Scribd
Upload
693 views4 pages

Design of Lifting Hook Bar:: 1.0, Hence Safe

This document provides design calculations for a lifting hook bar. It calculates the factored load on each hook as 53.16 kN based on the slab panel dimensions and material properties. It then calculates the tension in the sling as 75.2 kN and shear in each leg of the hook as 53.16 kN. It verifies that the yield strength and tensile strength of the 20mm diameter bar meet the design requirements for shear and tension. It also checks the anchorage length required and provided.

Uploaded by

Anand.5
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
693 views4 pages

Design of Lifting Hook Bar:: 1.0, Hence Safe

This document provides design calculations for a lifting hook bar. It calculates the factored load on each hook as 53.16 kN based on the slab panel dimensions and material properties. It then calculates the tension in the sling as 75.2 kN and shear in each leg of the hook as 53.16 kN. It verifies that the yield strength and tensile strength of the 20mm diameter bar meet the design requirements for shear and tension. It also checks the anchorage length required and provided.

Uploaded by

Anand.5
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 4

DESIGN OF LIFTING HOOK BAR:

45°

Slab Panel Length = 3


Slab Panel Width = 1.4
Thickness of Top Slab Panel = 300
Unit weight of Concrete = 25
Slab Panel Weight = 31.5
Impact Factor considered = 2.5
Dead Load Factor as per BS EN 1990 = 1.35
Factored load = 106.3
Minimum Number of hooks for lifting = 2
Vertical Tension on each hook = 53.16
It has been conservatively assumed that only one leg of the hook shall participate in taking the load
Hence vertical tension on each leg = 53.16

Angle of sling with horizontal = 45


Tension in sling = 75.2
Shear in the leg = 53.16

Yield strength of the bar = 500


Tensile strength of the bar = 540
Dia of bar = 20
Area of bar = 314.1593
Design shear strength as per BS EN 1993-1-8:2005 = 81.43
Design tension strength as per BS EN 1993-1-8:2005 = 122.15
Combined shear and tension ratio BS EN 1993-1-8:2005 = 0.964
< 1.0, Hence Safe
Calculation of Anchorage Length as per BS EN 1992-1-1
fctk0.05 = 2.5
αct = 1
γc = 1.5
fctd = 1.666667
η1 = 1
η2 = 1
fbd = 3.75
σsd = 500
lb,rqd = 666.7
Provided anchorage length = 750
Hence Safe
m
m
mm
kN/m3
kN

kN
articipate in taking the load
kN

°
kN
kN

N/mm2
N/mm2
mm
mm2
kN
kN
N/mm2

N/mm2
N/mm2
mm
mm

You might also like