Acc PDF

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

ACCELERATOR CONTROL SYSTEM

B ENGINE

ACC
SECTION
ACCELERATOR CONTROL SYSTEM C

E
CONTENTS
ACCELERATOR CONTROL SYSTEM ...................... 2 SERVICE DATA AND SPECIFICATIONS (SDS) ........ 3 F
Removal and Installation .......................................... 2 Tightening Torque ..................................................... 3
REMOVAL ............................................................. 2
INSTALLATION ..................................................... 2 G
INSPECTION AFTER INSTALLATION ................. 2

ACC-1
ACCELERATOR CONTROL SYSTEM

ACCELERATOR CONTROL SYSTEM PFP:18005

Removal and Installation EBS00KP5

PBIC2412E

1. Accelerator pedal assembly

REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Loosen nuts, and remove accelerator pedal assembly.
CAUTION:
● Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sen-
sor from accelerator pedal assembly.
● Avoid impact from dropping etc. during handling.

● Be careful to keep accelerator pedal assembly away from water.

● Do not adjust adjusting screw (painted white).

INSTALLATION
Install in the reverse order of removal.
INSPECTION AFTER INSTALLATION
● Make sure that accelerator pedal moves smoothly within the whole operation range.
● Make sure that accelerator pedal securely returns to the original position.
● For the electrical inspection of accelerator pedal position sensor, refer to EC-386, "DTC P2122, P2123
APP SENSOR" , EC-393, "DTC P2127, P2128 APP SENSOR" , EC-409, "DTC P2138 APP SENSOR"
[QR (WITH EURO-OBD)], EC-740, "DTC P2122, P2123 APP SENSOR" , EC-747, "DTC P2127, P2128
APP SENSOR" , EC-763, "DTC P2138 APP SENSOR" [QR (WITHOUT EURO-OBD)] or EC-987, "DTC
P0122, P0123 APP SENSOR" , EC-1025, "DTC P0222, P0223 APP SENSOR" , EC-1149, "DTC P2135
APP SENSOR" [YD (WITH EURO-OBD)], EC-1297, "DTC P0122, P0123 APP SENSOR" , EC-1332,
"DTC P0222, P0223 APP SENSOR" , EC-1437, "DTC P2135 APP SENSOR" [YD (WITHOUT EURO-
OBD)].
CAUTION:
When the harness connector of the accelerator pedal position sensor is disconnected, perform
“Accelerator Pedal Released Position Learning”. (QR20DE and QR25DE) Refer to EC-45, "Acceler-
ator Pedal Released Position Learning" (WITH EURO-OBD) or EC-507, "Accelerator Pedal
Released Position Learning" (WITHOUT EURO-OBD).
NOTE:
In the case of YD22DDTi, it is unnecessary to perform “Accelerator Pedal Released Position Learning”
even when disconnecting the harness connector of the accelerator pedal position sensor.

ACC-2
SERVICE DATA AND SPECIFICATIONS (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS) PFP:00030


A
Tightening Torque EBS00KP6

Unit: N·m (kg-m, in-lb)


Accelerator pedal assembly 5.1 (0.52, 45) ACC

ACC-3
SERVICE DATA AND SPECIFICATIONS (SDS)

ACC-4

You might also like