This document provides pinout information for a VAG Group 1.4 1.6 16v ME7.5.20 engine control unit. It lists pins 4, 9, 15, 26, and 51 as supplying +12V power, pin 2 and 28 as ground, and pin 29 as the K-LINE data connection. It describes how to connect a 680 ohm resistor between the enable pins, and connects the bootstrap pin 5 to the blue banana terminal on a diagnostic tool via a cable and contact point to read and write to the ECU.
This document provides pinout information for a VAG Group 1.4 1.6 16v ME7.5.20 engine control unit. It lists pins 4, 9, 15, 26, and 51 as supplying +12V power, pin 2 and 28 as ground, and pin 29 as the K-LINE data connection. It describes how to connect a 680 ohm resistor between the enable pins, and connects the bootstrap pin 5 to the blue banana terminal on a diagnostic tool via a cable and contact point to read and write to the ECU.
This document provides pinout information for a VAG Group 1.4 1.6 16v ME7.5.20 engine control unit. It lists pins 4, 9, 15, 26, and 51 as supplying +12V power, pin 2 and 28 as ground, and pin 29 as the K-LINE data connection. It describes how to connect a 680 ohm resistor between the enable pins, and connects the bootstrap pin 5 to the blue banana terminal on a diagnostic tool via a cable and contact point to read and write to the ECU.
This document provides pinout information for a VAG Group 1.4 1.6 16v ME7.5.20 engine control unit. It lists pins 4, 9, 15, 26, and 51 as supplying +12V power, pin 2 and 28 as ground, and pin 29 as the K-LINE data connection. It describes how to connect a 680 ohm resistor between the enable pins, and connects the bootstrap pin 5 to the blue banana terminal on a diagnostic tool via a cable and contact point to read and write to the ECU.
For the enable pin you have to connect a resistor (680Ω) between the pins like in the picture.
The Pin 5 is the Bootstrap’s Pin and you have to connect it to Serial Suite’s blue banana through the appropriate cable and the metal point. Holding connect the metal point for some second and during the connection time it will be able the read and write of ECU.
