Scribd Logo
Upload

Welcome to Scribd!

  • 222 views

    UTP A 3545 NB PDF

    Uploaded by

    N

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    UTP A 3545 NB PDF

    Uploaded by

    N
    222 views1 page

    Original Title

    UTP A 3545 Nb.pdf

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    222 views1 page

    UTP A 3545 NB PDF

    Uploaded by

    N

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    Standards : UTP A 3545 Nb

    EN ISO 14343-A : W/GZ 35 45 Nb


    Rods and wires for high temperature
    cast alloys with high carbon content in
    petrochemical industry

    Application field
    UTP A 3545 Nb is suitable for joining and surfacing on identical and similar high heat resistant cast alloys
    (centrifugal- and mould cast parts), such as G X-45NiCrNbSiTi 45 35.
    The main application field is for tubes and cast parts of reformer and pyrolysis ovens at temperatures up
    to 1175° C / air.

    Properties of the weld metal


    The weld deposit is applicable in a low sulphur, carbon enriching atmosphere up to 1175° C and has an
    excellent creep strength and a good resistance against carburization and oxidation.
    Mechanical properties of the weld metal
    Yield strength Tensile strength Elongation
    Rp0,2 Rm A
    MPa MPa %
    450 650 8

    Weld metal analysis in %


    C Si Mn Cr Ni Nb Ti Zr Fe
    0,45 1,5 0,8 35,0 45,0 1,0 0,1 0,05 balance
    Welding instructions
    Clean welding area carefully. No pre-heating or post weld heat treatment. Keep heat input as low as possi-
    ble and interpass temperature at max. 180° C.

    Welding procedure and availability

    Shielding gas Availability


    Ø
    Current type EN ISO 14175 Spools Rods
    (mm)
    I1 EN ISO 544 EN ISO 544
    1,2 DC (+) x x
    2,0 DC (-) x x
    2,4 DC (-) x x
    3,2 DC (-) x x

    All data on our products are based upon careful investigation and intensive © UTP Schweissmaterial
    research. However, we do not assume any liability for their correctness. Zweigniederlassung der Böhler Schweisstechnik Deutschland GmbH
    www.utp-welding.com Edition: 08/2010 Rev.: 1

    You might also like