Scribd
Upload
494 views1 page

CAN Troubleshooting Sheet v3

This document provides a quick reference guide for troubleshooting CAN bus issues. It includes diagrams of a CAN bus network and instructions for performing various voltage and resistance tests to identify common problems such as missing or faulty terminations, short circuits, open circuits, or issues with individual nodes. The guide directs the user to check specific resistance readings and voltage levels at different points in the network. It also provides contact information for an online academy that offers additional CAN bus troubleshooting resources and products.

Uploaded by

Velina Mileva
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
494 views1 page

CAN Troubleshooting Sheet v3

This document provides a quick reference guide for troubleshooting CAN bus issues. It includes diagrams of a CAN bus network and instructions for performing various voltage and resistance tests to identify common problems such as missing or faulty terminations, short circuits, open circuits, or issues with individual nodes. The guide directs the user to check specific resistance readings and voltage levels at different points in the network. It also provides contact information for an online academy that offers additional CAN bus troubleshooting resources and products.

Uploaded by

Velina Mileva
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CAN bus Troubleshooting - Quick Reference

Disclaimer: information furnished herein is


- - GND believed to be accurate and reliable, however,
Node 1 Node n Visit CANbusAcademy.com to
V2 V1 no responsibility is assumed for any errors. The
+ + obtain copies of this sheet and user assumes full responsibility for the
CAN HIGH learn about our CANbus accuracy and appropriateness of this
information. The recommendations and
120Ω 120Ω Ω1 =60Ω Academy’s products & services techniques presented have been used to solve
CAN LOW many CAN bus issues.

0Ω-5Ω
Bus Termination Test CANH & L Shorted?

y
Check Faulty Nodes
30Ω-50Ω Too Many Resistors?
Turn Off Power What is Ω1? Below 50Ω

em
110Ω-140Ω
Nominal: 60Ω Missing One resistor?

d
Typical 55Ω-65Ω

a
1kΩ-10kΩ

c
Above 70Ω Missing Two Resistors?

A
>MΩ
H or L open circuit?

Voltage Test

bus >8v Short to Batt Flipped H & L Wires?

N
V1, V2
No
Turn On Power DC Volt Test between 2v and Outside Range

A
Check wire continuity
4v?

C
Yes
OK Check Faulty Nodes
0Ω-100Ω
Node Transceiver Test Turn Off Fail Shorted
Node Ω2 Power
CAN HIGH What is Use identical working
CAN Ω2,Ω3,Ω4?
Transceiver CAN LOW Ω4 component as reference
Disconnect
Ω3 CAN >MΩ
Fail Open

Like this sheet? Let us Know:


All Rights Reserved. Copies of this sheet may only be
CANbusAcademy.com/good
obtained via www.CANbusAcademy.com. This sheet Version 3
shall not be copied and distributed by end-users. CANbusAcademy.com/bad

You might also like