Scribd
Upload
143 views1 page

cs4471 OSPF Lab

This document describes a lab assignment to configure a network with three routers running OSPF. Students are instructed to build the network in Cisco Packet Tracer and configure OSPF areas and routing. They then need to verify connectivity using ping and traceroute, check OSPF neighbor status and interfaces, and examine routing tables and OSPF packet captures. The goal is to demonstrate a working multi-area OSPF configuration and understand related OSPF concepts and commands.

Uploaded by

Juan Pablo Aragon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
143 views1 page

cs4471 OSPF Lab

This document describes a lab assignment to configure a network with three routers running OSPF. Students are instructed to build the network in Cisco Packet Tracer and configure OSPF areas and routing. They then need to verify connectivity using ping and traceroute, check OSPF neighbor status and interfaces, and examine routing tables and OSPF packet captures. The goal is to demonstrate a working multi-area OSPF configuration and understand related OSPF concepts and commands.

Uploaded by

Juan Pablo Aragon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CS4471 OSPF Lab (version 1.

3)
Name___________________
CIN_____________________
Group___________________

Use Cisco Packet Tracer to create the OSPF network shown below containing 3 interconnected Cisco 1841 routers, one
computer, and one server. Note that three subnets need to be configured to be in OSPF area 0 while remaining two
subnets are in different OSPF areas. Make sure that the three routers are configured with OSPF router-id values
shown in diagram.

1. (2 pts) Verify that from PC0 you can ping the IP address of the other devices.
a. Submit screenshot of the network drawn in Cisco Packet Tracer.
b. Submit screenshot of output of command "tracert 192.168.3.2".

2. (2 pts) On Router1, verify that OSPF adjacency has been established with the other two routers.
a. Submit output of IOS command "show ip ospf neighbor" executed on Router1.
b. What are 7 possible states that OSPF can be in?
c. What OSPF state should the router2 be in with each OSPF neighbor when everything is working correctly?

3. (1.5 pts) on Router3,


a. submit the output of "show ip ospf interface".
b. What is the meaning of OSPF Hello time, Dead time, Wait Time, and Retransmit time shown in the output?

4. (1.5 pts) On Router2, execute command "traceroute 192.168.2.1" a few times.


a. How was Router2 routing traffic destined to 192.168.2.1 ? Explain this routing behavior.
b. Submit output of command "show ip route" from Router2.

5. (1.5 pts) submit printout of output of “show running-config” of each router.

6. (1.5 pts) From simulation mode, capture and decode two different types of OSPF packets ( such as Hello and LSU ).
Submit screenshots of these decoded packets.

You might also like