International Journal on Recent and Innovation Trends in Computing and Communication ISSN: 2321-8169

Volume: 4 Issue: 1 78 - 80
__________________________________________________________________________________________________________________________________

Weather Monitoring System using Microcontroller

KarishmaPatil1,Mansi Mhatre2, Rashmi Govilkar3,Shraddha Rokade4, Prof.Gaurav Gawas5

Dept.of Electronics& Telecommunication Engineering. #
Shah & Anchor Kutchhi Polytechnic, Mumbai, India
[email protected],[email protected],[email protected]
,[email protected]

Abstract: The measurement of temperature and humidity remotely by using the sensor is not only important in weather monitoring but
also crucial for many other applications such as agriculture and industrial processes. A device for real time weather monitoring is
presented in this paper to monitor the temperature and relative humidity of the atmosphere via GSM network, using analog and digital
component. The sensor output will be given to the ADC. The microcontroller will read the ADC output and display the parameter value
on the LCD. An LCD display is also connected to the microcontroller to display the measurement. For analysis and achieving purposes,
the data can be transferred over GSM and receiver section that is mobile. The device has many advantages compared to other weather
monitoring system in terms of its smaller size, on-device display, low cost and portable.

_______________________________________________*****_______________________________________________

I. INTRODUCTION

Aim of our project is to monitor weather conditions

including atmospheric humidity & atmospheric
temperature with help of GSM modem. Local weather
measurements are extremely important to a wider range of
professions, from horticulturists to fire fighters. It provides
around the clock monitoring of various types of
applications. For example, it can be used in greenhouse to Figure1.Block diagram of weather monitoring system
manage climate control and help to promote favorable using microcontroller
growing conditions. On green roofs, it can help researchers
understand performance by tracking soil moisture and air Humidity Sensor: Humidity sensor works on the principle
temperature. This project is fine combination of analog and of relative humidity and gives the output in the form of
digital electronics. The project consists of parameters like voltage. This analog voltage provides the information
monitoring parameter sending through SMS. GSM about the percentage relative humidity present in the
interfacing is one of the main features of the project in environment.
which various data like value of parameters, date and time
are sent by the SMS. Temperature Sensor: The LM35 is an integrated circuit
sensor that can be used to measure temperature with an
We have used microcontroller as main component of our electrical output proportional to the temperature (in o C).
project. Now, Microcontroller has become a main
component of many electronic circuits. Also LCD and ADC: Mostly real world signals are Analog. Such signals
sensors are used for major basis of displaying and sensing are sensed through the sensors e.g. Temperature LM35.
purpose. This project consists of two basis modules like MCU/CPU processes only digital signals. ADC devices
Data monitoring module and Data sensing module. convert these analog signals into digital to be processed by
the MCU/CPU. ADC 0808, 0804, 0809etc.
The display unit shows the value of parameters. This will
help for the person to know the values, for this purpose we Microcontroller: microcontroller, as the name suggests,
are going to use various sensors like temperature and are small controllers i.e. called as single chip computer.
humidity sensor which will be connected to ADC. The This single chip computer is embedded into other systems
other module is named as parameter sending. It can be used to function as a processing/controlling unit.
to send the parameters value of remote location. We are
going to use GSM modem. These values can later be seen LCD: A liquid-crystal display is a flat panel, electronic
using a mobile SMS inbox. This system is useful because visual display that uses the light modulating properties of
many times it’s difficult to measure the parameter values liquid crystals. Liquid crystal does not emit light directly.
manually and also this module is more accurate than the
MAX232: Max232 is designed by Maxim Integrated
domestic system.
Products. Mostly MAX232 used is 16-pin DIP package. It
consist of 3 major blocks .It can only be powered by 5

78
IJRITCC | January 2016, Available @ http://www.ijritcc.org
____________________________________________________________________________________________________________________________
International Journal on Recent and Innovation Trends in Computing and Communication ISSN: 2321-8169
Volume: 4 Issue: 1 78 - 80
__________________________________________________________________________________________________________________________________
volts to make it power supply compatible with most of the 10. Detection of the Temperature conditions will help us
embedded systems. to avoid damages.

