Scribd
Upload
227 views2 pages

Load Cell

This document summarizes the testing of a load cell for a client. It includes information about the client, product details, and results of a visual inspection and electrical inspection of the load cell. The inspections checked for damage, corrosion, proper connections and readings. No failures were found, as the load cell passed all inspection points.

Uploaded by

Anonymous yCpjZF1rF
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
227 views2 pages

Load Cell

This document summarizes the testing of a load cell for a client. It includes information about the client, product details, and results of a visual inspection and electrical inspection of the load cell. The inspections checked for damage, corrosion, proper connections and readings. No failures were found, as the load cell passed all inspection points.

Uploaded by

Anonymous yCpjZF1rF
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Client Date of testing :

End User
Contact
Address
City / Country
PO reference no.
Product description
Serial number
System failure

Results
Visual inspection points
Review Load Cell data sheet for specifications and tolerances  NOK  OK
Review Load cell calibration certificate  NOK  OK
Type and serial number visible (label sticker and/or engraved)  NOK  OK
Check for force shunts (might be caused by dirt, mechanical misalignment or  NOK  OK
accompanying components such as stay- or check rods).
Check for damage, corrosion or significant wear in the areas of load introduction  NOK  OK
Check cable connections to junction box and indicator  NOK  OK
Signs of corrosion (especially around the critical gauge area)  NOK  OK
Integrity of the cable (might be compromised due to cuts, abrasions, etc) and the  NOK  OK
condition of the cable entry
Remarks Visual inspection:

Load Cell Measurement Record


S. No. Reference load Actual Measured reading Remarks
cell reading Load cell 1 Load cell 2 Load cell 3
Electrical inspection
Hoist measurements Actual Results
Zero Balance mV/V  NOK  OK
 NOK  OK
 NOK  OK
 NOK  OK
 NOK  OK
 NOK  OK
 NOK  OK
Remarks electrical inspection:

Conclusion
 Mechanical overload  Broken connector  Short circuit
 Broken wire  Moisture ingress  Electrical transients
 Broken component  Excessive corrosion  No failure found
 Broken cable  Excessive heat  Other:
Recommendations
Inspected by: Approved by:
Name Name
Signature Signature
Stamp Stamp

You might also like