UAB CRRT Academy 2018 Formulas

CRRT Formulas
BASIC DIALYSIS CONCEPTS

QB = Blood flow rate (ml/min)
QD = Dialysate rate (ml/hr)
QUF = Ultrafiltration rate (ml/hr)
QR = Replacement fluid rate (ml/hr)
QE = Effluent rate (ml/hr)
CRRT DOSE:
Recommended minimal effluent dose is 20-25 ml/kg/hr (target
25-30 ml/kg/hr to take into account downtime)
Dose = Effluent Rate (ml/hr) / Patient Weight (kg)
Effluent Rate (ml/hr) definition per CRRT modality:

 CVVH: Total Ultrafiltration (UF) Rate (ml/hr) = Pre-Filter
Replacement Fluid Rate (ml/hr) + Post-Filter Replacement
Fluid Rate (ml/hr) + Fluid Removal Rate (ml/hr) + Pre-Blood
Pump (PBP) Fluid Rate (ml/hr)*
 CVVHD: Dialysate Rate (ml/hr) + Fluid Removal Rate (ml/hr)
 CVVHDF: Total UF Rate (ml/hr) + Dialysate Rate (ml/hr) = Pre-
Filter Replacement Fluid Rate (ml/hr) + Post-Filter
Replacement Fluid Rate (ml/hr) + Fluid Removal Rate (ml/hr)
+ Pre-Blood Pump (PBP) Fluid Rate (ml/hr)* + Dialysate Rate
(ml/hr)
CRRT DOSE DILUTION FACTOR:
When using Pre-Filter Replacement Fluid and/or Pre-Blood-Pump
(PBP) Fluid, the CRRT dose is diluted and therefore decreased.
CRRT effluent rate is multiplied by the dilution factor and then
divided by patient weight to reflect actual CRRT dose in ml/kg/hr;
this takes into account the dilution effect.
Dilution Factor = Plasma Flow Rate (ml/hr) / [Plasma Flow Rate

(ml/hr) + Pre-Filter Replacement Fluid Rate (ml/hr) + PBP Fluid
Rate (ml/hr)*]
 Plasma Flow Rate (ml/hr) = Blood Flow Rate (ml/min) X 60
(min/hr) X (1-HCT)
CRRT FILTRATION FRACTION (FF):

Filter clotting occurs with FF > 20-25%.
Filtration Fraction (FF) = Total Ultrafiltration Rate / (Plasma Flow

Rate + Pre-Filter Replacement Fluid Rate + Pre-Blood Pump (PBP)
Fluid Rate*)
 Total Ultrafiltration Rate (ml/hr) = Pre-Filter Replacement
Fluid Rate (ml/hr) + Post-Filter Replacement Fluid Rate
(ml/hr) + Fluid Removal Rate (ml/hr) + Pre-Blood Pump (PBP)
Fluid Rate (ml/hr)*
 Plasma Flow Rate (ml/hr) = Blood Flow Rate (ml/min) X 60
(min/hr) X (1-HCT)
 Note: dialysate rate does NOT factor into the FF equation
* For all formulas above, PBP Rate only applies if utilizing with
Prismaflex device
CITRATE TOXICITY
Detection
 Rising anion gap, worsening metabolic acidosis
 Falling systemic iCa2+
 Escalating Ca2+ infusion requirements
 Total Ca2+:Systemic iCa2+ Ratio > 2.5:1 (increased Ca2+ gap)**
**To convert Total Calcium in mg/dL to mmol/L, multiply Total

Calcium by 0.25
DYSNATREMIAS
Hyponatremia
1. Add free water into commercial CRRT solution bag

