TCB TCB: UDV-2013072401 Shanghai Simcom LTD
TCB TCB: UDV-2013072401 Shanghai Simcom LTD
AUTHORIZATION TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:
NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE,
and is VALID ONLY for the equipment identified hereon for use under the
Commission's Rules and Regulations listed below.
Power output is conducted at the antenna terminal. Single Modular Approval. ERP
for part 22 is 30.7 dBm and EIRP for part 24 is 29.6 dBm.
This device is to be used only for mobile or fixed application. The antenna(s) used
for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures. End-Users must be provided with transmitter operation
conditions for satisfying RF exposure compliance. OEM integrators must insure
that the end user has no manual instructions to remove or install the module. For
mobile and fixed operating configurations the antenna gain, including cable loss,
must not exceed 3 dBi at 850/1900 MHz as defined in 2.1091 for satisfying RF
exposure compliance. Under no condition may an antenna gain be used that
would exceed the 7W erp Part 22 and the 2W eirp Part 24 power limits. The
Grantee is responsible for providing the documentation required for modular use.
The responsibility for the use of this module, in all configurations utilized or
contemplated, remains with the Grantee.
This module can only be used with a host antenna circuit trace layout design in
strict compliance with the OEM instructions provided.
BC: The output power is continuously variable from the value listed in this entry to 5%-10% of the value listed.