Scribd
Upload
42 views1 page

Charging of Nitrogen Gas Into Accumulator

The document provides instructions for charging nitrogen gas into an accumulator. It describes connecting a nitrogen gas cylinder to the accumulator via a charging hose and 3-way valve assembly. It also includes a conversion table to determine the appropriate gas pressure to charge the accumulator based on ambient temperature. Finally, it lists steps for safely discharging any remaining gas and disconnecting the assembly.

Uploaded by

Coni Fuenzalida Varela
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
42 views1 page

Charging of Nitrogen Gas Into Accumulator

The document provides instructions for charging nitrogen gas into an accumulator. It describes connecting a nitrogen gas cylinder to the accumulator via a charging hose and 3-way valve assembly. It also includes a conversion table to determine the appropriate gas pressure to charge the accumulator based on ambient temperature. Finally, it lists steps for safely discharging any remaining gas and disconnecting the assembly.

Uploaded by

Coni Fuenzalida Varela
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Charging of Nitrogen Gas into Accumulator

• Connect the charging hose to N2 gas cylinder after


screwing the valve adapter on to adapter, nut and installing
to the N2 gas cylinder.
• Connect the 3-way valve assembly to the charging hose
after unscrewing the cap on the 3-way valve assembly.
• Remove the cap from the accumulator and tighten the
charging valve fully.
• Check if O-rings are installed to the bushing. Remove the
plug and screw the bushing.
• Loosen the accumulator charging valve after checking if
bushing is installed to the 3-way valve assembly.
• Turn the handle of the N2 gas cylinder counter clockwise
slowly to charge the gas.
• Charge the gas in accordance with the conversion table for
charging N2 gas pressure to accumulator.
• Turn the handle of the N2 gas cylinder clockwise to close
the cock.
• Close the accumulator charging valve.
• Loosen the valve of the 3-way valve assembly to discharge
the N2 gas remaining in the charging hose.
• Remove the charging hose, 3-way valve assembly and
bushing and tighten the plug and cap.

Conversion Table for Charging Nitrogen Gas Pressure to Accumulator.


Ambient Temperature (°C /°F)
Accumulator Gas Pressure
0 / 32 10 / 32 20 / 68 30 / 86 40 / 104
kg/cm2 52 55 58 60 62
psi 739 782 825 853 882

Accumulator Sticker (A) Symbol


• Appears on the accumulator body.

CAUTION
PRESSURIZED CONTAINER!
DISCHARGE PRIOR TO DISASSEMBLY. DO NOT OPEN
WITHOUT READING THE OPERATION MANUAL OR
CONSULTING THE AUTHORIZED SERVICE PERSONNEL!

Figure 10

Preparation for Installation and Operation HB20/HB30/HB40


6-8

You might also like