UNI SONI C TECHNOLOGI ES CO.

, LTD

LM324 LINEAR INTEGRATED CIRCUIT

QU AD OPERAT I ON AL
AM PLI FI ERS

 DESCRI PT I ON
The UTC LM324 consists of four independent, high gain
internally frequency compensated operational amplifiers which are
designed specifically to operated from a single power supply over a
wide voltage range. Operation from split power supplies is also
possible. Application areas include transducer amplifier, DC gain
blocks and all the conventional OP amp circuits which now can be
easily implemented in single power supply system.
 FEAT U RES
*Internally frequency compensated for unity gain.
*Large DC voltage gain :100dB.
*Wide operating supply range (VCC=3V~40V).
*Input common-mode voltage includes ground.
*Large output voltage swing: From 0V to Vcc-1.5V.
*Power drain suitable for battery operation.
 ORDERI N G I N FORM AT I ON
Ordering Number
Package Packing
Lead Free Halogen-Free
LM324L-D14-T LM324G-D14-T DIP-14 Tube
LM324L-S14-R LM324G-S14-R SOP-14 Tape Reel
LM324L-P14-R LM324G-P14-R TSSOP-14 Tape Reel

 M ARK I N G
DIP-14 SOP-14 / TSSOP-14

www.unisonic.com.tw 1 of 5
QW-R105-006.N
Copyright © 2017 Unisonic Technologies Co., Ltd
LM324 LINEAR INTEGRATED CIRCUIT
 PI N DESCRI PT I ON

OUT 1 1 14 OUT 4

IN 1(-) 2 13 IN 4(-)

IN 1(+) 3 12 IN 4(+)

Vcc 4 11 GND

IN 2(+) 5 10 IN 3(+)

IN 2(-) 6 9 IN 3(-)

OUT 2 7 8 OUT 3

 BLOCK DI AGRAM

Only one section

Vcc

IN (-)
Output
IN (+)

GND

UNISONIC TECHNOLOGIES CO., LTD 2 of 5

QW-R105-006.N
www.unisonic.com.tw
LM324 LINEAR INTEGRATED CIRCUIT
 ABSOLU T E M AX I M U M RAT I N GS
PARAMETER SYMBOL RATINGS UNIT
Supply Voltage VCC ±20 V
Differential Input Voltage VI(DIFF) ±40 V
Input Voltage VIN -0.3 ~ +40 V
DIP-14 800 mW
Power Dissipation SOP-14 PD 580 mW
TSSOP-14 460 mW
Operating Temperature TOPR -20 ~ +85 C
Storage Temperature TSTG -40 ~ +150 C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
 ELECT RI CAL CH ARACT ERI ST I CS

(VCC=5.0V, All voltage referenced to GND unless otherwise specified.)

PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNIT
VCM=0V toVCC-1.5V
Input Offset Voltage VI(OFF) 5.0 mV
VO(P)=1.4V, RS=0
Input Offset Current II(OFF) 50 nA
Input Bias Current II(BIAS) 250 nA
Input Common Mode Voltage VI(CM) VCC=30V 0 VCC-1.5 V
RL=∞, VCC=30V 1.0 3.0 mA
Power Supply Current ICC
VCC=5V 0.7 1.2 mA
VCC=15V, RL≧2K
Large Signal Voltage Gain GV 25 100 V/mV
VO(P)=1V ~ 11V
VCC=30V, RL=2K 26 V
VO(H)
Output Voltage Swing VCC=30V, RL=10K 27 28 V
VO(L) VCC=5V, RL>10K 5 20 mV
Common Mode Rejection Ratio CMRR 65 75 dB
Power Supply Rejection Ratio PSRR 65 100 dB
Channel Separation CS f=1KHZ ~ 20KHZ 120 dB
Short Circuit Current to Ground ISC 40 60 mA
VI(+)=1V, VI(-)=0V
ISOURCE 20 40 mA
VCC=15V, VO(P)=2V
VI(+)=0V, VI(-)=1V
Output Current ISINK 10 13 mA
VCC=15V, VO(P)=2V
VI(+)=0V, VI(-)=1V
12 45 μA
VCC=15V, VO(P)=200mV
Differential Input Voltage VI(DIFF) VCC V

UNISONIC TECHNOLOGIES CO., LTD 3 of 5

QW-R105-006.N
www.unisonic.com.tw
LM324 LINEAR INTEGRATED CIRCUIT
 T Y PI CAL CH ARACT ERI ST I CS

Input Voltage Range Input Current

15 100

80
Negative
Input Voltgae,VIN (±V)

10

Input Current (nA)

VCC=+30V
60

Positive VCC=+15V
40
5
VCC=+5V
20

0 0
0 5 10 15 -50 -25 0 25 50 75 100
Supply Voltage (± V) Temperature (°C)

Supply Current Voltage Gain

40 160
VCC

IC
RL=20kΩ
3 120
Supply Current (mA)

Voltgae Gain (dB)

RL=2kΩ

2 80
TA=0~+85°C

1 40

TA=-40°C
0 0
0 10 20 30 40 0 7.5 15 22.5 30

Supply Voltage (V) Supply Voltage (V)

Open Loop Frequency response Common-Mode Rejection Ratio

120 120

VCC
100 100MΩ 100
0.1µF
VCC=+7.5V
Voltage Gain (dB)

80 80 VEE=-7.5V
VIN
CMRR (dB)

VCC/2

+7.5V
60 60
100kΩ

100Ω

40
VCC=30V
40 100Ω

VCC=15V VIN

20 100kΩ -7.5V
20

0
0
0 1 2 3 4 5 6 7 2 3 4 5 6
10 10 10 10 10 10 10 10 10 10 10 10 10

Frequency (Hz) Frequency (Hz)

UNISONIC TECHNOLOGIES CO., LTD 4 of 5

QW-R105-006.N
www.unisonic.com.tw
LM324 LINEAR INTEGRATED CIRCUIT
 T Y PI CAL CH ARACT ERI ST I CS(c ont .)
Input Voltage (V)

Output voltgae (mV)

Output Voltage (V)

Output Refference VCC (V)

Output Swing (VP-P)

UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.

UNISONIC TECHNOLOGIES CO., LTD 5 of 5

QW-R105-006.N
www.unisonic.com.tw