Scribd
Upload
135 views4 pages

Quiz

This document contains 19 multiple choice questions about networking topics such as routing protocols, IPv6, VPNs, and more. It tests understanding of concepts discussed in Chapter 1 such as the differences between interior and exterior routing protocols, factors that influence routing protocol convergence time, and IPv6 address types and their uses. The questions provide explanations for the correct answers referring back to content from Chapter 1.

Uploaded by

Henry Vizcaino
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
135 views4 pages

Quiz

This document contains 19 multiple choice questions about networking topics such as routing protocols, IPv6, VPNs, and more. It tests understanding of concepts discussed in Chapter 1 such as the differences between interior and exterior routing protocols, factors that influence routing protocol convergence time, and IPv6 address types and their uses. The questions provide explanations for the correct answers referring back to content from Chapter 1.

Uploaded by

Henry Vizcaino
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 4

Which two major areas can be used when discussing the high-level overview of a

typical enterprise network? Choose two.


You Answered
Campus backbone
Building distribution
Building access
Correct Answer
Enterprise campus
Correct!
Enterprise edge
Refer to Chapter 1.

Question 2
0 / 1 pts
Which of the following is used when choosing a dynamic routing protocol? Choose
two.
You Answered
Cost of equipment
Correct Answer
Knowledge level of a specific routing protocol
Correct!
Scalability
Type of links supported
Refer to Chapter 1.

Question 3
0 / 1 pts
BGP is which type of protocol?
You Answered
Distance vector
Advanced distance vector
Link-state
Correct Answer
Path vector
Refer to Chapter 1.

Question 4
0 / 1 pts
Which two factors can influence convergence time for a routing protocol? Choose
two.
Correct Answer
Fine tuning routing protocol timers
Number of end devices with IP addresses.
Correct!
Configuring route summarization
You Answered
Implementing authentication
Refer to Chapter 1.

Question 5
0 / 1 pts
Scalability of a network includes which two factors? Choose two.
Correct Answer
Number of adjacent neighbors
Correct!
Number of routers
Distance between routers
You Answered
Ability to do auto summarization
Refer to Chapter 1.

Question 6
1 / 1 pts
Which of the following traffic types is not supported by IPv6?
Unicast
Multicast
Anycast
Correct!
Broadcast
Refer to Chapter 1.

Question 7
1 / 1 pts
What is the IPv6 multicast address used by EIGRP?
FF02::5
FF02::6
FF02::9
Correct!
FF02::A
Refer to Chapter 1.

Question 8
1 / 1 pts
Which type of IPv6 address is used by routing protocols for communications only on
the link?
Unique local
Site local
Correct!
Link-local
Multicast
Refer to Chapter 1.

Question 9
0 / 1 pts
Which type of ICMPv6 message is sent by a device to request information about the
network such as the prefix, prefix length and default gateway?
Neighbor Advertisement
You Answered
Neighbor Solicitation
Router Advertisement
Correct Answer
Router Solicitation
Refer to Chapter 1.

Question 10
1 / 1 pts
Which type of ICMPv6 message is sent by a device to inform another device of its
IPv6 address and associated Ethernet address?
Correct!
Neighbor Advertisement
Neighbor Solicitation
Router Advertisement
Router Solicitation
Refer to Chapter 1.

Question 11
1 / 1 pts
Which type of network allows access to multiple devices on the same network but
does not provide broadcast capabilities?
Point-to-point
Broadcast
Correct!
NBMA
Multi-access
Refer to Chapter 1.

Question 12
0 / 1 pts
Which type of subinterface provides connections similar to physical point-to-point
links and has no neighbor discovery issues?
Correct Answer
Point-to-point
Point-to-multipoint
Multipoint
You Answered
All of the above
Refer to Chapter 1.

Question 13
1 / 1 pts
Which tunneling protocol was developed by Cisco to encapsulate a Layer 3 protocol
inside a point-to-point, tunnel-over-IP network?
Correct!
GRE
DMVPN
IPsec
MPLS
Refer to Chapter 1.

Question 14
0 / 1 pts
A Layer 3 MPLS VPN over GRE is an example of what type of VPN?
DMVPN
You Answered
Multi-VPN
Combination VPN
Correct Answer
Hybrid VPN
Refer to Chapter 1.

Question 15
0 / 1 pts
What protocol is used by routers implementing DMVPN to determine the next-hop IP
address in tunneling networks?
Dynamic GRE
Correct Answer
NHRP
You Answered
mGRE
MPLS
Refer to Chapter 1.

Question 16
1 / 1 pts
What framework of open standards that provides confidentiality, data integrity,
authentication and anti-replay protection?
Correct!
IPsec
VPN
PAP
PSK
Refer to Chapter 1.

Question 17
0 / 1 pts
R1 has an adjacent RIPng neighbor R2. R1 has a LAN with no neighbors,
2001:DB8:ACAD:1::/64. R1 advertises this prefix to adjacent RIPng neighbor, R2.
What metric does R2 display for 2001:DB8:ACAD:1::/64?
You Answered
1 hop
Correct Answer
2 hops
3 hops
4 hops
Refer to Chapter 1.

Question 18
1 / 1 pts
How is an interface enabled for RIPng?
Using the network prefix/prefix-length router mode command
Correct!
Using the ipv6 rip name enable interface command
Interfaces are automatically enabled for RIPng when the RIPng process is started
Using the router ripng name interface command
Refer to Chapter 1.

Question 19
1 / 1 pts
Router R1 has multiple routes in its routing table including RIPng routes, directly
connected networks and a static default route. R2 receives a default route from R1
but no other routes. This is because R1 uses which option at the end of ipv6 rip
name default-information interface command?
static
originate
default-only
Correct!
only
Refer to Chapter 1.

You might also like