PORTABLE III

System Boards Assembly Spare Part

80286 System Board 000540 107372-001
DISCONTINUED
80286 System Board 000709 107372-001
DISCONTINUED

System Board Jumper Settings (000540 and 000709)

Jumper Settings * Function
E1-1 to E1-2 ** CPU speed 12 or 8 MHz when accessing diskette drive
E1-2 to E1-3 CPU speed 8 MHz when accessing diskette drive
E2 Reserved - No jumper installed
E3-1 to E3-2 ** Serial device COM1
E5-2 to E16-2 IRQ4
E3-2 to E4-2 Serial device COM2
E5-1 to E5-2 IRQ3
E3-1 to E4-1 Modem for COM1
E16-1 to E16-2 IRQ4
E4-1 to E4-2 ** Modem for COM2
E5-1 to E16-1 IRQ3
E7-2 to E7-3 ** Enable parallel interface
E7-1 to E7-2 Disable parallel interface
E8-1 to E8-2 ** Diskette drive primary address
E8-2 to E8-3 Diskette drive secondary address
E8-4 to E8-5 ** Hard Drive primary address
E8-5 to E8-6 Hard Drive secondary address
E10-1 to E10-2 16-KB ROM
E10-2 to E10-3 ** 32-KB ROM
E12-1 to E12-2 Enable ROM set 2
E12-2 to E12-3 ** Disable ROM set 2
E17-2 to E17-3 ** and No extended memory when using the expanded
E17-4 to E17-5 memory board
E17-2 to E17-3 and Address bank 1 (extended memory)
E17-5 to E17-6 (J201 and J202)
E17-1 to E17-2 and Address bank 1 and 2 (extended memory)
E17-4 to E17-5 (J201 through J204)
E17-1 to E17-2 and Address banks 1, 2, and 3 (extended memory)
E17-5 to E17-6 (J201 through J206)
* If another serial device or third-party modem is used, the jumpers for
that device address must be removed.
**Default.
 PORTABLE III
System Board SW1 Switch Settings (000540 and 000709)
1 2 3 4 5 6 7 8 Function
OFF* OFF * 0-640 KB
ON OFF 0-256 KB
OFF ON 0-512 KB
ON ON Reserved
ON* OFF* Select 256 KB X 9 DRAM
module for expansion
memory
OFF ON Select 1 MB X 9 DRAM
module for expansion
memory
OFF OFF Reserved
ON ON Reserved
ON * Enable Hard Drive
OFF Disable Hard Drive
OFF * CPU boot speed 12 MHz
ON CPU boot speed 8 MHz
ON * Plasma display in CGA
mode
OFF Plasma display in
monochrome mode
OFF Reserved
*Default.

Memory Boards Assembly Spare Part

Expanded Memory 000718 107805-001
Memory Expansion - DISCONTINUED 000543 107378-001

Expanded Memory Board (000718)

Jumper Function
E1 1-2 * 256-KB modules installed
E2 1-2 *
E1 2-3 1-MB modules installed
E2 2-3
*Default.

Memory Expansion Board (000543)

Jumper Function
1-2 * 256-KB modules installed
2-3 1-MB modules installed
*Default.

Memory Modules Spare Part

256 X 9 SIMM - DISCONTINUED 107380-001
1 MB X 9 SIMM - DISCONTINUED 107379-001
 PORTABLE III
Video Boards Assembly Spare Part
Enhanced Color Graphic Board * *** 000410 Not Available
Enhanced Color Graphic Board * *** 000471 109196-001
Plasma Display Controller Board 000392 107374-001
Plasma Display Controller Board *** 000932 107374-001
Video Graphics Ctrlr. Board (VGC) * ** *** 000806 109253-001
DISCONTINUED
Video Graphics Ctrlr. Board (VGC) * ** *** 001241 109253-001
DISCONTINUED
Video Graphics Ctrlr. Board (VGC) * ** *** 109360 109253-001
DISCONTINUED
Advanced Graphics 1024 Board ** *** 109958 114201-001
Advanced Graphics Memory Board ** 109959 114202-001
QVision 1280/I Controller Board *** 002951 139182-001
* ECG and VGC require system ROM K or later.
** Installed in Expansion Unit only. The VGC Board is required for the Advanced
Graphics Color Monitor to display both normal VGA and high-resolution video
(single-monitor configuration).
*** See Volume 2 Appendix, Multiproduct Boards, for settings.

