Scribd
Upload
154 views1 page

Display and Buttons: Chronograph Vd53

The document provides instructions for setting the time, date, and chronograph functions on a watch. It explains how to set the time by pulling out the crown and turning it, set the date by pulling the crown out to the first position and turning it counter-clockwise, and use the chronograph buttons to start, stop, and reset timing. It also provides cautions about battery usage and care of the watch.

Uploaded by

atif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
154 views1 page

Display and Buttons: Chronograph Vd53

The document provides instructions for setting the time, date, and chronograph functions on a watch. It explains how to set the time by pulling out the crown and turning it, set the date by pulling the crown out to the first position and turning it counter-clockwise, and use the chronograph buttons to start, stop, and reset timing. It also provides cautions about battery usage and care of the watch.

Uploaded by

atif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

www.JBWTIME.

com

CHRONOGRAPH VD53

DISPLAY AND BUTTONS

Minute Hand
Chronograph
24 Hour
Minute Hand
Button A

Normal Crown
Position 1st Position

2nd Position

31

Button B
Chronograph
Second Hand
Second Hand Calendar
Hour Hand

SETTING THE TIME


1. Pull the crown out to the 2nd position.
2. Turn the crown clockwise to set hours and
minutes to desired time.
3. Push the crown back to the normal position.
ATTENTION: For watches with a screwdown crown, unscrew
to set time and when finished screw back crown fully to avoid
water entering the module. Crown covers should only be
rotated 90 degrees clock-wise to access the crown.

SETTING THE DATE


1. Pull the crown out to the 1st position.
2. Turn the crown counter clockwise to set the date.
3. Push the crown back to the normal position.
*Note: Do not adjust date between 9:00 PM and 1:00
AM. Date may not change correctly
the following day.

CHRONOGRAPH FUNCTION
1. To start the chronograph press Button A.
2. To stop the chronograph press Button A again.
3. To reset the chronograph press Button B.
*Note: Chronograph runs a maximum of 1 hour.

CHRONOGRAPH ALIGNMENT
1. Pull crown out to 2nd position and press Button A
until chronograph second hand is at 12 o’clock.
2. Push crown back to normal position.

CAUTION
1. Do not touch internal components other than the
batteries.
2. Keep your watch in a cool dry place.
3. Avoid abrasions as scratching may eventually
affect the case and bracelet.

BATTERY INSTRUCTIONS
1. Mixed usage of a different type of battery or use of
new and used battery is not recommended.
2. Battery should be inserted with correct polarity.
3. Supply terminals should not be short-circuited.

You might also like