Scribd
Upload
21 views8 pages

Emsamblaje

Emsamblaje

Uploaded by

daniel quispe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
21 views8 pages

Emsamblaje

Emsamblaje

Uploaded by

daniel quispe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 8

Sub-Ensamblajes

BasicBarrier
his subassembly creates a two-sided New Jersey barrier on a roadway surface. this subassembly is
one of a group of Getting Started subassemblies used for simple roadway modeling, and for tutorial
and training purposes.

BasicCurb
This subassembly creates a a simple curb at the edge of roadway. It can be attached to either
outside edge of pavement or to the edge of a median on the inside. This subassembly is one of a
group of Getting Started subassemblies used for simple roadway modeling, and for tutorial and
training purposes.
BasicCurbAndGutter
This subassembly creates a a simple curb and gutter structure at the inside or outside edges of
roadway. This subassembly is one of a group of Getting Started subassemblies used for simple
roadway modeling, and for tutorial and training purposes.
BasicLane
This subassembly creates a simple lane. This subassembly is one of a group of Getting Started
subassemblies used for simple roadway modeling, and for tutorial and training purposes.

BasicShoulder
This subassembly creates a simple paved shoulder with finish grade and subbase. This
subassembly is one of a group of Getting Started subassemblies used for simple roadway modeling,
and for tutorial and training purposes.
BasicSideSlopeCutDitch
This subassembly is used to close from the edge of roadway to a daylight point in both cut and fill
conditions. The cut condition includes an optional ditch. The final daylighting link can be omitted for
cases where the corridor model needs to be left in an incomplete state. For example, this might be
done so that grading surfaces on adjacent properties can tie to the hinge point on the uncompleted
roadway. This subassembly is one of a group of Getting Started subassemblies used for simple
roadway modeling, and for tutorial and training purposes. You can also specify optional lined
materials for daylight and other links (All Links, Daylight Links, Fill Links Only, and None).

Channel
This subassembly creates an open channel with optional lining and backslope links.
MedianDepressedShoulderExt
This subassembly creates a cross-sectional representation of a depressed median with inside
shoulders, using extended termination of shoulder subbase. It supports superelevation pivoting
about the attachment point at the centerline, or about the attachment point elevation at the inside
edges-of-traveled-way. The pavement structure on the paved portions of the shoulder follows the
standards described in "Pavement Structure of Paved Sections" in the AutoCAD Civil 3D Help.
Diseño geométrico de carreteras
Tabla de radio minimo

You might also like