Pollination Class 12 Biology Project
Pollination Class 12 Biology Project
Pollination Class 12 Biology Project
SCHOOL
BIOLOGY
PROJECT FILE
SESSION: - 2019-20
SESSION 2017-18
POLLINATION
CERTIFICATE
This is to certify that name of the student, a student
ASHOK SINGH of class 12th has successfully
completed the research on the mentioned project under
the guidance of Subject Teacher MR. POOJA
KUNTAL during the year in partial fulfillment of
Biology practical of session 2019-2020.
ASHOK SINGH
INTRODUCTION
Pollination is the process by which pollen is transferred to the
female reproductive organs of a plant, thereby enabling
fertilization to take place. Like all living organisms, seed
plants have a single major purpose: to pass their genetic
information on to the next generation. The reproductive unit is
the seed, and pollination is an essential step in the production
of seeds in all spermatophytes (seed plants). For the process
of pollination to be successful, a pollen grain produced by the
anther, the male part of a flower, must be transferred to a
stigma, the female part of the flower, of a plant of the same
species. The process is rather different in angiosperms
(flowering plants) from what it is in gymnosperms (other seed
plants). In angiosperms, after the pollen grain has landed on
the stigma, it creates a pollen tube which grows down the
style until it reaches the ovary. Sperm cells from the pollen
grain then move along the pollen tube, enter the egg cell
through the micropyle and fertilise it, resulting in the
production of a seed.
A successful angiosperm pollen grain (gametophyte)
containing the male gametes is transported to the stigma,
where it germinates and its pollen tube grows down the style
to the ovary. Its two gametes travel down the tube to where
the gametophyte(s) containing the female gametes are held
within the carpel. One nucleus fuses with the polar bodies to
produce the endosperm tissues, and the other with the ovule to
produce the embryo. Hence the term: "double fertilization".
In gymnosperms, the ovule is not contained in a carpel, but
exposed on the surface of a dedicated support organ, such as
the scale of a cone, so that the penetration of carpel tissue is
unnecessary. Details of the process vary according to the
division of gymnosperms in question. Two main modes of
fertilization are found in gymnosperms. Cycads and Ginkgo
have motile sperm that swim directly to the egg inside the
ovule, whereas conifers and gnetophytes have sperm that are
unable to swim but are conveyed to the egg along a pollen
tube.
The study of pollination brings together many disciplines,
such as botany, horticulture, entomology, and ecology. The
pollination process as an interaction between flower and
pollen vector was first addressed in the 18th century by
Christian Konrad Sprengel. It is important in horticulture and
agriculture, because fruiting is dependent on fertilization: the
result of pollination. The study of pollination by insects is
known as anthecology.
PROCESS
Pollen germination has three stages; hydration, activation and
pollen tube emergence. The pollen grain is severely
dehydrated so that its mass is reduced enabling it to be more
easily transported from flower to flower. Germination only
takes place after rehydration, ensuring that premature
germination does not take place in the anther. Hydration
allows the plasma membrane of the pollen grain to reform into
its normal bilayer organization providing an effective osmotic
membrane. Activation involves the development of actin
filaments throughout the cytoplasm of the cell, which
eventually become concentrated at the point from which the
pollen tube will emerge. Hydration and activation continue as
the pollen tube begins to grow.[4]
In conifers, the reproductive structures are borne on cones.
