Scribd
Upload
150 views14 pages

FLOWCHART

The document describes a flowchart for transient stability analysis: 1. It begins by reading in the system data and performing a load flow analysis. 2. It then computes the generator angles and speeds at time 0 and forms the reduced Ybus matrix for the pre-fault and post-fault systems. 3. It then enters a time stepping loop where it calculates the generator angles and speeds at intervals of 0.01 seconds until the time reaches the critical clearing time, printing the results and plotting the swing curves.

Uploaded by

Lakshmi Zahara
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
150 views14 pages

FLOWCHART

The document describes a flowchart for transient stability analysis: 1. It begins by reading in the system data and performing a load flow analysis. 2. It then computes the generator angles and speeds at time 0 and forms the reduced Ybus matrix for the pre-fault and post-fault systems. 3. It then enters a time stepping loop where it calculates the generator angles and speeds at intervals of 0.01 seconds until the time reaches the critical clearing time, printing the results and plotting the swing curves.

Uploaded by

Lakshmi Zahara
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 14

Flowchart

Read Data: , , k=1,2 …N k=1,2,…NP

, , where , tolerance

Set Flat Start ;

Compute Mismatch Vector C,

Yes
Is

No

Compute Line Flow Line Losses


Compute Jacobian matrix
and Slack bus power
Compute Voltage Correction

Print Solution

Update state vector Stop

Set

Q limit check for P-V BUs

B
Q Limit Check for P-V bus

Compute

Set

Do

Yes
Is

No

Yes
Is

No
Switch bus k to P-Q bus

Switch bus k to P-Q bus Is bus k is at P-Q bus status


switch back to P-V bus status
change Change

Change

Set

B
Q Limit Check for P-V bus
Read Data: Assume “Flat start” for ; ;

Compute: . Factorize and compute sensitivity


factors

Compute mismatch vector

Is Ye
s

No

Compute and update

No Yes

Compute mismatch vector

Is Ye
s

No

Compute and update

No Yes

B
A Converged.Compu
PV bus adjustment & Print solution

10
Simulation:
OUTPUT:
Simulation of single phase inverter:
Output:
Simulation of three phase inverter:
OUTPUT:
Flowchart for transient stability analysis

START

READ THE DATA

PERFROM LOAD FLOW ANALYSIS

COMPUTE E AND δ GENERATOR

COMPUTE REDUCED YBUS.FOR FROMULATED SYSTEM AND POST FALUT


SYSTEM

t=0.01

CALCULATE 1ST2ND3RD &4TH ESTIMTE OF


ANGLE AND SPEED

FIND δ(t) AND ω(t)AT THE END OF INTREVAL

NO
t=t+ IS t|< tC

YES

FIND δ(t) AND ω(t)AT THE END OF INTREVAL

PRINTALL THE RESULTS AND

PLOT THE CURVE

STOP
SWING CURVE

SWING CURVE
80

75

70

65
Angle in degres

60

55

50

45

40

35

30
0 0.05 0.1 0.15 0.2 0.25 0.3 0.35
Time in Seconds

You might also like