Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af
Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af
Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af Tlp3556a, Tlp3556af
Photocouplers Photorelay
TLP3556A,TLP3556AF
1. Applications
• Mechanical relay replacements
• Security Systems
• Heating, ventilation and air conditioning (HVAC)
• ATE (Automatic Test Equipment)
• Factory Automation (FA)
• Battery Management System (BMS)
2. General
The TLP3556A and TLP3556AF photorelay consists of a photo MOSFET optically coupled to an infrared light
emitting diode. It is housed in a 4-pin DIP package. The low ON-state resistance and the high permissible ON-
state current of the TLP3556A and TLP3556AF make it suitable for power line control applications.
3. Features
(1) Normally opened (1-Form-A)
(2) OFF-state output terminal voltage: 100 V (min)
(3) Trigger LED current: 3 mA (max)
(4) ON-state current: 2 A (max)
(5) ON-state resistance: 200 mΩ (max)
(6) Isolation voltage: 2500 Vrms (min)
(7) Safety standards
UL-approved: UL1577, File No.E67349
cUL-approved: CSA Component Acceptance Service No.5A File No.E67349
VDE-approved: EN60747-5-5 (Pending) (Note 1)
(Note 1):When a VDE approved type is needed, please designate the Option (D4)
(D4).
11-5B201S 11-5B205S
11-5B2S
TLP3556AF TLP3556AF(LF4,TP4)
11-5B204S
11-5B202S
5. Pin Assignment
1: Anode
2: Cathode
3: Drain
4: Drain
6. Internal Circuit
©2017
2 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
7. Absolute Maximum Ratings (Note) (Unless otherwise specified, Ta = 25 )
Characteristics Symbol Note Rating Unit
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 1: This device is considered as a two-terminal device: Pins 1 and 2 are shorted together, and pins 3 and 4 are
shorted together.
Note: The recommended operating conditions are given as a design guide necessary to obtain the intended
performance of the device. Each parameter is an independent value. When creating a system design using
this device, the electrical characteristics specified in this data sheet should also be considered.
©2017
3 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
10. Coupled Electrical Characteristics (Unless otherwise specified, Ta = 25)
25
Characteristics Symbol Note Test Condition Min Typ. Max Unit
Note 1: This device is considered as a two-terminal device: Pins 1 and 2 are shorted together, and pins 3 and 4 are
shorted together.
©2017
4 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
13. Characteristics Curves and Circuit Connections
13.1. Characteristics Curves (Note)
©2017
5 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
Note: The above characteristics curves are presented for reference only and not guaranteed by production test,
unless otherwise noted.
©2017
6 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
14. Soldering and Storage
14.1. Precautions for Soldering
The soldering temperature should be controlled as closely as possible to the conditions shown below, irrespective
of whether a soldering iron or a reflow soldering method is used.
• When using soldering reflow.
The soldering temperature profile is based on the package surface temperature.
(See the figure shown below, which is based on the package surface temperature.)
Reflow soldering must be performed once or twice.
The mounting should be completed with the interval from the first to the last mountings being 2 weeks.
©2017
7 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
15. Ordering Information (Example of Item Name)
Item Name Packaging VDE Option Packing (MOQ)
©2017
8 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
Package Dimensions
Unit: mm
TLP3556A
Package Name(s)
TOSHIBA: 11-5B2S
©2017
9 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
Package Dimensions
Unit: mm
TLP3556A(LF1,TP1)
Package Name(s)
TOSHIBA: 11-5B201S
©2017
10 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
Package Dimensions
Unit: mm
TLP3556A(LF5,TP5)
Package Name(s)
TOSHIBA: 11-5B205S
©2017
11 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
Package Dimensions
Unit: mm
TLP3556AF
Package Name(s)
TOSHIBA: 11-5B202S
©2017
12 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
Package Dimensions
Unit: mm
TLP3556AF(LF4,TP4)
Package Name(s)
TOSHIBA: 11-5B204S
©2017
13 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0
TLP3556A,TLP3556AF
• TOSHIBA reserves the right to make changes to the information in this document and related Product without notice.
• This document and any information herein may not be reproduced without prior written permission from TOSHIBA. Even with TOSHIBA's
written permission, reproduction is permissible only if reproduction is without alteration/omission.
