AUDIO, VISUAL & TELEPHONE SYSTEM

K ELECTRICAL

AUDIO, VISUAL & TELEPHONE SYSTEM

SECTION AV B

E
CONTENTS
PRECAUTIONS .......................................................... 2 Removal and Installation of Front Door Speaker ..... 9 F
Precautions for Supplemental Restraint System REMOVAL ............................................................. 9
(SRS) “AIR BAG” and “SEAT BELT PRE-TEN- INSTALLATION ..................................................... 9
SIONER” .................................................................. 2 Removal and Installation of Rear Door Speaker ..... 9 G
AUDIO ......................................................................... 3 REMOVAL ............................................................. 9
System Description .................................................. 3 INSTALLATION ................................................... 10
SPEED DEPENDENT VOLUME SYSTEM ........... 3 Removal and Installation of Tweeter ...................... 10
H
Component parts Location ....................................... 3 REMOVAL ........................................................... 10
Wiring Diagram —AUDIO— ..................................... 4 INSTALLATION ................................................... 10
Terminals and Reference Value for Audio Unit ......... 6 AUDIO ANTENNA .................................................... 11
Symptom Chart ........................................................ 8 Location of Antenna ................................................ 11 I
Steering Switch Resistance Check .......................... 9 Removal and Installation of Roof Antenna ............. 11
Removal and Installation of Audio Unit .................... 9 REMOVAL ........................................................... 11
REMOVAL ............................................................. 9 INSTALLATION ................................................... 11 J
INSTALLATION ..................................................... 9

AV

AV-1
 PRECAUTIONS

PRECAUTIONS PFP:00011

Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER” BKS001AK

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SRS and SB section of
this Service Manual.
WARNING:
● To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
● Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
● Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.

AV-2
 AUDIO

AUDIO PFP:28111
A
System Description BKS001AL

Refer to Owner’s Manual for audio system operating instructions.

SPEED DEPENDENT VOLUME SYSTEM B
Volume level of this system turns up and down automatically in proportion to the vehicle speed. And the con-
trol level can be selected by the customer.
C
Component parts Location BKS001C2

AV

SKIB8381E

AV-3
 AUDIO

Wiring Diagram —AUDIO— BKS001AM

MKWA4265E

AV-4
AUDIO

AV

MKWA4266E

AV-5
 AUDIO

Terminals and Reference Value for Audio Unit BKS001AO

Terminal No.
Signal Condition
(wire color)
Item input/ Voltage
output Ignition
(+) (–) Operation
switch
4 (B) Ground Ground — ON — Approx. 0 V
Press MODE switch Approx. 0 V
Press SEEK UP switch Approx. 1.7 V
10 (L) Ground Remote control A Input ON
Press VOL UP switch Approx. 3.3 V
Except for above Approx. 5 V
Press SEEK DOWN
Approx. 1.7 V
switch
11 (W) Ground Remote control B Input ON Press VOL DOWN
Approx. 3.3 V
switch
Except for above Approx. 5 V
12 (R) — Remote control GND — ON — Approx. 0 V

21 (B) 22 (O) Audio signal rear RH Output ON Receive audio signal

SKIA0177E

23 (W) 24 (R) Audio signal front RH Output ON Receive audio signal

SKIA0177E

25 (V) 26 (P) Audio signal front LH Output ON Receive audio signal

SKIA0177E

27 (G) 28 (GR) Audio signal rear LH Output ON Receive audio signal

SKIA0177E

When vehicle speed is

Vehicle speed signal
31 (R) Ground Input ON approx. 40 km/h (25
(2-pulse)
MPH)

ELF1080D

34 (LG) Ground Battery power supply Input OFF — Battery voltage

AV-6
 AUDIO

Terminal No.
Signal Condition
(wire color) A
Item input/ Voltage
output Ignition
(+) (–) Operation
switch
Lighting switch is ON B
Approx. 12 V
36 (V) Ground Illumination signal Input ON (position 1).
Turn lighting switch OFF. Approx. 0 V
37 (L) Ground ACC power Input ACC — Battery voltage C
38 (B) Ground Ground — ON — Approx. 0 V

