KYAMBOGO UNIVERSITY Faculty of Engineering UNIVERSITY EXAMINATIONS 2013/2014 Mist Year Semester Two Test for Bachelor of Engineering in: Mechanical and Manufacturing Engineering, Automotive and Power En} Environmental Engineering and Management; Bachelor of Industrial Engineering and Management; and Bxchelor of Vocational and Technological Studies. ME 122 MECHANICAL ENGINEERING DRAWING Date: Saturday May 3, 2014 Time: 2.00 p mo 5.00 p.m. Instructions to Candidates * This examination contains Eight questions Attempt question One and any other three questions Question one carries 40 marks and the remaining questions carry 20 marks each. All dimensions are i: mm unless stated otherwise All unstated fillet radii are 3mm and where dimensions are not given you may proportionally estimate the dimensions le calculator Question One (Machine drawing - assembly of parts) Fig. 1 attached shows details of parts of a STUFFING BOX. Draw full size in Third Angle Projection the following views of the stuffing box with all parts well assembled including the necessary nuts and a suitable form of locking device: (2) asectional front elevation on B-B 6 marks (®) —_aplan in projection with the view in (a) above, (include hidden details) 4 marks (©) _ Insert on the drawing you have drawn a parts list of assembled parts 1 to4 4 marks ()__Insert on the drawing you have drawn in (a) four dimensions of varied nature, 4 marks (©) Prepare a suitable title block and include in it the title, your name, index number. paper number, date, scale, and angle of projection 2 marks Question Two (Development) ‘Yke elevation and plan of a hopper which is rectangular and fitted to a cytind is shown in fig.2. Copy the given views full size and develop the parts mati hopper considering the most economical edges as the seam. 20 marks Question Three (True Length) ‘The plan and elevation of 2 triangular lamina are given in fig,3 in first angle projection. (a) Copy the given views full size and determine the true lengths of ab, ac and cd and then construct the true shape of the lamina . 14 marks (®) Measure and state the true lengths of ab, ac and cd and the included angles of the lamina, 6 marks Question Four (Interpenctration) ‘Two interpenetrating cylinders of @ 60 mm and @ 42 mm are skown in third angle projection in fig.4. Copy the given views full size und draw the following: (@) The interpenetration curve on the elevatio: 14 marks (b) The end view as seen from t'e direction of arrow E 6 marksQuestion Five (Ce-3} (@) > Oulline the furetion of a cam oo (>) _Lilustrate diagrammatically the three basic cam follower motions indi the parameters involved ©) A flate cam is to operate an inline flat follower. Draw the cain profiis gi the following information; 0° - 90", dwoil interval; $0” — 249°, Lift of 57 mm with Unifomm Acceleration and Retardation; and 240°- 366", Fall of 32 mm ‘e; nearest approach :o 12 toarke Question Six (Gears) | (@) A wheel and pinion spur gears are to mesh. Draw clear iabclle Meshing gears and alto indicate the line of action, common: laigent, pressure angle, centre distance, pitc’ point, dedeadum and addenduin. 8 marks (b) A wheel with 25 teeth is to mesh with a rack whose tavei is 250mm. The pressure agie is 20° anc module is 5 mm. using