Scribd
Upload
282 views3 pages

Konfigurasi Inter VLAN Routing Dengan Multilayer Switch Cisco Packet Tracer

This document provides instructions for configuring inter-VLAN routing on a Cisco multilayer switch using Packet Tracer. It involves: 1) Configuring ports on Switch0 for access to VLANs 10, 20 and 30 and trunk port configuration. 2) Entering configurations on the multilayer switch such as IP addresses for each VLAN interface, VLAN configurations, trunk encapsulation and enabling IP routing.

Uploaded by

Agus Pudjiarto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
282 views3 pages

Konfigurasi Inter VLAN Routing Dengan Multilayer Switch Cisco Packet Tracer

This document provides instructions for configuring inter-VLAN routing on a Cisco multilayer switch using Packet Tracer. It involves: 1) Configuring ports on Switch0 for access to VLANs 10, 20 and 30 and trunk port configuration. 2) Entering configurations on the multilayer switch such as IP addresses for each VLAN interface, VLAN configurations, trunk encapsulation and enabling IP routing.

Uploaded by

Agus Pudjiarto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

JOBSHEET 4:

Konfigurasi Inter VLAN Routing Dengan


Multilayer Switch Cisco Packet Tracer
1. Pertama masuk ke konfigurasi Switch0
Switch>en
Switch#conf t
Switch(config)#int fa0/2
Switch(config-if)#switchport access vlan 10
Switch(config-if)#ex
Switch(config)#int fa0/3
Switch(config-if)#switchport access vlan 20
Switch(config-if)#ex
Switch(config)#int fa0/4
Switch(config-if)#switchport access vlan 30
Switch(config-if)#ex
Switch(config)#int fa0/1
Switch(config-if)#switchport mode trunk

Switch>show vlan brief


2. Lalu masuk ke konfigurasi Multilayer Switch
Switch>en
Switch#conf t
Switch(config)#int fa0/1
Switch(config-if)#switchport trunk encapsulation dot1q
Switch(config-if)#switchport mode trunk
Switch(config-if)#ex
Switch(config)#int vlan 10
Switch(config-if)#ip add 192.168.10.1 255.255.255.0
Switch(config-if)#int vlan 20
Switch(config-if)#ip add 192.168.20.1 255.255.255.0
Switch(config-if)#int vlan 30
Switch(config-if)#ip add 192.168.30.1 255.255.255.0
Switch(config-if)#ex
Switch(config)#ip routing
Switch(config)#vlan 10
Switch(config-vlan)#vlan 20
Switch(config-vlan)#vlan 30

You might also like