The cones are either pollen cones (male) or ovulate cones
(female), but some species are monoecious and others
dioecious. A pollen cone contains hundreds of microsporangia
carried on (or borne on) reproductive structures called
sporophylls. Spore mother cells in the microsporangia divide
by meiosis to form haploid microspores that develop further
by two mitotic divisions into immature male gametophytes
(pollen grains). The four resulting cells consist of a large tube
cell that forms the pollen tube, a generative cell that will
produce two sperm by mitosis, and two prothallial cells that
degenerate. These cells comprise a very reduced
microgametophyte, that is contained within the resistant wall
of the pollen grain.[5][6]
The pollen grains are dispersed by the wind to the female,
ovulate cone that is made up of many overlapping scales
(sporophylls, and thus megasporophylls), each protecting two
ovules, each of which consists of a megasporangium (the
nucellus) wrapped in two layers of tissue, the integument and
the cupule, that were derived from highly modified branches
of ancestral gymnosperms. When a pollen grain lands close
enough to the tip of an ovule, it is drawn in through the
micropyle ( a pore in the integuments covering the tip of the
ovule) often by means of a drop of liquid known as a
pollination drop. The pollen enters a pollen chamber close to
the nucellus, and there it may wait for a year before it
germinates and forms a pollen tube that grows through the
wall of the megasporangium (=nucellus) where fertilisation
takes place. During this time, the megaspore mother cell
divides by meiosis to form four haploid cells, three of which
degenerate. The surviving one develops as a megaspore and
divides repeatedly to form an immature female gametophyte
(egg sac). Two or three archegonia containing an egg then
develop inside the gametophyte. Meanwhile, in the spring of
the second year two sperm cells are produced by mitosis of
the body cell of the male gametophyte. The pollen tube
elongates and pierces and grows through the megasporangium
wall and delivers the sperm cells to the female gametophyte
inside. Fertilisation takes place when the nucleus of one of the
sperm cells enters the egg cell in the megagametophyte’s
archegonium.[6]
In flowering plants, the anthers of the flower produce
microspores by meiosis. These undergo mitosis to form male
gametophytes, each of which contains two haploid cells.
Meanwhile, the ovules produce megaspores by meiosis,
further division of these form the female gametophytes, which
are very strongly reduced, each consisting only of a few cells,
one of which is the egg. When a pollen grain adheres to the
stigma of a carpel it germinates, developing a pollen tube that
grows through the tissues of the style, entering the ovule
through the micropyle. When the tube reaches the egg sac,
two sperm cells pass through it into the female gametophyte
and fertilisation takes place.[5]
POLLEN TUBE GROWTH
FERTILIZATION
TYPES OF POLLINATION
»» Depending on the source of pollen, pollination can be
classified into 2 types –
Self-pollination and Cross Pollination (Xenogamy).
Self Pollination is further divided into Autogamy and
Geitonogamy.
Depending on agent of Pollination, pollination can be
classified into abiotic pollination and biotic pollination.
(1) Anemophily:
Anemophilous plants produce enormous amount of.pollen
grains: A single plant of Mercurialis annually has been
estimated to produce 1,352,000,000 pollen grains.
Anemophilous plants bear small and inconspicuous flower.
The pollen grains are small, light, smooth and dry. Pollen of
some plants are said to be blown to 1,300 km. In some plants
as Pinus, pollen grains are winged.
The flowers are usually unisexual in some plants e.g.
Mulberry is borne in independent catkins which can sway
freely and shake off their pollen in air. The flowers may be
borne on long axis (as in grasses) much above the leaves.
The anther is versatile so as to oscillate in all directions at the
tip of filament. In Urticaceae filaments are very long.
Anempohilous flowers have adequate devices to catch the air-
borne-pollen grains with utmost efficiency. For this the stigma
is usually large and feathery (as in grasses) and brush like as
in Typha.
(2) Hydrophily:
It is of two types:
a) Hypohydrogamy:
(
(b) Epihydrogamy:
Vallisneria spiralis (ribbon weed) is a submerged dioecious
plant. The flowers are borne under water. When mature, the
male flower get detached from the parent plant and float on
the surface of water. The pistillate flowers also develop under
water, at the time of pollination, they are brought to the
surface by their long and slender stalks. As it arrives on the
surface it forms a cuplike depression. If male flowers floating
on water get lodged into the depression, the pollination takes
place. After pollination, the stalk of the pistillate flower
undergoes spiral torsion bringing the pollinated flower under
water once more.
(3) Entomophily:
Some of the insects which help in pollination are bees, flies,
wasps, moths and beetles. Bees, flies and beetles visit flowers
which open after sunset. Bees probably carry out 80% of all
pollination done by insects. Bee pollinated flowers are
coloured, possess special smell and/or produce nectar. Pollen
grains are sticky or with spinous exine. Also the stigma is
sticky and bees are colour blind for red.
