Scribd
Upload
506 views43 pages

Cgdi Prog MB Key Programmer User Manual en

This document provides instructions for using CGDI MB car key programming software. The software allows users to: 1) Collect data from the original key by clicking buttons and inserting the key into the ignition switch without removing it. 2) Generate a key file and password using the collected data. 3) Write the generated key file to a new blank key using an NEC adapter connected to the vehicle's diagnostic port.

Uploaded by

Armen Gevorgyan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
506 views43 pages

Cgdi Prog MB Key Programmer User Manual en

This document provides instructions for using CGDI MB car key programming software. The software allows users to: 1) Collect data from the original key by clicking buttons and inserting the key into the ignition switch without removing it. 2) Generate a key file and password using the collected data. 3) Write the generated key file to a new blank key using an NEC adapter connected to the vehicle's diagnostic port.

Uploaded by

Armen Gevorgyan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 43

CGDI-MB

User manual
for CGDI MB car key add
Click：Lock（EIS)
Click：read Lock（EIS）data
1 click:calculate password 2 click：make key with key
1 click：other key（one Generation of key 705E6 key）
2 click ：confirm

1 click ：collecting data


pls insert key into(Auto ignition switch /EIS）then ,click “confirm”
pls insert key into（on the bez devices）then ,click “confirm”
collecting data ,pls dont remove key !!!
collecting data ,pls dont remove key !!!
pls insert key into（Auto ignition switch /EIS）click “confirm”！！！
pls be attention to wait 10-15 seconds,pls dont remove!!!
pls operate as picture showed ！
pls operate as picture showed！(Auto ignition switch as showed EIS）
pls operate as instruction！(its Auto ignition switch as showed EIS above)
pls operate as instructions！
pls save data！（suggestion：named new
file to save）
click:upload data
click：open
pls operate as instructions ！
click：The query results
2 click：Lock/EIS

1 click ：copy
click：paste
（2）click：save lock/EIS data

（1）check password if correct or


not ！
click：save（Stored in the build directory）
（2）click：generate EE

（1）click：confirm
click：loading lock data
click：open
click：generate key file
click：save
click：read/write key

（1）click：confirm
write BE key click：IR（IR is the key hole on equipment ）

NEC adapter：use for writting original key.include smart key(method: remove the chip to weld)
（1）click ：read key

（2）click：open (pls insert new key into devices before click）


just show NEC adapter（ignore）
devices instruction，click “confirm”
select the location of writting key：click”open”
pls be attention to wait！！！
click：confirm（finished making key successfully）.then,dont forget to charge ur
customer!!
Password display area （Write down
the password manually ）

BE key read password directly，no need collect data！

You might also like