Refractive Index of Kerocene Oil

REFRACTIVE
INDEX OF
KEROSENE OIL.
Arunesh Venkatesan
XII F
KNMS
6, Maris Ave 3rd St,

Cantonment, Tiruchirappalli,
Tamil Nadu 620001
2019-2020
CONTENTS:
1. AIM
2. APPARATUS REQIURED
3. THEORY
4. PROCEDURE
5. OBSERVATION
6. BIBLIOGRAPGY
7. CONCLUTION
AIM:
To find refractive index of the given liquid samples and find Molar refraction
and specific refraction.
APPARATUS:
Abbe’s refractometer, temperature controller, light source and samples.
THEORY:
Abbe’s Refractometer: The Abbe instrument is the most convenient and
widely used refractometer; Fig (2) shows a schematic diagram of its optical
system. The sample is contained as a thin layer (~0.1mm) between two
prisms. The upper prism is firmly mounted on a bearing that allows its
rotation by means of the side arm shown in dotted lines. The lower prism is
hinged to the upper to permit separation for cleaning and for introduction of
the sample. The lower prism face is rough-ground: when light is reflected into
the prism, this surface effectively becomes the source for an infinite number of
rays that pass through the sample at all angels. The radiation is refracted at
the interface of the sample and the smooth-ground face of the upper
prism. After this it passes into the fixed telescope. Two Amici prisms that
can be rotated with respect to another serve to collect the divergent
critical angle rays of different colours into a single white beam, that
corresponds in path to that of the sodium D ray. The eyepiece of the
telescope is provided with crosshairs: in making a measurement, the prism
angle is changed until the light-dark interface just coincides with the
crosshairs. The position of the prism is then established from the fixed scale
(which is normally graduates in units of nD). Thermosetting is accomplished by
circulation of water through the jackets surrounding the prism.
The refractive index of a substance is ordinarily determined by measuring the

change in direction of colliminated radiation as it passes from one medium to
another.
---------------(1)
Where v1 is the velocity of propagation in the less dense medium M1 and
v2 is the velocity in medium M2; n1andn2are the corresponding refractive
indices and θ1 and θ2 are the angles of incidence and refraction.
When M1 is a vacuum, n1 is unity because v1 becomes equal to c in equation

(1). Thus,
n2=nVAC=c/v2 ---------------(2)
Where nvac is the absolute refractive index of M2. Thus nvaccan be obtained
by measuring the two angles θ1 and θ2 Abbe's refractometer is used to
measure the refractive index of the given organic liquid. Using a
particular monochromatic light source, the apparatus is calibrated with
water as the liquid. Adjust the micrometre screw to focus the boundary
between the bright and dark regions. Adjust the refractometer scale to
place the cross wire of the telescope exactly on the boundary between the
bright and dark regions. Repeat the same process for different organic liquids
after the equipment is calibrated.
PROCEDURE:
1. Clean the surface of prism first with alcohol and then with acetone
using cotton and allow it to dry.
2.Using a dropper put 2-3 drops of given liquid b/w prisms and press
them together
3. Allow the light to fall on mirror.

4. Adjust the mirror to reflect maximum light into the prism box
5.Rotate the prism box by moving lever until the boundary b/w shaded
and bright parts appear in the field of view.
6.If a band of colours appear in the light shade boundary make it sharp
by rotating the compensator.
7. Adjust the lever so that light shade boundary passes exactly through the
centre of cross wire
8. Read the refractive index directly on the scale 9.Take 3 set of readings and
find the average of all the readings.
OBSERVATION:
Room temperature =23 degrees Celsius
Name of the liquid = Kerosene
Specific refraction, R = (n^2- 1)/ (n^2 + 2) × 1/d
Molar refraction, Rm= R ×M (molecular mass of liquid)

RESULT:
Refractive Index Of KEROSENE Oil= 1.44
Bibliography:
http://davjalandhar.com/dbt/chemistry/SOP%20LabManuals/
https://www.wikipedia.org/

Refractive Index of Kerocene Oil

Uploaded by

Copyright:

Available Formats

Refractive Index of Kerocene Oil

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Refractive Index of Kerocene Oil

Uploaded by

Copyright:

Available Formats

What is the aim of the experiment?

What apparatus is used in the experiment and what is each used for?

REFRACTIVE

6, Maris Ave 3rd St,

The refractive index of a substance is ordinarily determined by measuring the

When M1 is a vacuum, n1 is unity because v1 becomes equal to c in equation

3. Allow the light to fall on mirror.

Name of the liquid = Kerosene

Specific refraction, R = (n^2- 1)/ (n^2 + 2) × 1/d

Molar refraction, Rm= R ×M (molecular mass of liquid)

You might also like