Hollywreath PDF
Hollywreath PDF
Hollywreath PDF
Holly Wreath
These pattern details should be used in conjunction with the Stitching Cards General Instructions.
“Out at …” means passing the needle through a hole from the back of the card to the front.
“In at …” means passing the needle through a hole from the front of the card to the back.
Finished design
Stitching Cards Holly wreath pricking pattern
152 mm
6 inches
104 mm
4¼ inches
When you print the pricking pattern please make sure you have the printer page scaling set to “None”.
Failure to do this could cause the page to print at a different size from the one intended.
You will need a suitable pricking mat. This could be foam or felt but should allow easy penetration of
the pricking pin whilst protecting your work surface. Lay your blank card onto the pricking mat with the
right side (outside) of the card facing upwards.
Place the pricking pattern on the card in the required position. Use a fine pricking tool to pierce through
the pattern and the card. If you do not have a purpose made pricking tool then a hat pin or similar can be
used.
Remove the pricking pattern. The pricked holes can be seen on the card.
Turn the card over so the wrong side (inside) is uppermost.. Select a suitable thread such as Kreinik
metallic cord. Use a Number 10 embroidery needle. Use a length of thread that you are comfortable
with. We suggest using about a third of a metre (14 inches). Secure the end of the thread to the card with
adhesive tape. Pass the needle through the start hole from the back to the front of the card.
Follow the instruction diagram. Refer to the finished diagram from time to time to see the complete
stitching required.
When the thread on your needle runs out secure the end of the thread with adhesive tape on the back of
the card and start a new thread.
Continue to follow the instructions a section at a time. Some patterns uses beads. These are held in place
with stitching. You may need to use a beading needle if the bead holes are very fine.
If you are using a double fold card (a card with three panels) then place the completed card on your
work surface with the right side facing downwards. Fold the left-hand panel across to cover and hide the
back of the stitching work. Secure the panel in place with double-sided adhesive tape or card adhesive.
The stitching of your card is now complete. You may choose to add a suitable greeting with stickers,
stamping or handwriting.
Stitching Terminology.
Where the instructions say “Out at” this means passing the needle through a hole from the back of the
card to the front.
Where the instructions say “In at” this means passing the needle through a hole from the front of the
card to the back.
Where the design calls for back stitch this works as follows:
Out at 2 in at 1
Out at 3 in at 2 1 2 3 4
Out at 4 in at 3
Where the design calls for stem stitch this works as follows:
Out at 1 in at 3
Out at 2 in at 4 1 2 3 4 5
Out at 3 in at 5
Value Pack Number 3: Christmas. Value Pack Number 4: Christmas. Value Pack Number 6: Occasions.
Value Pack Number 8: Easter. Value Pack No.12: Christmas Borders Value Pack Number 13: Religious.
The illustrations on this page show some of our Value Packs. Patterns are also available individually. Value Packs
contain six patterns for the price of five separate patterns.
You get pattern sheets with step-by-step instructions for each design.
Please see our web site for pattern prices.
10% of all sales from these patterns will be donated to EveryChild, the international children's charity.
Visit the EveryChild web site at www.everychild.org.uk.