• Though TOSHIBA works continually to improve Product's quality and reliability, Product can malfunction or fail. Customers are responsible
for complying with safety standards and for providing adequate designs and safeguards for their hardware, software and systems which
minimize risk and avoid situations in which a malfunction or failure of Product could cause loss of human life, bodily injury or damage
to property, including data loss or corruption. Before customers use the Product, create designs including the Product, or incorporate
the Product into their own applications, customers must also refer to and comply with (a) the latest versions of all relevant TOSHIBA
information, including without limitation, this document, the specifications, the data sheets and application notes for Product and the
precautions and conditions set forth in the "TOSHIBA Semiconductor Reliability Handbook" and (b) the instructions for the application
with which the Product will be used with or for. Customers are solely responsible for all aspects of their own product design or applications,
including but not limited to (a) determining the appropriateness of the use of this Product in such design or applications; (b) evaluating
and determining the applicability of any information contained in this document, or in charts, diagrams, programs, algorithms, sample
application circuits, or any other referenced documents; and (c) validating all operating parameters for such designs and applications.
TOSHIBA ASSUMES NO LIABILITY FOR CUSTOMERS' PRODUCT DESIGN OR APPLICATIONS.
• PRODUCT IS NEITHER INTENDED NOR WARRANTED FOR USE IN EQUIPMENTS OR SYSTEMS THAT REQUIRE
EXTRAORDINARILY HIGH LEVELS OF QUALITY AND/OR RELIABILITY, AND/OR A MALFUNCTION OR FAILURE OF WHICH MAY
CAUSE LOSS OF HUMAN LIFE, BODILY INJURY, SERIOUS PROPERTY DAMAGE AND/OR SERIOUS PUBLIC IMPACT
("UNINTENDED USE"). Except for specific applications as expressly stated in this document, Unintended Use includes, without limitation,
equipment used in nuclear facilities, equipment used in the aerospace industry, medical equipment, equipment used for automobiles,
trains, ships and other transportation, traffic signaling equipment, equipment used to control combustions or explosions, safety devices,
elevators and escalators, devices related to electric power, and equipment used in finance-related fields. IF YOU USE PRODUCT FOR
UNINTENDED USE, TOSHIBA ASSUMES NO LIABILITY FOR PRODUCT. For details, please contact your TOSHIBA sales
representative.
• Do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy Product, whether in whole or in part.
• Product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any
applicable laws or regulations.
• The information contained herein is presented only as guidance for Product use. No responsibility is assumed by TOSHIBA for any
infringement of patents or any other intellectual property rights of third parties that may result from the use of Product. No license to any
intellectual property right is granted by this document, whether express or implied, by estoppel or otherwise.
• ABSENT A WRITTEN SIGNED AGREEMENT, EXCEPT AS PROVIDED IN THE RELEVANT TERMS AND CONDITIONS OF SALE
FOR PRODUCT, AND TO THE MAXIMUM EXTENT ALLOWABLE BY LAW, TOSHIBA (1) ASSUMES NO LIABILITY WHATSOEVER,
INCLUDING WITHOUT LIMITATION, INDIRECT, CONSEQUENTIAL, SPECIAL, OR INCIDENTAL DAMAGES OR LOSS, INCLUDING
WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF OPPORTUNITIES, BUSINESS INTERRUPTION AND LOSS OF DATA, AND
(2) DISCLAIMS ANY AND ALL EXPRESS OR IMPLIED WARRANTIES AND CONDITIONS RELATED TO SALE, USE OF PRODUCT,
OR INFORMATION, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE, ACCURACY OF INFORMATION, OR NONINFRINGEMENT.
• GaAs (Gallium Arsenide) is used in Product. GaAs is harmful to humans if consumed or absorbed, whether in the form of dust or vapor.
Handle with care and do not break, cut, crush, grind, dissolve chemically or otherwise expose GaAs in Product.
• Do not use or otherwise make available Product or related software or technology for any military purposes, including without limitation,
for the design, development, use, stockpiling or manufacturing of nuclear, chemical, or biological weapons or missile technology products
(mass destruction weapons). Product and related software and technology may be controlled under the applicable export laws and
regulations including, without limitation, the Japanese Foreign Exchange and Foreign Trade Law and the U.S. Export Administration
Regulations. Export and re-export of Product or related software or technology are strictly prohibited except in compliance with all
applicable export laws and regulations.
• Please contact your TOSHIBA sales representative for details as to environmental matters such as the RoHS compatibility of Product.
Please use Product in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances,
including without limitation, the EU RoHS Directive. TOSHIBA ASSUMES NO LIABILITY FOR DAMAGES OR LOSSES OCCURRING
AS A RESULT OF NONCOMPLIANCE WITH APPLICABLE LAWS AND REGULATIONS.
©2017
14 2017-11-30
Toshiba Electronic Devices & Storage Corporation
Rev.1.0