AV

AV-7
 AUDIO

Symptom Chart BKS001C3

● The majority of the audio malfunctions are the result of outside causes (bad CD/cassette, electromagnetic
interference, etc.). Check the symptoms below to diagnose the malfunction.
● The vehicle itself can be a source of noise if noise prevention parts or electrical equipment is malfunction-
ing. Check if noise is caused and/or changed by engine speed, ignition switch turned to each position, and
operation of each piece of electrical equipment, and then determine the cause.
NOTE:
● CD-R is not guaranteed to play because they can contain compressed audio (MP3, WMA) or could be
incorrectly mastered by the customer on a computer.
● Check if the CDs carry the Compact Disc Logo. If not, the disc is not mastered to the “red book” Com-
pact Disc Standard and may not play.
Symptom Probable malfunction location
● Audio unit power supply circuit
Audio system does not work properly.
● Audio unit
● Remote control signal circuit between steering switch and combination
switch (spiral cable)
● Remote control signal circuit between combination switch (spiral cable)
Audio steering wheel switch does not operate properly. and audio unit
● Steering wheel audio control switch
● Combination switch (spiral cable)
● Audio unit
No sound can be heard from all speakers. ● Audio unit
● Audio signal circuit between audio unit and speaker
● Speaker
No sound can be heard from one or several speakers.
● Tweeter
● Audio unit
● Antenna feeder
No sound can be heard from radio or noise is caught. ● Roof antenna
● Audio unit
● Vehicle speed signal circuit between combination meter and audio unit
Speed dependent volume system does not function. ● Audio unit
● Combination meter

NOTE:
Noise resulting from variations in field strength, such as fading noise and multi-path noise, or external noise
from trains and other sources, is not a malfunction.
● Fading noise: This noise occurs because of variations in the field strength in a narrow range due to moun-
tains or buildings blocking the signal.
● Multi-path noise: This noise results from a time difference between the broadcast waves directly from the
station arriving at the antenna and the waves reflected by mountains or buildings.

AV-8
 AUDIO

Steering Switch Resistance Check BKS001AP

A
Check continuity between steering switch harness connector terminals 14, 15 and 16.
Resistance value
14 − 16 B
MODE ON :0−1Ω
SEEK UP ON : 164 − 166 Ω
C
VOL UP ON : 646 − 658 Ω
15 − 16
SEEK DOWN ON : 164 − 166 Ω D

VOL DOWN ON : 646 − 658 Ω

SKIB8537E

Removal and Installation of Audio Unit BKS001AU E

REMOVAL
1. Remove cluster lid C. Refer to IP-8, "K. Cluster Lid C" .
2. Remove screws (A) and remove audio unit (1) and bracket. F

SKIB3963J I
INSTALLATION
Install in the reverse order of removal. J
Removal and Installation of Front Door Speaker BKS001AV

REMOVAL
1. Remove front door finisher. Refer to EI-20, "DOOR FINISHER" . AV
2. Remove screws (A) and remove speaker (1).

SKIB3965J

INSTALLATION
Install in the reverse order of removal.
Removal and Installation of Rear Door Speaker BKS001AW

REMOVAL
1. Remove rear side finisher. Refer to EI-20, "DOOR FINISHER" .

AV-9
 AUDIO

2. Remove screws (A) and remove speaker (1).

SKIB3965J

INSTALLATION
Install in the reverse order of removal.
Removal and Installation of Tweeter BKS001AZ

REMOVAL
1. Remove corner cover inner. Refer to GW-96, "DOOR MIRROR" .
2. Remove screws (A) and remove tweeter.

SKIB8634E

INSTALLATION
Install in the reverse order of removal.

AV-10
 AUDIO ANTENNA

AUDIO ANTENNA PFP:28200

A
Location of Antenna BKS001B0

SKIB8382E

Removal and Installation of Roof Antenna BKS001B1

J
REMOVAL
: Vehicle front
AV
1. Remove headliner. Refer to EI-30, "HEADLINER" .
2. Remove roof antenna mounting nut (A) and antenna feeder (1).
Then remove roof antenna.
L

SKIB8635E

INSTALLATION
Install in the reverse order of removal.
Roof Antenna mounting nut
: 4.0 N·m (0.41 kg-m, 35 in-lb)

AV-11
AUDIO ANTENNA

AV-12