Code No: R1621044 R16 SET - 1

II B. Tech I Semester Regular/Supplementary Examinations, October/November - 2019

NETWORK ANALYSIS
(Com to ECE, EIE and ECC)
Time: 3 hours Max. Marks: 70
Note: 1. Question Paper consists of two parts (Part-A and Part--B)
2. Answer ALL the question in Part-A
3. Answer any FOUR Questions from Part-B
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~

PART –A
1. a) A sine wave has a peak value of 12 V. Determine
Determine the RMS value, Average (3M)
value and form factor.
b) What is complex impedance? (2M)
c) Define Bandwidth. (2M)
d) The current through a branch in a linear network is 2 A when the input source (2M)
voltage is 10 V. If the voltage is reduced to 1 V and the polarity is reversed,
then determine the current through the branch.
e) Write the relationship between Y-parameters
Y and Z-parameters. (2M)
f) What is meant by transient response? (3M)
PART -B
2. a) For the circuit shown in figure, determine the voltage across each current (7M)
source.

b) Explain the following with an example: (7M)

(i) Tree and Co-Tree
Tree (ii) Twigs and Links

1 of 2

WWW.MANARESULTS.CO.IN
|''|'||||''|'''|'|'|
Code No: R1621044 R16 SET - 1

3. a) Determine the equivalent impedance of the network shown in Figure if the (7M)
operating frequency is 5 rad/s.

b) Find the current ix in the circuit shown below by using nodal analysis. (7M)

4. a) Explain the dot rule of coupled circuits. (7M)

b) Draw the parallel resonant circuit and derive the expression for resonant (7M)
frequency.

5. a) State and explain Norton’s theorem. (7M)

b) Find the value of RL for maximum power transfer in the circuit shown below. (7M)
Find the maximum power.

6. a) Explain about Z-parameters

parameters of a two port network. (7M)
b) Find the transmission parameters of the following two port network: (7M)

7. a) A parallel RLC circuit having an inductance of 10 mH and a capacitance of (7M)

100 µF.
F. Determine the resistor values that would lead to overdamped and
underdamped responses.
b) Discuss about modeling of inductors in ss-domain. (7M)
2 of 2
WWW.MANARESULTS.CO.IN
|''|'||||''|'''|'|'|
Code No: R1621044 R16 SET - 2

II B. Tech I Semester Regular/Supplementary Examinations, October/November - 2019

NETWORK ANALYSIS
(Com to ECE, EIE and ECC)
Time: 3 hours Max. Marks: 70
Note: 1. Question Paper consists of two parts (Part-A and Part--B)
2. Answer ALL the question in Part-A
3. Answer any FOUR Questions from Part-B
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~

PART –A
1. a) Define Form factor and Peak factor. (2M)
b) Define impedance. (2M)
c) Define Quality factor. (2M)
d) Write short notes on Tellegen’s theorem. (3M)
e) What is a two port network? Explain. (3M)
f) Write the differential equation for the parallel RLC circuit. (2M)
PART -B
2. a) Determine the power supplied by the dependent source shown in figure. (7M)

b) What is an incidence matrix? Write the properties of incidence matrix. (7M)

3. a) Explain about star to delta conversion. (7M)

b) Determine the time domain node voltages v1(t) and v2(t) shown in circuit: (7M)

1 of 2
WWW.MANARESULTS.CO.IN
|''|'||||''|'''|'|'|
Code No: R1621044 R16 SET - 2

4. a) What is coupling coefficient? Derive the expression for it. (7M)

b) A series connected circuit has R = 4 Ω and L = 25 mH. (7M)
(i) Calculate the value of C that will produce a quality factor of 50.
(ii) Find ω1 , ω2 and bandwidth.

