APE4518R14v

 A PE4518R14v06
06
DXXXXX-690-960/690-960/1427-2200/1695-2690/1695-2690-65/65/65/65/65-
16i/16i/17.5i/18i/18i-M/M/M/M/M-R
EasyRET
EasyRET 2L3H 10-
10-Port
Port A ntenna w ith 5 Integrated RCUs - 2.0m

 An t enna
enn a Spec if ic ati on s
Electrical Properties
2 x (690 - 960) 1427 - 2200
Frequency range (MHz)
690 - 803 790 - 862 824 - 894 880 - 960 1427 - 1518 1695 - 1990 1920 - 2200
Polarization +45° , -45° +45° , -45°
Electrical downtilt ( °) 0 - 10 , continuously adjustable , each band separately 2 - 12 , continuously adjustable
at mid Tilt 14.8 15.4 15.7 16.0 16.0 17.3 17.4
Gain (dBi)
over all Tilts 14.7 ±0.4 15.3 ±0.4 15.5 ±0.3 15.8 ±0.4 15.8 ±0.6 17.2 ±0.4 17.3 ±0.5
Side lobe suppression for first side
> 17 > 17 > 17 > 17 > 15 > 16 > 16
lobe above main beam (dB)
Horizontal 3dB beam width ( °) 70 ±5 69 ±4 68 ±3 64 ±4 63 ±7 64 ±7 65 ±6

Vertical 3dB beam width ( °) 11.0 ±0.8 9.8 ±0.5 9.5 ±0.5 8.8 ±0.5 7.9 ±0.3 6.3 ±0.5 5.8 ±0.4
VSWR < 1.5 < 1.5
Cross polar isolation (dB) ≥ 28 ≥ 28

Interband isolation (dB) ≥ 28 ≥ 28

Front to back ratio , ±30° (dB) > 24 > 25 > 25 > 25 > 25 > 27 > 27
Cross polar ratio (dB) 0° > 20 > 20 > 20 > 21 > 16 > 18 > 18

Max. power per input (W) 500 (at 50 ℃ ambient temperature)*

temperature) * 300 (at 50 ℃ ambient temperature)*
temperature) *
Intermodulation IM3 (dBc) ≤ -153 (2 x 43
43 dBm carrier) ≤ -153 (2 x 43
43 dBm carrier)
Impedance (Ω) 50
Grounding DC Ground

Electrical Properties
2 x (1695 - 2690)
Frequency range (MHz)
1695 - 1990 1920 - 2200 2200 - 2490 2490 - 2690
Polarization +45° , -45°
Electrical downtilt ( °) 2 - 12 , continuously adjustable , each band separately
at mid Tilt 17.0 17.5 17.6 18.0
Gain (dBi)
over all Tilts 16.9 ±0.6 17.4 ±0.5 17.5 ±0.5 17.9 ±0.5
Side lobe suppression for first side
> 18 > 19 > 19 > 18
lobe above main beam (dB)
Horizontal 3dB beam width ( °) 63 ±6 61 ±6 60 ±6 60 ±6
Vertical 3dB beam width ( °) 7.4 ±0.7 6.6 ±0.6 5.8 ±0.3 5.3 ±0.3
VSWR < 1.5
Cross polar isolation (dB) ≥ 28
Interband isolation (dB) ≥ 28
Front to back ratio , ±30° (dB) > 25 > 27 > 27 > 27
Cross polar ratio (dB) 0° > 18 > 18 > 17 > 18
Max. power per input (W) 250 (at 50 ℃ ambient temperature)*
temperature) *
Intermodulation IM3 (dBc) ≤ -153 (2 x 43 dBm carrier)
Impedance (Ω) 50
Grounding DC Ground

power : 1000 W (at 50 ℃ ambient temperature)

