0% found this document useful (0 votes)
100 views2 pages

Experiment No.10

A 2x4 decoder was designed using 7404 NOT and 7408 AND gates to convert binary inputs into octal outputs, with two inputs selecting one of four outputs to be either high or low based on the input's octal equivalent number. The schematic was built and output waveforms verified the decoder was functioning properly to decode inputs.

Uploaded by

faadu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
100 views2 pages

Experiment No.10

A 2x4 decoder was designed using 7404 NOT and 7408 AND gates to convert binary inputs into octal outputs, with two inputs selecting one of four outputs to be either high or low based on the input's octal equivalent number. The schematic was built and output waveforms verified the decoder was functioning properly to decode inputs.

Uploaded by

faadu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

EXPERIMENT NO.

10

AIM: To design a 2X4 decoder.

IC USED: 7404(NOT), 7408(AND).


THEORY: A decoder is a device which does the reverse of an encoder, undoing the encoding so
that the original information can be retrieved. The same method used to encode is usually just
reversed in order to decode.
In digital electronics, a decoder can take the form of a multiple-input, multiple-output logic
circuit that converts coded inputs into coded outputs, where the input and output codes are
different.
Decoders have 2 inputs and 4 outputs. The binary input fed at input will be decoded to provide
either logical high or low on one of the 4 outputs, which is termed as octal equivalent for that
binary input. For a binary input 100, which is 4 in octal number system, the output pin called O4
will go either high or low.
SCHEMATIC DIAGRAM:

WAVEFORM:

RESULT:
2X4 decoder is designed and its output is verified.

You might also like