mob: +92 323 509 4443, email: megalecture@gmail.

com

Physics (Alternative to Practical) 62 Tuesday

Just study all 5 Topics of physics:

General Physics
Thermal Physics
Waves

m
co
Magnetism

e.
Atomic Physics
ur
ct
le
ga
me
w.
ww

www.youtube.com/megalecture Page 1 of 13
 mob: +92 323 509 4443, email: [email protected]

And you'll do fine For paper 6 learn all the 5 topics

experiments precautions.

Physics laboratory safety precautions / rules:

* Live wires should not be touched.

* Hot Objects should not be touched with barren hands instead

of that gloves should be used the most common process is
heating of water in thermodynamic experiments.

* Circuit connections should be checked and approved by the

teacher and then only the circuit should be switched ON.

* While changing components of the circuit the power should

be switched so that one should not experience electric shocks.

* Safety spectacles, gloves and other safety components should

be used while handling experiments.

www.youtube.com/megalecture Page 2 of 13
 mob: +92 323 509 4443, email: [email protected]

* While handling a mercury thermometer one should take of

the mercury spills.

* No other laboratory instruments should be touched or

handled which is not involved in the course of experiments.

micrometer : can measure the thickness of any small thing to

m
co
0.01 mm

e.
vernier : can measure the inner and outer wall of anything to
1.05mm
ur
ct

Control Variables
le

Precautions
ga

Units ( eg.. voltage is V etc. ) cause the units hold 1 mark of the
me

question
w.

Statements & justification

ww

The rest are calculations and measurements

To produce more accurate or reliable results:
• Repeat experiment, to calculate average reading.
• Avoiding parallax error, look perpendicular to the ruler.

www.youtube.com/megalecture Page 3 of 13
 mob: +92 323 509 4443, email: [email protected]

• If accuracy in measurement was asked, check for zero

error.
Improvements that could be done to the experiment (temp.
cooling):
• Same initial temperature.
• Same volume of water.
• Same shape of beaker.
• Beakers of same surface.
• Same room temperature.
• Stirring the water in the beakers.
• Same time intervals.
• Same surface area. (Unless given different containers)
• Adding water or cooling effect at regular intervals.
Heat loss could be reduced by:
• Insulation of beaker.
• Covering beaker with a lid.
For 2 values to be directly proportional,
• The graph of the values must be a straight line from the
origin.

www.youtube.com/megalecture Page 4 of 13
 mob: +92 323 509 4443, email: [email protected]

• As value 1 increase, value 2 increases.

For images produced from lenses on screens, precautions

taken:
• Use of a darkened room for the experiment.
• Avoiding parallax error in measurement, and look
perpendicular to the ruler.

m
co
• Object and lens at the same height from bench.

e.
• Object/lens/screen is perpendicular to the bench.
ur
To draw an image created from lens:
ct
le

• Inverted from the original object.

ga

• Sides are multiplied by the magnification.

me

*If values have difference by 0.1 or 0.01, that is the limit of

w.

experimental accuracy, so answers are about the same.

ww

For spring extension experiment, variables that should be

constant in the experiment:
• Number of coils.
• Diameter of spring.
• Selection of loads.

www.youtube.com/megalecture Page 5 of 13
 mob: +92 323 509 4443, email: [email protected]

• Mass of spring.
http://www.opamp-
electronics.com/tutorials/experiments_ch_003.htm

micrometer : can measure the thickness of any small thing to

0.01 mm
vernier : can measure the inner and outer wall of anything to
1.05mm
Control Variables
Precautions
Units ( eg.. voltage is V etc. ) cause the units hold 1 mark of the
question
Statements & justification
The rest are calculations and measurements
To produce more accurate or reliable results:
• Repeat experiment, to calculate average reading.
• Avoiding parallax error, look perpendicular to the ruler.
• If accuracy in measurement was asked, check for zero error.
Improvements that could be done to the experiment (temp.
cooling):

www.youtube.com/megalecture Page 6 of 13
 mob: +92 323 509 4443, email: [email protected]

• Same initial temperature.

• Same volume of water.
• Same shape of beaker.
• Beakers of same surface.

