Penmount 1610 Control Board Data Sheet
Penmount 1610 Control Board Data Sheet
PenMount 1610 Control Board uses Microcontroller, which is a capacitive sensing IC designed for AMT Projected
Capacitive Input (PCI) touch panel and other projected capacitive touch panel. It is designed for PCI touch screen
size up to 10.1”. PenMount 1610 Control Board has the programmable filter, gain amplifier; with the functions of
single-ten finger touch; and the gestures of one and more fingers. There are four connectors on this board: 40 Pins
& 50 Pins ZIF connectors for PCI touch screen FPC cable, one USB connector for 4-pin USB cable (optional) , and
one I²C connector for 7-pin I²C cable (optional).
Specifications
Touch Screen Size 8.4” to 10.1"
USB, Full-speed, 12Mbps
Interface
I²C, Slave, support 400 kHz specifications
Touch Screen Controller PenMount P3-03
Mechanical Size 70 x 30 mm
ADC resolution Dual 12 bits
Operating Voltage +5V DC
Storage Temperature -40°C ~ +85°C
Operating Temperature -20°C ~ +70°C
Power Consumption Typical – 36.4 mA / 5V
Max. touch line 32 sensing lines; 45 driving lines
Sample rate > 84 sps
Note: 1. PenMount P3-03 is using SIS-9255 IC
2. Power consumption and sample rate will vary according to different firmware versions , panel size
and thickness.
Firmware Features
On Field-update firmware
Signal sensitivity tuning capability
With noise filter feature on firmware
Perform smoothing & jitter filter for drawing
Touch panel rotation with X-Y coordinate reverse and/or swap
Touch linearity compensation in border area
High sampling rate
Driver Software
Windows 7 : ten fingers touch, Inbox driver for USB interface.
Windows 8 : ten fingers touch, Inbox driver for USB interface.
Bottom View