Scribd
Upload
163 views1 page

Pressure Switch

Pressure switch can be used to detect pressure in pipe

Uploaded by

Ilham Fahmi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
163 views1 page

Pressure Switch

Pressure switch can be used to detect pressure in pipe

Uploaded by

Ilham Fahmi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

System Components

UL EX-4510 12-1-03 Page 1-14

Pressure Switch – DPST

The pressure switch can be used to open or close electrical 3 5/8 IN.
2 7/8 IN.
(9.2 cm)
circuits to either shut down equipment or turn on lights and (7.3 cm)

alarms. The double pole, single throw (DPST) pressure


switch is constructed with a gasketed, water-tight housing.
The housing is constructed of malleable iron. A 1/4 in. NPT
pressure inlet is used to connect the pressure switch to the
1/4 in. actuation piping between the ANSUL AUTOMAN II-C
4 9/16 IN.
release and the pneumatic actuator on the master (12 cm)
SAPPHIRE tank valve.
Minimum operating pressure is 50 psi (3.5 bar)
004593

Shipping Assembly
Part No. Description
000716
46250 Pressure Switch – DPST

Thread Electrical
Component Material Size/Type Rating Approvals
Pressure Switch Switch: BAKELITE Conduit Inlet: 2 HP – 240 UL Listed
DPST 3/4 in. NPT Female VAC/480 VAC ULC Listed
Housing: Malleable Iron Pressure Inlet: 2 HP – 250 VDC FM Approved
Piston: Brass 1/4 in. NPT Female 30A – 250V AC/DC
Cover: Brass 5A – 480V AC/DC

ANSUL and SAPPHIRE are trademarks of Ansul Incorporated or its affiliates.

TYCO SAFETY PRODUCTS, MARINETTE, WI 54143-2542 715-735-7411 Form No. F-2003196 © 2003 Ansul Incorporated Litho in U.S.A.

You might also like