Sikacrete 08 SCC Id - Pds en

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

PRODUCT DATA SHEET

Sikacrete®-08 SCC ID
SELF-COMPACTING CONCRETE (SCC)

DESCRIPTION CHARACTERISTICS / ADVANTAGES


Sikacrete®-08 SCC ID is a ready to use cement based The following advantages can be achieved by using
fine concrete. Sikacrete®-08 SCC ID:
▪ No vibration required
USES ▪ Fast placing due to high flow characteristics
▪ Economical concreting
Fields of application are: ▪ Good high quality surface finish
▪ Any small concreting work
▪ Concrete repair work
▪ Domestic concreting work i.e. in gardens and house-
holds
▪ Filling of voids and cavities etc. in concrete

PRODUCT INFORMATION
Packaging 35 kg set
Part A: 25 kg (powder)
Part B: 10 kg (Aggregate)
Appearance / Colour Ready to use dry cement based concrete with an aggregate / Grey.
Shelf life 9 months from date of production if stored properly in undamaged un-
opened, original sealed packaging.
Storage conditions Store properly in dry conditions at temperatures between +18 °C and +35
°C. Protect from moisture, direct sunlight and frost.
Density ~2.28 kg / L
Maximum Grain Size 10 mm

TECHNICAL INFORMATION
Compressive Strength 50 N / mm² (cube 15 x 15 x 15, after 28 days)

APPLICATION INFORMATION
Mixing Ratio 3.5 to 4.2 L of water per 35 kg set dependent on the desired flow
Yield 35 kg of dry mix yields approx. 15 L of concrete
Pot Life 30 min (at +30° C)

Product Data Sheet


Sikacrete®-08 SCC ID
June 2019, Version 02.01
020201010060000035

1/2
Setting Time 6-9h

APPLICATION INSTRUCTIONS ECOLOGY, HEALTH AND SAFETY


MIXING For information and advice on the safe handling, stor-
age and disposal of chemical products, users shall refer
Using Pan mixer : to the most recent Safety Data Sheet (SDS) containing
Mix dry concrete for a few seconds, then add mixing physical, ecological, toxicological and other safety-re-
water. Mix with low-speed for 3 minutes. lated data.
Using Hand mixer :
Put appropriate quantity of water (depend on the de- LEGAL NOTES
sired flow)into a mixing vessel. Add slowly the total
content mortar of Sikacrete®-08 SCC ID while mixing. The information, and, in particular, the recommenda-
Mix continuously for 2 minutes, then add the aggreg- tions relating to the application and end-use of Sika
ate. Add mixing time 1 more minutes. Use a mechanic- products, are given in good faith based on Sika's cur-
ally low speed drill (400–600 rpm) with mixing paddle. rent knowledge and experience of the products when
properly stored, handled and applied under normal
CURING TREATMENT conditions in accordance with Sika's recommenda-
After pouring, need wet cure for a minimum 3 days tions. In practice, the differences in materials, sub-
with wet hessian, plastic sheet or apply a curing strates and actual site conditions are such that no war-
compound (Antisol). ranty in respect of merchantability or of fitness for a
particular purpose, nor any liability arising out of any
CLEANING OF EQUIPMENT legal relationship whatsoever, can be inferred either
from this information, or from any written recom-
Clean all tools and application equipment with water mendations, or from any other advice offered. The
immediately after use. user of the product must test the product’s suitability
Hardened / cured material can only be removed mech- for the intended application and purpose. Sika re-
anically. serves the right to change the properties of its
products. The proprietary rights of third parties must
BASIS OF PRODUCT DATA be observed. All orders are accepted subject to our
current terms of sale and delivery. Users must always
All technical data stated in this Data Sheet are based refer to the most recent issue of the local Product Data
on laboratory tests. Actual measured data may vary Sheet for the product concerned, copies of which will
due to circumstances beyond our control. be supplied on request.

LOCAL RESTRICTIONS
Note that as a result of specific local regulations the
declared data and recommended uses for this product
may vary from country to country. Consult the local
Product Data Sheet for the exact product data and
uses.

PT. Sika Indonesia Head Office and


Jl. Raya Cibinong-Bekasi Km.20
Limusnunggal-Cileungsi
Bogor 16820-Indonesia
Tel. +62 21 8230025, Fax +62 21 8230026
Web: idn.sika.com
Email: [email protected]

Sikacrete-08SCCID-en-ID-(06-2019)-2-1.pdf

Product Data Sheet


Sikacrete®-08 SCC ID
June 2019, Version 02.01
020201010060000035

2/2

You might also like