Scribd
Upload
35 views2 pages

Session 10 Day 1 Review

The document summarizes a VERICUT simulation session review exercise. It lists 8 steps to apply concepts from previous training, including opening a project file, simulating a toolpath to detect errors, adjusting the tool length, checking for collisions, measuring wall thickness, and comparing models. It asks multiple choice questions after several of the steps to check understanding. The conclusion congratulates the reader for surviving the first day.

Uploaded by

Le Huynh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
35 views2 pages

Session 10 Day 1 Review

The document summarizes a VERICUT simulation session review exercise. It lists 8 steps to apply concepts from previous training, including opening a project file, simulating a toolpath to detect errors, adjusting the tool length, checking for collisions, measuring wall thickness, and comparing models. It asks multiple choice questions after several of the steps to check understanding. The conclusion congratulates the reader for surviving the first day.

Uploaded by

Le Huynh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Session 10

Day 1 Review Session


In this exercise, we will apply what we have seen today. The steps are not listed. Refer to
the previous training session for step-by-step instructions.
1. Open project file review_session1.vcproject
• Launch VERICUT
• File > Open
• Shortcut = Training
• File = review_session1.VcProject
• Open
2. Cut part and monitor the errors
How many errors are detected?
A. 2
B. 110
C. 293
D. 88
E. No error, I just like the color red…
3. Set VERICUT to stop the simulation at line 223
What caused the error?
A. Tool too short, the holder rubs
B. This tool cannot ramp into the part, causing a shank collision
C. 42
D. Collision with the fixture
E. The machine operator fell asleep

4. Calculate the Minimum Cutter Extension


How much longer does Tool #8 needs to be?
A. About .125
B. About .500
C. 42
D. About .875
E. The tool fell off the holder and I can’t find it!

VERICUT V6 Session 10 1
5. Detect Machine Collisions
The tool collides with which machine component (other than the fixture)?
A. A Table
B. Y Axis
C. 42
D. X Axis table
E. The machine operator!

6. Measure the wall thickness


What is the thickness of the vertical walls?
A. 0.043
B. 0.071
C. 42
D. .002
E. Well, about 1/8th?! …I think!

7. Compare the Cut Stock with the Design model to detect


gouges larger than 0.002 inch
How many errors in the AUTO-DIFF report?
A. 1
B. 3
C. 42
D. 9
E. Where is the report?!

8. Exit VERICUT
• File > Exit
• Ignore All Changes
Conclusion
You survived the first day, congratulation

VERICUT V6 Session 10 2

You might also like