GSM MODEM: A GSM modem is one of the wireless Table 1:Comparative study of temperature & humidity
modem that is devised to work with a GSM with a GSM
wireless network.
Temperature Humidity
II. FLOWCHART

Season

Mor Mor
Aft Eve Aft Eve
n n

400 410 35 27
Summer 300C 27%
C C % %

Monsoo 320 260 48 64

280C 60%
n C C % %

290 260 42 49
Winter 220C 74%
C C % %

IV. DISADVANTAGES
1. If we want continuous monitoring of required
parameter then we have to keep pc on at receiver that
will increase the power consumption.
2. Limited Communication range.
3. Less Secured.
4. Low data rate.

V. APPLICATIONS
1. Industrial purpose.
2. Home automation
3. Agriculture field monitoring
4. Also this system communicates with a mobile and
sends various data like level of humidity and
III. ADVANTAGES temperature of water.
1. Reduces manpower
2. Wireless Sensor Systems
3. Accurate system VI. EXPERIMENTAL RESULTS
4. Faster Data transfer The environmental monitoring data sensors automatically
5. Automatic Indication monitor the temperature & humidity. It can realize the
6. Low cost. remote access of sensor monitoring data and download of
7. Less circuitry required because of software used. the environmental monitoring data to the client according
8. Time saving to requests. The simulation result is shown below the table.
9. Enhanced for monitoring & controlling of atmosphere
conditions.

79
IJRITCC | January 2016, Available @ http://www.ijritcc.org
____________________________________________________________________________________________________________________________
International Journal on Recent and Innovation Trends in Computing and Communication ISSN: 2321-8169
Volume: 4 Issue: 1 78 - 80
__________________________________________________________________________________________________________________________________
Electronic Nose for Environment Quality
Classification,” International Conference on
Electrical Engineering/Electronics Computer
Telecommunications and Information Technology,
pp. 540-543.

[8] W. Pimpao, T. Kerdcharoen, M. Sangworasil, A.

Jomphoak, and A. Tuantranont, “Design and
Development of Gas Sensor Array System for
Portable Electronic Nose,” International Conference
on Applied Science, 2006, pp. 515.
[9] P. Leilei and S. X. Yang, “An Electronic Nose
Figure 2.Circuit Photo Network System for Online Monitoring of
Livestock Farm Odors,” IEEE/ASME Transactions
VII. FUTURE SCOPE on Mechatronics, vol.14, no. 3, June 2009, pp. 371 -
1. Different other sensors as light intensity sensor, 376.
pressure sensor can also be interfaced with the
microcontroller to fetch various information about a
location.
2. Automatic irrigation control can also be implemented
using moisture sensor to fetch regarding water
presence in the farm and do turn on or off water pump
accordingly.

VIII. CONCLUSION
Our aim is to implement a simple and low cost weather
monitoring system using LM35, LCD and 89v51RD2
microcontroller unit to monitor weather conditions of the
desired location and transmit it to a cell phone at distant
location through SMS. This wireless monitoring system
implements real-time remote monitoring and management
of wind power generation by using the wind station
network (WSN). By using this we calculate the direction of
winds, current and voltage which will be transmitted
wirelessly to the base station.

REFERENCES

[1] SMS based Weather report information system.

[2] Keshavkumar Singh Design of wireless weather
monitoring system.
[3] P.Susmitha Dept. of ECM K L UNIVERSITY
Guntur (Dt), India, G.Sowmyabala Assistant
Professor Dept. of ECM K L University, India
Design and Implementation of Weather Monitoring
and Controlling System.
[4] ZigBee based weather monitoring system by Nisha
Gahlot, Varsha Gundkal, Sonali Kothimbire,
Archana Thite.
[5] Microcontroller based real time weather monitoring
device with GSM.
[6] X. Meng, “ICA Algorithm Based on Intelligent
Electronic Nose in the Mixed Gas of Feature
Extraction,” 6th International Conference on
Wireless Communications Networking and Mobile
Computing, 2010, pp. 1-4.
[7] N. Watthanawisuth, W. Pimpao, A. Wisitsoraat, S.
Mongpraneet, T. Lomas, M. Sangworasil, and
A.Tuantranont, “Development of Wireless

80
IJRITCC | January 2016, Available @ http://www.ijritcc.org
____________________________________________________________________________________________________________________________