Scribd
Upload
116 views2 pages

EE1000

This document is the mid-term examination for the 1st semester Basic Electrical Engineering course at the National Institute of Technology Rourkela. It contains 7 questions related to circuit analysis using concepts like superposition theorem, voltage and current dividers, phasors, resonance in RLC circuits, and 3-phase power. The exam is worth a total of 30 marks and has a duration of 2 hours. Students are instructed to attempt all questions and provide brief answers.

Uploaded by

Swastik Lenka
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
116 views2 pages

EE1000

This document is the mid-term examination for the 1st semester Basic Electrical Engineering course at the National Institute of Technology Rourkela. It contains 7 questions related to circuit analysis using concepts like superposition theorem, voltage and current dividers, phasors, resonance in RLC circuits, and 3-phase power. The exam is worth a total of 30 marks and has a duration of 2 hours. Students are instructed to attempt all questions and provide brief answers.

Uploaded by

Swastik Lenka
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

NATIONAL INSTITUTE OF TECHNOLOGY ROURKELA

Department of Electrical Engineering


Mid-term Examination, Session: 2019 - 2020 (Autumn)
Program: B.Tech
Semester: 1st
Subject Name: Basic Electrical Engineering
Subject Code: EE1000

Number of Pages: 2 Full Marks: 30 Duration: 2 Hours


Figures at the right hand margin indicate marks.
All symbols carry usual meaning. Assume standard value for any missing data.

Attempt all questions. Be brief and to the point.

1. State superposition theorem. Find I0 in the circuit given in Fig. 1 using superposition principle. [4]

6V
1 k
-+

4 mA
1 k

2 k 2 k
2 mA Io

Figure 1: For Q. 1

2. In Fig. 2(a), the voltage across the terminals X-Y and voltage across the current source after the removal
of 50Ω resistance are 75V and 25V , respectively (with upper side positive). When terminals X-Y are
short circuited, short-circuit current of 7.5A flows downward. Find the values of RA , RB , RC . When
load resistance 50Ω is connected between the terminals X-Y, find load current IL . Calculate the amount
of power absorbing or delivering by the current and voltage sources. [6]

IS
X
1Ÿ RA RC IL
RB 50Ÿ
100V
5A
Y

Figure 2: (a) For Q. 2 (b) For Q. 3


ŸDV
3. Find VT h and RT h with respect to terminal A-B for the circuit given in Fig. 2(b), [5]

Please go on to the next page. . .


Basic Elec. Engg. Mid-term Examination Page 2 of 2

4. In the circuit given in Fig. 3, calculate and draw the phasors I1 , I2 , VAB (voltage across current source).
Given that I = 10∠0◦ A. [4]

Figure 3: For Q. 4

5. For an R-L-C series circuit, it is given that bandwidth= 10π rad/s , resonance-frequency= 100π rad/s.
The circuit consumes 100W at the half-power frequencies when the source voltage is 10V . Find values
of R, L and C.
[4]

6. Find RMS value for the signal given in Fig. 4(a) [2]

v(t) (V)
10

0 2 4 6 8 1 0 12 14 16

t(s)

-10

Figure 4: (a) For Q. 6 (b) For Q. 7

7. Calculate total power consumed by the 3-Phase load shown in Fig. 4(b). Phase sequence is A-B-C, line
voltage is 220V and load resistances R = 5Ω. Find the angle between line voltage and line current. If a
wattmeter is connected as shown in the figure, what will be the reading? [5]

You might also like