Scribd
Upload
47 views

Assignment 2

This document provides instructions for an assignment to create assembly drawings of a pulley. Students are to: 1) Draw a full sectional view from the front with a cutting plane passing through B-B, showing the internal features. 2) Draw the end view from direction H, omitting hidden details and including a hex nut. 3) Include a parts list with part numbers, descriptions, materials, and quantities for each part. 4) Add a suitable title block with the assembly title. The document provides an orthographic view of the pulley parts, basic part sizes, and a parts list table with specifications.

Uploaded by

Elvis Kadagi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
47 views

Assignment 2

This document provides instructions for an assignment to create assembly drawings of a pulley. Students are to: 1) Draw a full sectional view from the front with a cutting plane passing through B-B, showing the internal features. 2) Draw the end view from direction H, omitting hidden details and including a hex nut. 3) Include a parts list with part numbers, descriptions, materials, and quantities for each part. 4) Add a suitable title block with the assembly title. The document provides an orthographic view of the pulley parts, basic part sizes, and a parts list table with specifications.

Uploaded by

Elvis Kadagi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ASSIGNMENT 2 – EMG 2105 (Due 13th February 2019)

Fig Q1 shows parts of a pulley in first angle ORTHOGRAPHIC projection. The bracket provides

support, the axle bolt holds the pulley and is fastened to the bracket by nut and washer. The bushes are

inserted between the axle bolt and the pulley to reduce friction. The basic sizes of the parts are given and

assembly tolerances are ignored. Include a hex nut of specification M16 x 1.5 in your assembly drawing.

Assemble the parts of the pulley shown and draw the following views:

a) Full sectional view from the front, with the cutting plane passing through B-B [15 mks]

b) The END VIEW from direction H without the hidden details and showing the nut. [7 mks]

c) Include a parts list [4 mks]

d) Include a suitable title block, with the title of the assembly [4 mks]

PARTS LIST
PART NO. DESCRIPTION MATERIAL NO. PER ASSY

1 BRACKET CAST IRON 1

2 V PULLEY CAST IRON 1

3 BUSH PHOSPHOR BRONZE 2

4 AXLE BOLT MILD STEEL 1

5 WASHER MILD STEEL 1

6 M16 X1.5 HEX NUT MED CARBON STEEL 1

Page 1 of 2
H

A/F= 1.5D, THICKNESS = 0.8D


Fig. Q 1

Page 2 of 2

You might also like