5. a) What is maximum power transfer theorem? Explain it. (7M)

b) Find the Norton’s equivalent circuit for the following circuit. (7M)

6. a) Explain about Y-parameters of a two port network. (7M)

b) Find the hybrid parameters of the following two port network: (7M)

7. a) The switch in the following circuit has been closed for a long time. It is open at (7M)
t = 0. Find
(i) i(0+), v(0+) (ii) di(0+)/dt, dv(0+)/dt (iii) i( ∞ ), v( ∞ )

b) Discuss about modeling of capacitors in s-domain. (7M)

2 of 2

WWW.MANARESULTS.CO.IN
|''|'||||''|'''|'|'|
Code No: R1621044 R16 SET - 3

II B. Tech I Semester Regular/Supplementary Examinations, October/November - 2019

NETWORK ANALYSIS
(Com to ECE, EIE and ECC)
Time: 3 hours Max. Marks: 70
Note: 1. Question Paper consists of two parts (Part-A and Part--B)
2. Answer ALL the question in Part-A
3. Answer any FOUR Questions from Part-B
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~
PART –A
1. a) Define RMS value and Average value. (2M)
b) What is meant by steady state response? (3M)
c) A parallel resonant circuit is composed of the elements R = 8 kΩ.
k . L = 50 mH (2M)
and C = 80 nF. Compute ω0.
d) State reciprocity theorem. (2M)
e) What is meant by cascade connection? Explain. (3M)
f) Define time constant. (2M)
PART -B
2. a) Determine the currents i1 and i2 in the circuit shown below. (7M)

b) Explain about phasor representation and write the advantages of it. (7M)

3. a) Determine the input impedance of the following circuit. Assume ω = 10 rad/s. (7M)

b) Find v1 and v2 in the following circuit using nodal analysis. (7M)

WWW.MANARESULTS.CO.IN
1 of 2

|''|'||||''|'''|'|'|
Code No: R1621044 R16 SET - 3

4. a) Explain the concept of mutual inductance with necessary equations. (7M)

b) Derive the expression for resonant frequency of series resonant circuit. (7M)

5. a) Explain about superposition principle and write the advantages of it. (7M)
b) Prove that the maximum power transfer to the load when the load resistance (7M)
equals the Thevenin’s resistance as seen from the load.

6. a) Explain about h-parameters

parameters of a two port network. (7M)
b) Obtain Y- parameters of the following circuit. (7M)

7. a) Discuss about step response of an RL circuit. (7M)

b) Calculate the voltage v(t) shown in figure, given an initial current i(0-) = 1 A (7M)
using Laplace transform method.

2 of 2

WWW.MANARESULTS.CO.IN
|''|'||||''|'''|'|'|
Code No: R1621044 R16 SET - 4
II B. Tech I Semester Regular/Supplementary Examinations, October/November - 2019
NETWORK ANALYSIS
(Com to ECE, EIE and ECC)
Time: 3 hours Max. Marks: 70
Note: 1. Question Paper consists of two parts (Part-A and Part--B)
2. Answer ALL the question in Part-A
3. Answer any FOUR Questions from Part-B
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~
PART –A
1. a) Write short notes on source transformation. (2M)
b) The voltage v = cos (60t + 450) is applied to a 0.1 H inductor. Find the steady state (3M)
current through the inductor.
c) What is significance of coefficient of coupling? (2M)
d) A load is connected to a network. At the terminals to which the load is connected, (3M)
RTh = 10Ω and VTh = 40 V. Find the maximum power supplied to the load.
e) What is meant by reciprocal network? (2M)
f) What is overdamped response? (2M)
PART -B
2. a) Determine the currents i1 and i2 in the circuit shown below. (7M)

b) Explain the concept of principle of duality. (7M)

3. a) Find the input impedance of the circuit shown in figure. Assume that the circuit (7M)
operates at ω = 50 rad/s.

b) Determine the current I0 in the following circuit using mesh analysis. (7M)

WWW.MANARESULTS.CO.IN
1 of 2
|''|'||||''|'''|'|'|
Code No: R1621044 R16 SET - 4

4. a) Explain the concept of self inductance with necessary equations. (7M)

b) In the circuit shown below, R = 2 Ω, L = 1 mH and C = 0.4 µF. (7M)
(i) Find the resonant frequency and the half-power
half frequencies.
(ii) Calculate the quality factor and bandwidth.

5. a) State and explain thevenin’s theorem. (7M)

b) State superposition theorem and find v0 in the following circuit using it. (7M)

6. a) Explain about transmission line parameters of a two port network. (7M)

b) Determine the Z- parameters of the following circuit. (7M)

7. a) Discuss about step response of an RC circuit. (7M)

b) Determine the voltage vc(t) shown in figure, given an initial voltage (7M)
vc(0-) = -22 V using Laplace transform method.

2 of 2

WWW.MANARESULTS.CO.IN
|''|'||||''|'''|'|'|