PAG 10.2 - Observing Forced and Damped Oscillations

OCR A Physics A-Level
PAG 10.2
Observing forced and damped oscillations
www.pmt.education
Damped Oscillations
Equipment
● Clamp stand
● Two 15 cm rulers
● Spring
● 100 g masses
● 500 g mass holder
● 400 g mass holder
● Stopwatch
● Fiducial marker (e.g pin and blu-tack)
● Damping card (circular cards with a hole in the centre which is smaller than a 100 g mass
but larger than the stem of the mass holder so it can be wedged between two masses to
hold it in place)
● Rubber bands
Method
1. Attach the spring to the clamp stand and attach the 500 g mass holder to the spring as
shown in the diagram below.
2. Wait until the spring stops moving completely, then place the fiducial marker at the very
bottom of the mass holder. This represents the centre of oscillations and will make it easier
to count how many oscillations the mass-spring system has undergone.
3. Attach the 15 cm ruler, either side of the fiducial marker, using rubber bands. These will be
used to measure the amplitude of the oscillations.
4. Pull the spring down slightly and let it go so that it is oscillating with a small amplitude and
in a straight line.
5. As the bottom of the mass holder passes the fiducial marker, start the stopwatch and count
the time taken for it to complete 10 full oscillations.
6. Once again, pull down the spring and let it go, allowing it to oscillate with a small amplitude
and in a straight line. Remember to record the amplitude that the spring is pulled to, as this
will be the maximum amplitude at the start of the first oscillation.
www.pmt.education
7. Measure the maximum amplitude of the spring at the start of every oscillation for at least 10
oscillations.
8. Repeat the above two steps twice and calculate the mean values of maximum amplitude at
each oscillation.
9. Repeat the above procedure but this time using the 400 g mass holder and the damping
card wedged between the mass holder and a 100 g mass.
Calculations
● Divide the collected values of time period by 10 to get the time period for a single oscillation
(T).
● Calculate the frequency of the oscillations by using the equation below, when the damping
card is present and when it is not.
1
f= T
● Plot a graph of the maximum amplitude against the number of oscillations for both systems
and draw a line of best fit, which in this instance is an exponential decay curve.
Safety
● Be careful when handling the masses. Dropping them may cause injury.
● If the clamp stand is unstable, a counterweight placed on the base of the clamp stand can
be used to prevent it from falling over.
● Wear eye protection when using springs.
Notes
● You will notice that the frequency of the system with the damping card will be less than the
system not using the damping card, even though the mass and spring constant is kept
constant. This is because the system experiences more damping and so will move slightly
slower.
● When comparing your graphs you will see that the maximum amplitude decreases
exponentially in both systems, however the amplitude will decay much faster in the damped
system as the degree of damping is greater.
● A large mass is attached to the spring so that the time period of oscillations is longer,
meaning the maximum amplitude of each oscillation is easier to measure.
● To reduce uncertainty and to more accurately measure the maximum amplitude, you can
record the oscillations of both systems using a position sensor connected to a computer.
www.pmt.education
Forced oscillations
Equipment
● Computer
● Position sensor
● Clamp stand
● Spring
● Mass holder
● Signal generator
● Vibration generator
● Metre ruler
Method
1. Set up the equipment as in the diagram.
2. Turn on the signal generator and set it to a frequency much lower than the natural
frequency of the spring if it is known - if not set it to 10 Hz. (The natural frequency of the
spring can be calculated by letting the spring oscillate freely and calculating the frequency
of its oscillations.)
3. Wait until the spring stops moving completely, then measure the distance of the bottom of
the mass holder above the sensor using either the position sensor or a metre ruler.
4. Using the position sensor connected to a computer with data-logging software, record the
maximum amplitude of the oscillations above its equilibrium position.
5. Increase the frequency of the signal generator by 10 Hz, and repeat the above step.
6. Repeat the last step until the frequency of the signal generator is far above the natural
frequency of the spring if known, if not, aim for 10 readings.
www.pmt.education
Calculations
● Plot a graph of maximum amplitude against frequency. You should get a graph similar to
the following:
● As the driving frequency is equal to the natural frequency of the spring when it is
experiencing resonance, you can calculate the natural frequency of the spring using your
graph. You can do this by finding the frequency at which the maximum amplitude of
oscillations reaches its peak value.
Safety
● Be careful when handling the mass holder. If dropped it may cause injury.
● If the clamp stand is unstable, a counterweight placed on the base of the clamp stand can
be used to prevent it from falling over.
Notes
● You will be able to see from your graph that the maximum amplitude of oscillations
increases greatly as the frequency of the driving force, which in this case is the vibration
generator, comes closer to the natural frequency. This is because resonance occurs when
the frequency of the driving force is equal to the natural frequency of the spring.
www.pmt.education

PAG 10.2 - Observing Forced and Damped Oscillations

Uploaded by

Copyright:

Available Formats

PAG 10.2 - Observing Forced and Damped Oscillations

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

PAG 10.2 - Observing Forced and Damped Oscillations

Uploaded by

Copyright:

Available Formats

OCR A Physics A-Level

You might also like