Wastewater Treatment Facilities

Magbanlag, Loury Joy N.
J15-50233
“WASTEWATER TREATMENT FACILITIES”
One of the most pollution control is most country is wastewater treatment. Every country has a
vast system of collection sewers, pumping stations and treatment plants. Sewers collect the
wastewater from homes businesses and many industries and deliver it to plants to treat.
Treatment plants are mostly built to clean wastewater for discharge into streams or other
receiving waters or for reuse.
Years ago, a natural process of purification began when sewage was dumped into waterways.
First, the sheer volume of clean water in the stream diluted waste. Bacteria and other small
organisms in water consumed the sewage and other organic matter making it into new bacterial
cells. In today’s higher and increasing populations and greater volume of domestic and industrial
wastewater require that communities give nature a helping hand. The basic of the wastewater
treatment is to fasten the natural processes by which water is purified. There are two basic stages
in treating wastewater, the primary and secondary where in primary stage allowed the solid to
settle and removed from wastewater while the secondary stage uses biological to further purify
wastewater. Sometimes, these stages are combined into one operation.
Primary Treatment
When sewage enters a plant for treatment, it flows through a screen to removes large floating
objects such as rags and sticks that may cause pipe to clog and damage equipment. After the
sewage has been screened, it passed into a grit chamber, where cinders, sand, and small stones
settle to the bottom. Grit chamber is important particularly in communities with combined sewer
systems where sand or gravel may wash into sewers along with storm water. After screening is
completed and grit has been removed, sewage still contains organic and inorganic matter along
with other suspended solids. These solids are minute particles that can be removed from sewage
in a sedimentation tank. When the speed of the flow through one of these tanks is reduced,
suspended solids will sink to the bottom where they form a mass of solids called primary bio
solids or formerly called as sludge. Bio solids are usually eliminated from tanks by pumping,
after which it may further treated to use as a fertilizers or disposed of in land fill or incinerated.
Over the past years, primary treatment alone has been unable to meet many communities’
demands for higher water quality. To meet them, cities and industries normally treat to a
secondary treatment level, and in some cases, also use advanced treatment to remove nutrients
and other contaminants.
Secondary Treatment
The secondary stage of wastewater treatments removes 85% of the organic matter found in
sewage by making used of the bacteria in it. Principal secondary treatment techniques used in
secondary treatment are the trickling filter and the activated sludge process. When effluent leaves
the sedimentation tank in the primary stage it flows or is pumped to a facility using one or the
other of these processes. A trickling filter is simply bed of stones from three to six feet deep
through which sewage passes.
The secondary stage of treatment removes about 85 percent of the organic matter in sewage by
making use of the bacteria in it. The principal secondary treatment techniques used in secondary
treatment are the trickling filter and the activated sludge process. After effluent leaves the
sedimentation tank in the primary stage it flows or is pumped to a facility using one or the other
of these processes. A trickling filter is simply a bed of stones from three to six feet deep through
which sewage passes.
`
Recently, the interlocking pieces of corrugated plastic have also used in trickling beds. On these
stones, bacteria gather and multiply until they can consume of the organic matter. The cleaner
water trickles out through pipes for further treatment. From a trickling filter, the partial of treated
sewage flows to another sedimentation tank for the removing of excess bacteria.
Today’s trend is toward the used of the activated sludge process instead of trickling filters.
Bringing air and sludge heavily laden with bacteria into close contact with sewage, activated
sludge process speeds up the work of bacteria. When the sewage leaves the settling tank in the
primary stage, it is pumped into an aeration tank, where it is mixed with air and sludge loaded
with bacteria and allowed to remain for several hours. During this time, bacteria break the
organic matter into harmless by-products.
The sludge, with additional billions of bacteria and other small organisms is now activated and
can be used again by returning it to the aeration tank for mixing with air and new sewage. From
aeration tank, the partial of the treated sewage flows to another sedimentation tank to remove
excess bacteria.
To complete secondary treatment, effluent from the sedimentation tank should undergo
disinfection with the use of chlorine before it discharged into receiving waters. The purpose of
using chlorine is kill pathogenic bacteria and reduce odor. When properly done, chlorination will
kill more than the 99% of harmful bacteria in an effluent. In some municipalities today,
manufacture chlorine solution on site to avoid transporting and storing large amounts of chlorine,
sometimes in a gaseous form. Many stages now require removal of excess chlorine before
discharge to surface waters by a process called dechlorination. Chlorine disinfection alternatives
such as ultraviolet light or ozone are also being used in situations where chlorine in treated
sewage effluents can harm fish and other aquatic life.
Other Treatment Options

New problems in pollution have placed addition burdens on wastewater treatment systems.
Pollutants today such as metals, chemical compounds and other toxic substances are difficult to
remove from water. Rising demand on the supply of water only aggravate the problem. The
demand to reuse water calls for better wastewater treatment. These challenges are being met
through better methods of removing pollutants at treatment plants or through prevention of
pollution at the source. Pretreatment of waste from industrial, for example, removes lots of
troublesome pollutants at the beginning, not the end of the pipeline.
To return adequate usable water to receiving lakes and streams, new methods to remove
pollutants are being developed. The advanced waste treatment techniques in use or under the
development range from biological treatment capable of removing nitrogen and phosphorous to
physical-chemical separation techniques such as filtration, carbon absorption, distillation and
reverse osmosis. These wastewater treatment processes, alone or in combination can achieve the
desire of almost any degree of pollution. Waste effluents purified by such treatment can be used
for industrial, agricultural or recreational purposes or even drinking water supplies.
Conclusion
It used to be said that “the solution to pollution is dilution.” When small amounts of sewage are
discharged into a flowing body of water, a natural process of stream self-purification occurs.
Densely populated communities generate such large quantities of sewage; however, that dilution
alone does not prevent pollution. This makes it necessary to treat or purify wastewater to some
degree before disposal. With the present of wastewater treatment facilities waste water can be
reuse for other purposes and prevent the water bodies from contamination that affects aquatic
lives.

Wastewater Treatment Facilities

Uploaded by

Copyright:

Available Formats

Wastewater Treatment Facilities

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Wastewater Treatment Facilities

Uploaded by

Copyright:

Available Formats

Magbanlag, Loury Joy N.

“WASTEWATER TREATMENT FACILITIES”

Other Treatment Options

You might also like