Scribd
Upload
52 views4 pages

Moving Heat Source

The document defines variables to control a thermal simulation over time. It initializes the temperature source, time increment, load step count, and time count. It then performs a DO loop where it increments the load step count, time count, and applies the temperature source to nodes at each iteration.

Uploaded by

Pranesh Sb
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
52 views4 pages

Moving Heat Source

The document defines variables to control a thermal simulation over time. It initializes the temperature source, time increment, load step count, and time count. It then performs a DO loop where it increments the load step count, time count, and applies the temperature source to nodes at each iteration.

Uploaded by

Pranesh Sb
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 4

temp_source = 3000

time_increment = 5
lscount = 0
time_count = 1
*DO, i, x_min, x_max,20
lscount = lscount + 1
TIME, time_count
D, NODE(NX(i),NY(y_loc),NZ(z_loc)),TEMP,temp_source
LSWRITE, lscount
DDELE, ALL, ALL
time_count = time_count + time_increment
*ENDDO

*do,w,0,1,0.0125 !The movement is divided 81 steps and �w

is

the ratio of the line length.

lwplan,-1,231,w ! Define the working plane normal to a location

on line 231.

wpro,,90 ! Rotate the working plane about X axis.

cswpla,11,1,1,1

!Define

cylindrical

coordinate

system

at

the

origin of the working plane.

nsel,s,loc,z,0 !Select the nodes on the surface (z=0).

nsel,r,loc,x,,8 !Reselect the nodes on the surface (x=8).

*get,nodmax,node,,num,max
!Retrieve

the

maximum

number

of

nodes and assignment �

nodmax

*get,nodmin,node,,num,min

!Retrieve

the

minimum

number

of

nodes and assignment �

nodmin

*dim,aa,array,nodmax,1,1, !Define an array parameter

�aa�

and

its dimensions

is �

nodmax
�

*do,kk,nodmin,nodmax

!Loop from �

nodmin

� to �

nodmax

*if,nsel(kk),eq,1,then

!If node �kk� is selected

*SET,aa(kk),51.1*exp(-3*((nx(kk))/7.1)**2) !Assignment the heat

flux values to array

�aa�

*else

*SET,aa(kk),0 !

If node �kk� is not selected,

aa(kk)

0.

*endif

*enddo

sffun,hflux,aa(1) !

Array �aa� is applied to the heat flux of

function distribution.

sf,all,hflux,0 ! Load heat flux to n

ode �kk�, the

value is 0
+

aa(kk).

You might also like