Scribd
Upload
89 views

Q No. Questions CO No.: C C W That Results in G

This document is an assignment sheet from the Department of Electronics and Communication Engineering at JSS Academy of Technical Education in Bangalore, India. It contains 10 questions related to analog circuits for Assignment 02. The questions cover topics like the IC555 timer used in astable and monostable multivibrators, FET amplifier analysis, designing an NMOS amplifier with certain specifications, calculating transistor parameters like gm and rπ at given bias currents, and analyzing the small-signal models of a BJT. It provides the relevant circuit diagrams, parameters, and equations needed to solve each problem. The assignment is due on April 24th, 2020.

Uploaded by

Samarth Sama
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
89 views

Q No. Questions CO No.: C C W That Results in G

This document is an assignment sheet from the Department of Electronics and Communication Engineering at JSS Academy of Technical Education in Bangalore, India. It contains 10 questions related to analog circuits for Assignment 02. The questions cover topics like the IC555 timer used in astable and monostable multivibrators, FET amplifier analysis, designing an NMOS amplifier with certain specifications, calculating transistor parameters like gm and rπ at given bias currents, and analyzing the small-signal models of a BJT. It provides the relevant circuit diagrams, parameters, and equations needed to solve each problem. The assignment is due on April 24th, 2020.

Uploaded by

Samarth Sama
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

JSS Academy of Technical Education, Bangalore

Department of Electronics and Communication Engineering

Analog Circuits
18EC42
Faculty Incharge:
Dr.Poornima N
Module No. : 1 & 5 Assignment No.: 02
Announcement Date: 10/04/2020 Submission Date: 24/04/2020

Q No. Questions CO
No.
1 Sketch the functional schematic of IC555 timer and explain. C212.4
2 Discuss the operation of IC555 timer as astable multi vibrator with relevant circuit diagram,
waveforms and derive the expression for duty cycle.
3 Construct an astable multi vibrator circuit using IC555 timer to obtain a square wave of frequency
5khz at 50% duty cycle.
4 Discuss the operation of IC555 timer as mono-stable multi vibrator with relevant circuit diagram,
waveforms and derive the expression for pulse width.
5 Consider the FET amplifier of Fig. shown below for the case Vt 0.4 V, Kn 4 mA/V2, VGS 0.65 V, VDD 1.8 C212.1
V, and RD 8 kΩ.
a) Find the dc quantities ID and VD.
(b) Calculate the value of gm at the bias point.
(c) Calculate the value of the voltage gain.
(d) If the MOSFET has λ0.1 /V, find r0 at the bias point and calculate the voltage gain.

An NMOS amplifier is to be designed to provide a 0.50-V peak output signal across a 50 kΩ load that can be
6
used as a drain resistor. If a gain of at least 5 V/V is needed, what gm is required? Using a dc supply of 1.8 V,
what values of ID and VOV would you choose? What W/L ratio is required if µn Cox 200 µA/V2? If Vt 0.4 V, find
VGS
An NMOS technology has µn Cox 250 µA/V2 and Vt0.5 V. For a transistor with L 0.5 µm, find the value of
7 W that results in gm1 mA/V at ID 0.25 mA. Also, find the required VGS
A transistor with β120 is biased to operate at a dc collector current of 0.6 mA. Find the values of gm, rπ, and re.
8 Repeat for a bias current of 60 µA.
9 A BJT is biased to operate in the active mode at a dc collector current of 0.5 mA. It has a βof 100. Give the two
small-signal models of the BJT complete with the values of their parameters.
10 Using a 3-V power supply, design a version of the circuit of Fig. shown below to provide a dc emitter current of
0.5 mA and to allow a 1-V signal swing at the collector. The BJT has a nominal β100. Use standard 5%
resistor values. If the actual BJT used has β50, what emitter current is obtained? Also, what is the allowable
signal swing at the collector? Repeat for β150
Faculty in-charge

You might also like