Ec303 QP
Ec303 QP
PART A
Answer any two full questions, each carries 15 marks. Mar
ks
1 a) State Ampere’s circuit law. (3 )
b) Derive an expression for magnetic energy of a continuous distribution of current in ( 7)
a volume.
c) Find the potential function and electric field intensity for the region between (5)
concentric right circular cylinders, where V=0 at r=1mm and V=100 V at r=30mm.
PART B
Answer any two full questions, each carries 15 marks.
4 a) What is Snell’s law? ( 3)
b) Derive an expression for reflection coefficient of a plane wave under oblique (5 )
incidence with parallel polarization at a dielectric interface.
c) Define reflection coefficient and VSWR of a transmission line and derive the (7)
relation between reflection coefficient and VSWR.
Page 1 of 2
B E1133 Pages: 2
5 a) Derive an expression for net outward power flow associated with an (10)
electromagnetic wave, from a surface.
b) State phase velocity of a wave (5)
6 a) Draw the circuit of small section of transmission line of length ∆x and label the (3)
circuit parameters
b) Derive the current and voltage equation of a transmission line. (7)
c) A lossless transmission line has primary constant L= 0.01µH/m, C=100pF/m. Find (5)
the characteristic impedance of the line.
PART C
Answer any two full questions, each carries 20 marks.
7 a) What are distributed elements ( 4)
b) Derive the expression for input impedance of a loss less transmission line (8 )
c) A transmission line has primary constants R=0.1Ω/m, G=0.01/m, L=0.01µH/m (8)
and C=100pF/m. Find the characteristic impedance of the line at 2 GHz. Find the
following
i) Reflection coefficient at the load end when it is connected to a load
impedance 10+j20Ω.
ii) The reflection coefficient at a distance of 20cm from load.
8 a) Derive the expressions for Transverse magnetic (TE) mode propagation in a (10)
parallel plane wave guide.
b) A load impedance 90- j 25 is to be matched to 50Ω using single stub matching (10)
find the length and location of stub using smith chart.
9 a) Derive the expressions for TE mode in a rectangular wave guide (10)
b) The longitudinal electric field for TM11 mode is given by (7)
𝐸𝑍 = sin 5𝑥 sin 8𝑦 𝑒 −𝑗𝛽𝑧 𝑉/𝑚 Find the cut off frequency of the mode.
c) The cross section of a rectangular wave guide is 20 cm ˣ5 cm. Find 3 lowest order (3)
mode frequencies
****
Page 2 of 2