Plasma Display Controller Board (000392)

Jumper E1 Function
1-2* Primary Address 3XXX
2-3 Secondary Address 2XXX
*Default..

Hard Drives
Inter- Inte-
Size Type leave grated Min ROM Spare Part
20 MB 2 1:1 Y K Not Available
20 MB 2 3:1 Y K Not Available
40 MB 17 3:1 Y K Not Available
40 MB3 224 1:1 Y R.2 Not Available
40 MB3 43 1:1 Y F Not Available
84 MB3 27 1:1 Y K Not Available
100 MB3 45 1:1 Y K 142365-0011
120 MB3, 5 45 1:1 Y K 161832-0012
1 2
Except Europe. Europe only.
3
Requires MS-DOS 3.2 or later.
4 5
Drive type 17 if ROM earlier than R.2 is used. Formats to 100 MB.

Tape Drives Spare Part Tape Cartridge Spare Part

40 MB * 107785-001 40 MB (DC2000) 108142-001
* Used in Expansion Unit only.

Diskette Drives Spare Part

360 KB - DISCONTINUED 107360-001
1.2 MB - DISCONTINUED 107359-001
1.44 MB - DISCONTINUED 109595-001
* Requires system ROM N.2 or later for use with MS-DOS and system ROM P.2
or later for use with MS OS/2 Version 1.1. Requires MS-DOS Version 3.31.
 PORTABLE III
Miscellaneous Assembly Spare Part
2400 Baud Internal Modem DISCONTINUED 107791-001
Serial/Parallel Interface Board ** 000570 106886-001
000990
16-Bit Memory/Modem 000549 107375-001
DISCONTINUED
16-Bit Memory/Modem 000755 107375-001
DISCONTINUED
Second Serial Board * 000715 107871-001 *
1200 Baud Internal Modem 107041 107376-001
* Not available for use in the U.S. and Canada.
** See Volume 2 Appendix, Multiproduct Boards, for settings.

Cables Used With Spare Part

Mass Storage Power Cable Hard Drive (Drive C) 101741-001 (6-inch)
Mass Storage Power Cable Hard Drive (Drive D) and 101741-004 (15-
All Diskette Drives inch)
Hard Drive Signal Cable All Hard Drives 107176-001
Diskette Signal Cable All Diskette Drives (Single) 107177-001
Diskette Signal Cable All Diskette Drives (Dual) 107177-002
Display Data Cable Display 107171-001
Display Controller Cable Display 107173-001
Display Intensity Cable Display 107174-001
Display Power Cable Display 107175-001
RGB Port Cable Display 107172-001
Modem Jack Cable Modem (RJ11 to RJ11) 107518-001
Cable Kit All 107382-001
VGA Pass-Through Cable Advanced Graphics 114229-001

Processor Location (80286-12) Coprocessor Location (80287-8)

U52 U43

System ROM Locations

U72 ODD U89 EVEN

System ROM Revisions (Spare Part 107592-001)

Revision Number on ODD ROM Number on EVEN ROM Size
K 106778-002 106779-002 16 KB
N.2 107824-001 107825-001 32 KB
P.2 109737-001 109738-001 32 KB
R.2 109737-002 109738-002 32 KB

Power Supply/Battery Spare Part

Power Supply 107373-001 - DISCONTINUED
Battery - DISCONTINUED 107385-001 (For System Board 000709-001)
Battery/Clock Module 107872-001 (For System Board 000709-003)
 PORTABLE III

MEMORY UPGRADE CHART