(4) Ornithophily:
Tiny birds like humming birds and honey thrushes (hardly 1
inch long) feeds on the nectar of flower like Bignonia,
Erythrina is visited by crows.
(5) Chiropteriphily:
Bauhinia megalandra of Java and Anthocephalus are
pollinated by bats.
(6) Malcophily:
Many aroids which are usually pollinated by Diptera are also
pollinated by snails.
Pollen vectors
Biotic pollen vectors are animals, usually insects, but also
reptiles, birds, mammals, and sundry others, that routinely
transport pollen and play a role in pollination. This is usually
as a result of their activities when visiting plants for feeding,
breeding or shelter. The pollen adheres to the vector's body
parts such as face, legs, mouthparts, hair, feathers, and moist
spots; depending on the particular vector. Such transport is
vital to the pollination of many plant species.
Any kind of animal that often visits or encounters flowers is
likely to be a pollen vector to some extent. For example, a
crab spider that stops at one flower for a time and then moves
on, might carry pollen incidentally, but most pollen vectors of
significant interest are those that routinely visit the flowers for
some functional activity. They might feed on pollen, or plant
organs, or on plant secretions such as nectar, and carry out
acts of pollination on the way. Many plants bear flowers that
favour certain types of pollinator over all others. This need
not always be an effective strategy, because some flowers that
are of such a shape that they favor pollinators that pass by
their anthers and stigmata on the way to the nectar, may get
robbed by ants that are small enough to bypass the normal
channels, or by short-tongued bees that bite through the bases
of deep corolla tubes to extract nectar at the end opposite to
the anthers and stigma. Some pollinator species can show
huge variation in pollination effectiveness because their
ability to carry pollen is impacted by some morphological
trait. This is the case in the white-lined sphinx moth, in which
short-tongued morphs collect pollen on their heads but long-
tongued morphs do not carry any pollen. Some flowers have
specialized mechanisms to trap pollinators to increase
effectiveness. Other flowers will attract pollinators by odor.
For example, bee species such as Euglossa cordata are
attracted to orchids this way, and it has been suggested that
the bees will become intoxicated during these visits to the
orchid flowers, which last up to 90 minutes. However, in
general, plants that rely on pollen vectors tend to be adapted
to their particular type of vector, for example day-pollinated
species tend to be brightly coloured, but if they are pollinated
largely by birds or specialist mammals, they tend to be larger
and have larger nectar rewards than species that are strictly
insect-pollinated. They also tend to spread their rewards over
longer periods, having long flowering seasons; their specialist
pollinators would be likely to starve if the pollination season
were too short.
As for the types of pollinators, reptile pollinators are known,
but they form a minority in most ecological situations. They
are most frequent and most ecologically significant in island
systems, where insect and sometimes also bird populations
may be unstable and less species-rich. Adaptation to a lack of
animal food and of predation pressure, might therefore favour
reptiles becoming more herbivorous and more inclined to feed
on pollen and nectar. Most species of lizards in the families
that seem to be significant in pollination seem to carry pollen
only incidentally, especially the larger species such as
Varanidae and Iguanidae, but especially several species of the
Gekkonidae are active pollinators, and so is at least one
species of the Lacertidae, Podarcis lilfordi, which pollinates
various species, but in particular is the major pollinator of
Euphorbia dendroides on various Mediterranean islands.
Mammals are not generally thought of as pollinators, but
some rodents, bats and marsupials are significant pollinators
and some even specialise in such activities. In South Africa
certain species of Protea (in particular Protea humiflora, P.
amplexicaulis, P. subulifolia, P. decurrens and P. cordata) are
adapted to pollination by rodents (particularly Cape Spiny
Mouse, Acomys subspinosus) and elephant shrews
(Elephantulus species). The flowers are borne near the
ground, are yeasty smelling, not colourful, and sunbirds reject
the nectar with its high xylose content. The mice apparently
can digest the xylose and they eat large quantities of the
pollen. In Australia pollination by flying, gliding and
earthbound mammals has been demonstrated. Examples of
pollen vectors include many species of wasps, that transport
pollen of many plant species, being potential or even efficient
pollinators.