* Total power

1. Values based on NGMN recommendations on Base Station Antenna Standards (BASTA).

2. Electrical datasheet in XML format is available.

1
 APE4518R14v06
DXXXXX-690-960/690-960/1427-2200/1695-2690/1695-2690-65/65/65/65/65-
16i/16i/17.5i/18i/18i-M/M/M/M/M-R
EasyRET 2L3H 10-Port A ntenna w ith 5 Integrated RCUs - 2.0m

Mechanical Properties
 Antenna dimensions (H x W x D) (mm) 1999 x 469 x 206 144

Packing dimensions (H x W x D) (mm) 2255 x 535 x 285

 Antenna weight (kg) 38.9

Clamps weight (kg) 5.8 (2 units)

 Antenna packing weight (kg) 60.0 (Included clamps)

Mast diameter supported (mm) 50 - 115

Radome material Fiberglass

Radome colour Light grey

   0    9
   2    9
Operational temperature ( ℃) -40 .. +65    4    9
   1    1

Frontal: 955 (at 150 km/h)

Wind load (N) Lateral: 270 (at 150 km/h)
Rear side: 910 (at 150 km/h)

Max. operational wind speed (km/h) 200

Survival wind speed (km/h) 250

Connector 10 x 4.3-10 Female

Connector position Bottom

 Ac cessories

Item Model Descriptio n Weight Units per antenna

Downtilt kit ASMDT0F01 Mechanical downtilt: 0 - 12 ° 3.1 kg 1 (Separate packing)

Pattern sample for reference

690 - 960 MHz 1427 - 2200 MHz 1695 - 2690 MHz

2
  APE4518R14v06
DXXXXX-690-960/690-960/1427-2200/1695-2690/1695-2690-65/65/65/65/65-
16i/16i/17.5i/18i/18i-M/M/M/M/M-R
EasyRET 2L3H 10-Port A ntenna w ith 5 Integrated RCUs - 2.0m

Integrated RET Specif icatio ns

Properties
RET type Integrated RET
RET protocols* AISG 2.0 / 3GPP
Input voltage range (V) 10 - 30 DC
< 6 (motor activated, 12V)
Power consumption (W)
< 1.5 (stand by, 12V)
 Adjustment time (full range) (s) < 65 (typically, depending on antenna type)
4 x 8 pin connector according to IEC 60130-9
RET connector
Daisy chain in: Male / Daisy chain out: Female
1 2 3 4 5 6 7 8
Pin assignment according AISG
DC n/c RS-485B n/c RS-485A DC DC return n/c
3 (10/350 μs)
Lightning protection (kA)
10 (8/20 μs)

* Please confirm the AISG protocol of primary station is compatible with RET antenna protocol interface. The protocol of RET antenna software
interface is switchable between AISG 2.0/3GPP and AISG 1.1 with a vendor defined command. For more details about protocol switching function,
contact Huawei before system installation.

Standards: UL 60950-1 (Safety), UL 60950-22 (Safety – Equipment installed outdoor), EN 55032 (Emission),
EN 55024 (Immunity), ETSI EN 301 489, FCC Part15, ICES-003
Certification: CE, FCC, IC, RCM

Integrated RET S/N:

HWMxxx……Lr 1

HWMxxx……Ly1
Ly1 b1 Ry2
HWMxxx…….b 1

HWMxxx……Ry2

HWMxxx……Rr 2
Lr1 Rr2
r - Red y - Yellow
b - Blue
L - Left array R - Right array

NOTE

1. Facilities, such as towers and poles, must bear the weight and wind load of antennas.
2. HUAWEI ‘s standard brackets and accessories must be used for any installation.
3. The antenna working environment must meet the requirements specified in the datasheet.
4. Only qualified personnel are allowed to perform installation. Installation tools and procedures must conform to
requirements described in the antenna installation guide.

Huawei Technolo gies Co., Ltd. Banti an, Long gang Distri ct, Shenzhen 518129, P.R.China www .huawei.com/antenna
 Any previous datasheet issues become i nvalid. 3 Issue: 2017-02-27