Scribd
Upload
168 views4 pages

Ruby Amp Project: Bill of Materials

Uploaded by

Mase mase
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
168 views4 pages

Ruby Amp Project: Bill of Materials

Uploaded by

Mase mase
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Ruby Amp Project

Version 2006May26 Copyright 2005 JD Sleep


Permission refused for posting/serving this file from any site other than www.generalguitargadgets.com

The Ruby Amp is a great little practice amp. The diagrams include wiring for a “power on”
indicator LED and also a diagram for an optional headphone jack. Schematic and
information are at http://www.runoffgroove.com. This is the layout information for PCB
building.

Bill of Materials
Resistors (1/4 watt rating)
1 – 10 ohm Capacitors (minimum 16 volt rating)
1 – 3k9 (3.9k) 2 – 0.047uF film or ceramic
1 – 1M5 (1.5M) 1 – 0.1uF film or ceramic
1 – 100uF aluminum electrolytic
Pots (1/4 watt or higher rating) 1 – 220uF aluminum electrolytic
1 – 1k Linear (or 1k Trimmer)
1 – 10k Linear Other
1 – mono quarter inch jack (speaker out)
Transistors 1 – stereo quarter inch jack (input)
1 – MPF102 (or 2N5457) - Optional LED and 1k resistor
- 9v battery snaps & holder and/or DC jack,
ICs - Copper-clad board, etchant, or perfboard
1 – LM386 or JRC386 - 24 gauge stranded wire
- Enclosure

Size 4.5cm x 3.1cm

Page 1
Ruby Amp Project
Version 2006May26 Copyright 2005 JD Sleep
Permission refused for posting/serving this file from any site other than www.generalguitargadgets.com

Page 2
Ruby Amp Project
Version 2006May26 Copyright 2005 JD Sleep
Permission refused for posting/serving this file from any site other than www.generalguitargadgets.com

Ruby with Trimmer Gain Control

Page 3
Ruby Amp Project
Version 2006May26 Copyright 2005 JD Sleep
Permission refused for posting/serving this file from any site other than www.generalguitargadgets.com

Optional wiring for a headphones jack, thanks to Michael Froehlich. A Zobel


Network is used for the headphones output. For clarity, only the output wiring
is shown in this diagram.

Page 4

You might also like