steel series

DOMESTIC/RESIDENTIAL
water solutions
Operating specifications Construction materials
Max operating temperature 40°C [90°C max 3 min] Case Stainless steel - AISI 304
pH of treated fluid 6 ÷ 14 Impeller Stainless steel - AISI 304
Viscosity of treated fluid 1 mm /s2
Mechanical seal SiC-Al
Maximum immersion depth 10 m Nuts and bolts Stainless steel - Class A2-70
Density of treated fluid 1 Kg/dm3 Standard gasket Rubber - NBR
Maximum acoustic pressure <70 dB Shaft Stainless steel - AISI 431
Max starts per hour 30 Cable (external casing) Neoprene

The cooling jacket ensures an optimal motor

temperature even with the pump only partially
submerged.
3

The digital version of this catalogue is available for download at: www.zenit.com
5

The vertical travel level switch is available

for installation in small pits.

6
7

2 Large oil chamber guarantees long

mechanical seal lifetime.
series

The Technical Data Booklet complete with duty curves

is available for download in the download area of
The data provided are not binding.
zenit.com
Zenit reserves the right to modify any product without notice.
To select the pump best suited to your needs ELECTRICAL SUBMERSIBLE PUMPS
Cod. 29040060600400011
we advise you to use the Zeno Pump Selector
Rev. 0 - 01/02/2018
FOR DOMESTIC DRAINAGE AND LIFTING
configuration tool on the zenit.com website For further information, visit www.zenit.com

EN
 steel series steel series steel series

steel series DG steel DR steel

High-performance, compact stainless steel submersible pumps for opti- Stainless steel vortex impeller Stainless steel multi-channel open impeller
mal service in household installations and small civil plants.
The steel series is a range of lightweight and handy stainless steel submersible pumps with
single and three-phase motors from 0.25 to 0.75 kW with two types of hydraulics:
• Vortex impeller (DG steel) for use with charged water and in the presence of solid bodies
• Open multichannel impeller (DR steel) for use with light or low water

• Sewage • Clear or slightly soiled wastewaters

• Soiled wastewaters with solids • Strained, seepage and underground pump-out waters
• Lifting stations in civil and residential plants • Garden sprinklers and pumping from tanks

Range characteristics

1 Handle Performances
In AISI 304 stainless steel with ergonomic, insulating techno-polymer coating.

H [m] H [m]
2 Adjustable float switch 10
Float switch stroke adjustment system for modification of start-stop levels. 15

3 Cable gland
Cable gland system with dual safety device to prevent disconnection even in case 6 10
of accidental pulling.

4 Capacitor/relay 4

Single-phase models have internal capacitor. 5 The DR steel

Three-phase models have relay for float-switch control of start/stop cycles. 2
easily converts from an ordinary
submersible pump to a dry floor unit.
5 Thermal protection When operating in this mode, the
Dry motor protection with thermal overload. Free passage up to 40 mm. 0 0
suction level can be reduced to as little as 5 mm
0 50 100 150 200 250 300 350 400 Q [l/min] 0 50 100 150 200 250 300 350 400 Q [l/min]
above the ground.
Q [m /h] Q [m3/h]
6 Drive shaft
3
0 5 10 15 20 0 5 10 15 20

Integral drive shaft in AISI 431 stainless steel for high strength and to allow use with
brine or chlorine.

7 Mechanical seal
SiC-Al mechanical seal in wide oil chamber Technical data
V-Ring in direct contact with the liquid

Free V/~ P2 [kW] A Rpm Ø Free

V/~ P2 [kW] A Rpm Ø
passage passage

Applications DG steel 37/2 M50 230/1 50 0.37 3.0 2900 G 1¼” 25 mm DR steel 25/2 M50 230/1 50 0.25 2.3 2900 G 1¼” 10 mm
DG steel 55/2 M50 230/1 50 0.55 4.3 2900 G 1½” 40 mm DR steel 37/2 M50 230/1 50 0.37 3.1 2900 G 1¼” 10 mm
Steel models can be used in emergencies for pumping-out flooding pre- DG steel 75/2 M50 230/1 50 0.75 5.6 2900 G 1½” 40 mm DR steel 55/2 M50 230/1 50 0.55 4.3 2900 G 1½” 12 mm
mises or for pumping from wells and tanks.
DG steel 75/2 T50 400/3 50 0.75 2.4 2900 G 1½” 40 mm DR steel 75/2 M50 230/1 50 0.75 5.6 2900 G 1½” 12 mm
DR steel 75/2 T50 400/3 50 0.75 2.4 2900 G 1½” 12 mm

What's more, the DR steel version also D

Dimensions
D
provides an excellent lifting station installed
inside the nanoBOX tank for the collection A
and transfer of domestic wastewaters. A B C D A B C D
A

DG steel 37/2 M50 170 20 350 G 1¼” 6.6 DR steel 25/2 M50 170 10 300 G 1¼” 5.9

C
DG  steel 55/2 M50 170 40 400 G 1½” 8.1 DR steel 37/2 M50 170 10 300 G 1¼” 6.3

DG steel 75/2 M50 210 40 400 G 1½” 8.9 DR steel 55/2 M50 215 12 335 G 1½” 7.7
The steel models are used in the emergency kit that
allows an immediate intervention in case of flooding DG steel 75/2 T50 210 40 400 G 1½” 8.9 DR steel 75/2 M[T]50 215 12 335 G 1½” 8.4
of basements. B B

ZENIT.COM