SEAS#008
SEAS#008
SEAS#008
The final size of the jellyfish is about 15 to 18 inches long, with the head about 5
inches across. The length of the jellyfish is up to you and how you want to make
and arrange the curly cues. I did notice that after some hard playing, my son’s
jellyfish’s curly cues loosened and lengthened a bit.
Just one piece of advice/warning. If you are making this for small children,
PLEASE supervise their play. These are long curly cues, and God forbid it
becomes a strangulation hazard. This pattern was not designed to be
dangerous, but, well, kids. So, be careful if they’re flinging it around, and
especially don’t let kids sleep with their jellyfish friends. Maybe it is safer to
let them hang out in the bathroom as a cute little towel.
SUPPLIES
G (4 mm) hook (Clover Amour Hook*)
Note: I used a G hook for the head of the jellyfish, but
tried both a G hook (blue jellyfish) and an H hook (purple
jellyfish) for the curly cues.
Yarnspirations Bernat Handicrafter Cotton Yarn: main color – 2
skeins, secondary color – 1 skein
The Blue jellyfish is Robin’s Egg Blue and Mod Blue. The
Purple jellyfish is Soft Violet and Hot Pink.
9mm safety eyes
Black DMC embroidery thread
embroidery needle
scissors
polyester fiberfill
ABBREVIATIONS
sl st – slip stitch
ch – chain stitch
sc – single crochet
hdc – half double crochet
dc – double crochet
sc2tog – single crochet 2 together (joining/decreasing stitch)
Round 2: Ch 1. Work 2 sc into each stitch around. Join with sl st to first sc. (16)
Round 7-8: Ch 1. Work 1 sc into each stitch around. Join with sl st to first sc. (48)
Round 10-14: Ch 1. Work 1 sc into each stitch around. Join with sl st to first sc.
(56)
Round 15: Ch 1. *Work 1 sc into each of next 2 stitches. Work 1 sc2tog, 1 sc into
next stitch, 1 sc2tog.* Repeat around. Join with sl st to first sc. (40)
J E L L Y F I S H B OT T O M P AN E L :
Round 1: Ch 1. Work 8 sc into a magic circle. Join with sl st to first sc. (8)
Round 2: Ch 1. Work 2 sc into each stitch around. Join with sl st to first sc. (16)
Round 5: Ch 3 (does not count as stitch). *Work 1 dc into each of next 3 stitches,
2 dc into next stitch.* Repeat around. Join with sl st to first sc. (40)
Fasten off, but leave a long enough tail to sc around. (Probably a few feet at
least).
J E L L Y F I S H S T R E AM E R S / T E NT AC L E S :
I found the streamers were easiest and most fun when done freeform. All of them
are a little different, but I used the same basics for each one to maintain
consistency. You can check out my curly cue sampler to get an idea of what each
type of curl will look like. Also, you can change up the hook size for a different
look. I used a G hook for the blue jellyfish and an H hook for the purple jellyfish.
On each jellyfish, there are 8 tentacles of varying width and length.
I found it best if you stick with a particular pattern long enough to establish the
right curl, then change it to create a different type curl. Don’t change your stitch
type too quickly. You can curl the curly cues properly or leave it messy, up to you!
AS S E M B L Y
Step 1: Attach the safety eyes between rows 12 and 13 on the cap, about 8
stitches apart.
Step 2: Use the embroidery thread to sew on a mouth halfway between the eyes.
Step 3: Attach the tentacles to the bottom panel by weaving both tails of the
tentacles through stitch spaces in the panel, and tie a double knot to secure. You
can weave the ends in, or maybe not, since it’ll be hidden inside the stuffed head.
I chose to weave in ends because I don’t know how hard the kids will pull on the
tentacles.
Step 4: Match up the seam stitch of the panel against the seam stitch of the cap.
Insert your hook through both loops (front to back) on one stitch on the cap, and
pull through a loop of the panel’s tail. Work a chain stitch. Then insert your hook
through the same cap stitch, and through the first stitch on the panel, pull up a
loop and complete a sc. (It’s ok if you fudge this. You just need to attach the two
pieces together to get started.)
Step 5: For the next stitch and for each stitch around, insert hook from outside of
cap through all 4 loops (cap and panel). Work a sc.
Step 6: Once you’ve gone almost around, stuff the head with fiberfill, then
continue working sc around to close up the head. Join to the first sc with a sl st.
Fasten off and weave in ends.
If you’d like to hang your jellyfish, you can sew on a loop at the top. Otherwise
you’re done!
Remember, be careful playing with the jellyfish and don’t get tangled up!