Scribd
Upload
533 views3 pages

Structural Report Format by ASEP

This document provides the structural design criteria for a proposed 2-storey reinforced concrete building located at 123 Quezon Avenue, Quezon City, Metro Manila. It outlines the loadings including dead, live, wind and seismic loads to be used in design. It specifies the material properties of concrete, structural steel and reinforcing bars. The document also states the applicable codes, foundations details based on a geotechnical report, and notes the occupancy category and story drift limitations in accordance with the National Structural Code of the Philippines.

Uploaded by

Jaybert Dumaran
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
533 views3 pages

Structural Report Format by ASEP

This document provides the structural design criteria for a proposed 2-storey reinforced concrete building located at 123 Quezon Avenue, Quezon City, Metro Manila. It outlines the loadings including dead, live, wind and seismic loads to be used in design. It specifies the material properties of concrete, structural steel and reinforcing bars. The document also states the applicable codes, foundations details based on a geotechnical report, and notes the occupancy category and story drift limitations in accordance with the National Structural Code of the Philippines.

Uploaded by

Jaybert Dumaran
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Date: December 5, 2020

STRUCTURAL DESIGN COMPUTATION


FOR

PROPOSED 2-STOREY RC BUILDING


AT 123 QUEZON AVENUE, QUEZON CITY
METRO MANILA

Prepared by:

JAYBERT VARGA DUMARAN


Civil / Structural Engineer, RMP
Registration No. 0152513
Registration Date: May 25, 2017
STRUCTURAL DESIGN CRITERIA

LOADINGS
1. DEAD LOAD
 Concrete - 24 kN/cu.m
 Structural Steel - 27 kN/cu.m
 25 mm concrete topping - 0.60 kPa
 Floor Finish - 0.50 kPa
 Ceiling - 0.15 kPa
 Utilities (Water, Electrical & Mechanical) - 0.24 kPa
 150 mm CHB exterior wall - 2.40 kPa
 100 mm CHB interior wall - 1.76 kPa
 Gypsum board wall on metal frames - 0.38 kPa

2. DEAD LOAD
 Commercial - 1.9 kPa
 Stairways - 2.4 kPa

3. WIND LOAD – Applicable for provision Zone 2

4. SEISMIC LOAD – Applicable for provision Zone 4

5. LOAD COMBINATIONS

 D+L
 1.4D
 1.2D + 1.6L +0.5(Lr or R)
 1.2D + 1.0W 0.5L(Lr or R)
 1.2D + 1.0E + 0.5L
 0.9D + 1.0E
OCCUPANCY CATEGORY
IV – Standard Occupancy Structure
STORY DRIFT LIMITATION
In accordance with the 208.6.5(for 5 storey) provision of NSCP PLEASE READ!!!
FOUNDATION
Soil bearing capacity of 144 kPa shall be used for gravity loading based on the provided
geotechnical report by ABC Geotek, Inc.

MATERIAL PROPERTIES
1. Concrete Compressive Strength in 28 days, fc' =27 Mpa
2. Structural Steel Yield Strength, fy = 248 Mpa
3. Reinforcing Bar Yield Strength: for 12mm dia. and below, fy = 275 Mpa
for above 12mm dia., fy = 414 Mpa

APPLICABLE CODES / REFERENCES


1. National Structural Code of the Philippines, Volume I – 7th Edition
2. National Building Code of the Philippines, Latest Edition
3. American Concrete Institute, ACI 318-14M, Building Code requirements for Reinforce Concrete
4. ASEP Steel Manual, 1st Edition

You might also like