𝐶𝐶 𝑉𝑉
𝑉𝑉𝑎𝑎𝑎𝑎𝑎𝑎 = 𝐶𝐶𝑖𝑖 𝑖𝑖 - 𝑉𝑉𝑖𝑖
𝑓𝑓
2. Equivolume exchange of fluid with free water (exchange

volume in CRRT solution bag with sterile water)
𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑 [𝑁𝑁𝑁𝑁+ ]
𝑉𝑉𝑉𝑉𝑉𝑉𝑉𝑉𝑉𝑉𝑉𝑉 𝑡𝑡𝑡𝑡 𝑒𝑒𝑒𝑒𝑒𝑒ℎ𝑎𝑎𝑎𝑎𝑎𝑎𝑎𝑎 = 𝑉𝑉𝑖𝑖 − × 𝑉𝑉𝑖𝑖
𝑖𝑖𝑖𝑖𝑖𝑖𝑖𝑖𝑖𝑖𝑖𝑖𝑖𝑖 [𝑁𝑁𝑁𝑁 + ]
3. Use Post filter RF (or add as separate infusion)
D5W can be used as post-filter RF to slowly correct patients who

have hyponatremia:
D5W rate = [(140 - target Na) / 140] x desired clearance.
For example, using post-dilution CVVHDF in a patient with initial

sodium of 120 mEq/L with target sodium concentration of 130
mEq/L at a desired clearance of 3 L/hr using RF/dialysate with
140 mEq/L of sodium, the D5W infusion rate would be [(140 –
130)] / 140] x 3 L = 0.214 L/hr. So the post filter RF would be 210
ml/hr and the dialysate/pre-filter RF should be 2,790 ml/hr (2.79
L/hr + 0.210 L/hr = 3 L/hr)
Hypernatremia
In patients with cerebral edema who need 3% saline to maintain

serum Na concentration in range 150 to 155 mEq/L, 3% saline
can be delivered as the post-filter RF.
3% infusion rate = [(target Na – 140) / (513 – 140)] x desired

clearance.
For example, in a patient with an initial sodium 140 mEq/L with

target sodium concentration of 155 mEq/L at a desired clearance
of 3 L/hr, the 3% saline infusion rate would be [(155-140)/513-
140)] x 3 = 0.120 L/hr or 120 ml/hr. The dialysate/pre-filter RF
should be 2880 ml/hr (2.880 L/hr + 0.120 L/hr = 3 L/hr)
Prediction of Serum Sodium Concentration

−𝐷𝐷𝐷𝐷
𝑁𝑁𝑁𝑁(𝑡𝑡) = 𝑁𝑁𝑁𝑁0 + �𝑁𝑁𝑁𝑁𝑑𝑑𝑑𝑑𝑑𝑑𝑑𝑑 − 𝑁𝑁𝑁𝑁0 � × �1 − 𝑒𝑒 𝑉𝑉 �
D = CRRT effluent dose ml/kg/hr

T = Time (ie 24 hr)
V = Volume of distribution

UAB CRRT Academy 2018 Formulas

Uploaded by

Copyright:

Available Formats

UAB CRRT Academy 2018 Formulas

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

UAB CRRT Academy 2018 Formulas

Uploaded by

Copyright:

Available Formats

CRRT Formulas

BASIC DIALYSIS CONCEPTS

Dose = Effluent Rate (ml/hr) / Patient Weight (kg)

Effluent Rate (ml/hr) definition per CRRT modality:

Dilution Factor = Plasma Flow Rate (ml/hr) / [Plasma Flow Rate

CRRT FILTRATION FRACTION (FF):

Filtration Fraction (FF) = Total Ultrafiltration Rate / (Plasma Flow

**To convert Total Calcium in mg/dL to mmol/L, multiply Total

1. Add free water into commercial CRRT solution bag

2. Equivolume exchange of fluid with free water (exchange

3. Use Post filter RF (or add as separate infusion)

D5W can be used as post-filter RF to slowly correct patients who

For example, using post-dilution CVVHDF in a patient with initial

In patients with cerebral edema who need 3% saline to maintain

3% infusion rate = [(target Na – 140) / (513 – 140)] x desired

For example, in a patient with an initial sodium 140 mEq/L with

Prediction of Serum Sodium Concentration

D = CRRT effluent dose ml/kg/hr

You might also like