ENetwork Chapter 7 - CCNA Exploration Network Fundamentals (Version 4.0)

Assessment System
Skip to Time Left | Skip to Navigation | Skip to Assessment Items
Take Assessment - ENetwork Chapter 7 - CCNA Exploration: Network Fundam

(Version 4.0)
Time Remaining:
Showing 1 of 2 Next> Page: GO <Prev

1 What is true concerning physical and logical topologies?
The logical topology is always the same as the physical topology.
Physical topologies are concerned with how a network transfers frames.
Physical signal paths are defined by Data Link layer protocols.
Logical topologies consist of virtual connections between nodes.
Refer to the exhibit. Which statement describes the media access control methods that are
the networks in the exhibit?
All three networks use CSMA/CA
e of the networks require media access control.

Network 1 uses CSMA/CD and Network 3 uses CSMA/CA.
Network 1 uses CSMA/CA and Network 2 uses CSMA/CD.
Network 2 uses CSMA/CA and Network 3 uses CSMA/CD.
3 Which three factors should be considered when implementing a Layer 2 protocol in a netw
(Choose three.)
the Layer 3 protocol selected
the geographic scope of the network
the PDU defined by the transport layer
the physical layer implementation
the number of hosts to be interconnected
4What is a primary purpose of encapsulating packets into frames?

provide routes across the internetwork
format the data for presentation to the user
facilitate the entry and exit of data on media
identify the services to which transported data is associated
5 What are three characteristics of valid Ethernet Layer 2 addresses? (Choose three.)
They are 48 binary bits in length.
They are considered physical addresses.
They are generally represented in hexadecimal format.
They consist of four eight-bit octets of binary numbers.
They are used to determine the data path through the network.
They must be changed when an Ethernet device is added or moved within the network
Refer to the exhibit. Assuming that the network in the exhibit is converged meaning the rou
and ARP tables are complete, which MAC address will Host A place in the destination add
Ethernet frames destined for www.server?
00-1c-41-ab-c0-00
00-0c-85-cf-65-c0
00-0c-85-cf-65-c1
00-12-3f-32-05-af
7 What is a function of the data link layer?

provides the formatting of data
provides end-to-end delivery of data between hosts
provides delivery of data between two applications
provides for the exchange data over a common local media
8Which options are properties of contention-based media access for a shared media? (Choo
non-deterministic
less overhead
one station transmits at a time
collisions exist
devices must wait their turn
token passing
9 What two facts are true when a device is moved from one network or subnet to another?
two.)
The Layer 2 address must be reassigned.
The default gateway address should not be changed.
The device will still operate at the same Layer 2 address.
Applications and services will need additional port numbers assigned.
The Layer 3 address must be reassigned to allow communications to the new network
1 What is true regarding media access control? (Choose three.)

0 Ethernet utilizes CSMA/CD
defined as placement of data frames on the media
contention-based access is also known as deterministic
802.11 utilizes CSMA/CD
Data Link layer protocols define the rules for access to different media
controlled access contains data collisions
11 Which statements describe the logical token-passing topology? (Choose two.)

Network usage is on a first come, first serve basis.
Computers are allowed to transmit data only when they possess a token.
Data from a host is received by all other hosts.
Electronic tokens are passed sequentially to each other.
Token passing networks have problems with high collision rates.
1 What statements are true regarding addresses found at each layer of the OSI model? (Ch
2 Layer 2 may identify devices by a physical address burned into the network card
Layer 2 identifies the applications that are communicating
Layer 3 represents a hierarchical addressing scheme
Layer 4 directs communication to the proper destination network
Layer 4 addresses are used by intermediary devices to forward data
13 Which sublayer of the data link layer prepares a signal to be transmitted at the physical la
LLC
MAC
HDLC
NIC
1 What is the primary purpose of the trailer in a data link layer frame?
4 define the logical topology
provide media access control
support frame error detection
carry routing information for the frame
15 A network administrator has been asked to provide a graphic representation of exactly whe
company network wiring and equipment are located in the building. What is this type of draw
logical topology
physical topology
cable path
wiring grid
access topology
All contents copyright 1992-2010 Cisco Systems, Inc. Privacy Statement and Trademarks
Assessment System
Skip to Time Left | Skip to Navigation | Skip to Assessment Items
Take Assessment - ENetwork Chapter 7 - CCNA Exploration: Network Fundam

(Version 4.0)
Time Remaining:

16
Refer to the exhibit. How many CRC calculations will take place as traffic routes from the
laptop?
1
2
4
6
8
16
1 What determines the method of media access control? (Choose two.)

7 network layer addressing
media sharing
application processes
logical topology
intermediary device function
18 What is the purpose of the preamble in an Ethernet frame?

is used as a padding for data
is used for timing synchronization
is used to identify the source address
is used to identify the destination address
1
9
Refer to the exhibit. A frame is being sent from the PC to the laptop. Which source MAC a
addresses will be included in the frame as it leaves RouterB? (Choose two.)
source MAC - PC
source MAC - S0/0 on RouterA
source MAC - Fa0/1 on RouterB
source IP - PC
source IP - S0/0 on RouterA
source IP - Fa0/1 of RouterB
20 What is a characteristic of a logical point-to-point topology?

The nodes are physically connected.
The physical arrangement of the nodes is restricted.
The media access control protocol can be very simple.
The data link layer protocol used over the link requires a large frame header.
All contents copyright 1992-2010 Cisco Systems, Inc. Privacy Statement and Trademarks

ENetwork Chapter 7 - CCNA Exploration Network Fundamentals (Version 4.0)

Uploaded by

Copyright:

Available Formats

ENetwork Chapter 7 - CCNA Exploration Network Fundamentals (Version 4.0)

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

ENetwork Chapter 7 - CCNA Exploration Network Fundamentals (Version 4.0)

Uploaded by

Copyright:

Available Formats

Assessment System

Skip to Time Left | Skip to Navigation | Skip to Assessment Items

Take Assessment - ENetwork Chapter 7 - CCNA Exploration: Network Fundam

Showing 1 of 2 Next> Page: GO <Prev

e of the networks require media access control.

4What is a primary purpose of encapsulating packets into frames?

7 What is a function of the data link layer?

1 What is true regarding media access control? (Choose three.)

11 Which statements describe the logical token-passing topology? (Choose two.)

Showing 1 of 2 Next> Page: GO <Prev

Take Assessment - ENetwork Chapter 7 - CCNA Exploration: Network Fundam

Showing 2 of 2 Next> Page: GO <Prev

1 What determines the method of media access control? (Choose two.)

18 What is the purpose of the preamble in an Ethernet frame?

20 What is a characteristic of a logical point-to-point topology?

Showing 2 of 2 Next> Page: GO <Prev

You might also like