• Same room temperature.

m
co
• Stirring the water in the beakers.

e.
• Same time intervals.
ur
• Same surface area. (Unless given different containers)
ct

• Adding water or cooling effect at regular intervals.

le

Heat loss could be reduced by:

ga
me

• Insulation of beaker.
w.

• Covering beaker with a lid.

ww

For 2 values to be directly proportional,

• The graph of the values must be a straight line from the
origin.
• As value 1 increase, value 2 increases.
For images produced from lenses on screens, precautions
taken:

www.youtube.com/megalecture Page 7 of 13
 mob: +92 323 509 4443, email: [email protected]

• Use of a darkened room for the experiment.

• Avoiding parallax error in measurement, and look
perpendicular to the ruler.
• Object and lens at the same height from bench.
• Object/lens/screen is perpendicular to the bench.
To draw an image created from lens:
• Inverted from the original object.
• Sides are multiplied by the magnification.
*If values have difference by 0.1 or 0.01, that is the limit of
experimental accuracy, so answers are about the same.
For spring extension experiment, variables that should be
constant in the experiment:
• Number of coils.
• Diameter of spring.
• Selection of loads.
• Mass of spring.
for improving the accuracy of the results (for experiments):
Minimizing heating effect of a current:
• Lower current

www.youtube.com/megalecture Page 8 of 13
 mob: +92 323 509 4443, email: [email protected]

• Increase voltage
• Add a lamp
• Increase resistance of a resistor
To increase accuracy of ray diagrams
• View bases of pins since pins may not be vertical
• Keep pins further apart

m
co
• Use more pins

e.
• Avoid parallax, explain action and reason
ur
• Repeats and average
ct

Adjustments made to experiments will be made to increase

le

accuracy
ga

Improvement made to experiments about heating effect and

me

insulation
w.

• Lids
ww

• Repeats
• Stirring
• Record max. Temperature
• Add insulation
• Keep constant room temperature

www.youtube.com/megalecture Page 9 of 13
 mob: +92 323 509 4443, email: [email protected]

• Avoid heat loss

How to check if a rule is vertical:
• Protractor
• Use of set square
• Plumb line
• Spirit Level
Precautions taken in experiments about formation of images by
a lens
• Use a darkened area
• Meter ruler on bench or clamped
• Object and lens same height on bench
• Mark on lens holder to show center of lens
• Take more readings
• Avoid parallax error, explain action and reason
• Lens\screen perpendicular to bench
Variables in experiments about springs and stretching effect:
• Number of coils
• Length of spring
• Diameter\thickness of spring or wire

www.youtube.com/megalecture Page 10 of 13
 mob: +92 323 509 4443, email: [email protected]

• Range of loads
• Length of wire
• Coil spring
Periodic time (T) is measured by timing a number (n) of
oscillations, then divide the time taken for all the oscillations by
the number of oscillations (n)

m
co
e.
Drawing graphs: ur
• Label axis
ct
le

• Choose a proper scale

ga

• Well judged best fit line

me

• Thin and neat lines

w.

Measuring the gradient:

ww

• Draw a triangle on graph

• Use clear lines
• Triangle must be larger than half the line
Sources of error in calculating circumference by string method:
• Parallax

www.youtube.com/megalecture Page 11 of 13
 mob: +92 323 509 4443, email: [email protected]

• Diagonal winding
• Thickness of string
Improvement made to calculating circumference by string
method
• Avoid parallax error
• Repeats and average
• Thinner string
• Parallel winding of springs
It's not the BEST list in the world, but hopefully it will help...
Control Variables
Precautions
Units ( eg.. voltage is V etc. ) cause the units hold 1 mark of the
question
Statements & justification
The rest are calculations and measurements which are easy..
they provide the equation in the question

www.youtube.com/megalecture Page 12 of 13
 mob: +92 323 509 4443, email: [email protected]

Paper 6 is one of the easiest

Just memorise the variables.. precautions.. & units
Other then that .. use a sharp pencil when drawing graphs
cause you may lose marks for the thickness of the lines
Be so accurate in measuring angles..

m
co
e.
ur
ct
le
ga
me
w.
ww

www.youtube.com/megalecture Page 13 of 13