NE555

Description
These devices are monolithic timing circuits capable of producing accurate time delays or oscillation.
Inthe time delay mode of operation, the timed interval is controll ed by a single external resistor and capacit
or netw ork. In the astable mode of operation, the frequency and duty cy cle may be independently
controlled wi th two external resistors and a si ngle external capacitor.

Features

• Timing from Microseconds to Hours

• Astable or Monostable Operation
• Adjustable Duty Cycle
• TTL - Compatible Output Can Sink or Source Up to 200 mA
• DIP-8 SOP-8
Temperature Stability of 0.005% per o C
• Direct Replacement for Signetics NE555 Timer
P ack age
Applications Pin Configuration
• Precision timing
• Pulse generation TOP VIEW
• Sequential timing
• Time delay generation
• Pulse w idth modulation
• Pulse position modulation
• Missing pulse detector

Internal Block Digram

RESET can override TRIGGER, which can override THRESHOLD

BEIJING ESTEK ELECTRONICS CO.,LTD

1
 NE555
Absolute Maximum Ratings
(TA=25°C, unless otherwise specified)
Parameter Min Max Units
Supply Voltage, VCC 4.5 16 V
Input Voltage (control, reset, threshold and trigger) VCC
Output Current, I0 ±200 mA
Operating Free-Air Temperature, TA 70 °C
Storage Temperature Range, TSTG -65 +150

Electrical characteristics
(TA=25°C, VCC=+5V to +15V, unless otherwise specified)
Parameter Test conditions (Note 2) Min Typ Max Units
Operating Supply Voltage Range 4.5 16 V
Threshold Voltage Level VCC=15V 8.8 10 11.2 V
VCC=5V 2.4 3.3 4.2
Threshold Current (Note 1) (see Note 1) 30 250 nA
Trigger Voltage Level VCC=15V 4.5 5 5.6 V
VCC=5V 1.1 1.67 2.2
Trigger Current Trigger at 0V 0.5 2 µA
Reset Voltage Level 0.3 0.7 1 V
Reset Current Reset at VCC 0.1 0.4 mA
Reset at 0V -0.4 -1.5
Discharge Leakage Current 20 100 nA
Control Voltage Level VCC=15V 9 10 11 V
VCC=5V 2.6 3.3 4
Low-level Output Voltage VCC=15V IOL=10mA 0.1 0.25
IOL=50mA 0.4 0.75
IOL=100mA 2 2.5
IOL=200mA 2.5
VCC=5V IOL=5mA 0.25 0.35
IOL=8mA 0.3 0.4
High-level Output Voltage VCC=15V IOL=-100mA 12.75 13.3
IOL=-200mA 12.5
VCC=5V IOL=-100mA 2.75 3.3
Supply Current Output Low, VCC=15V 10 15 mA
No Load VCC=5V 3 6
Output High, VCC=15V 9 13
No Load VCC=5V 2 5
Initial Error of monostable TA=25°C 1 3 %
Timing Interval (Note 3) (Note 4)
astable 5 13
(Note 5)
Temperature Coefficient monostable TA=MIN to MAX 50 150 ppm /°C
of Timing Interval astable 150 500
Supply Voltage Sensitivity of monostable TA=25°C 0.1 0.5 %/V
Timing Interval astable 0.3 1
Output Pulse Rise Time CL=15pF, TA=25°C 100 300 ns
Output Pulse Fall Time 100 300
Note 1: This parameter influences the maximum value of the timing resistors RA and RB in the circuit on Fig 1. For example, when
VCC=5V, the maximum value is R=R A+RB=3.4 MΩ, and VCC=15V, the maximum value is 10 MΩ.
Note 2: For conditions shown as MIN or MAX, use the appropriate value specified under recommended operating conditions.
Note 3: Timing interval error is defined as the difference between the measured value and the average value of a random sample from
each process run.
Note 4: Values specified are for a device in a monostable circuit similar to Fig. 2, with component values as follow: RA=2KΩ to 100 KΩ,
C=0.1µF.
Note 5: Values specified are for a device in an astable circuit similar to Fig. 1, with component values as follow: RA, RB=1KΩ to 100 KΩ,
C=0.1µF.

BEIJING ESTEK ELECTRONICS CO.,LTD

2
 NE555
Function Table
Reset Trigger Voltage * Threshold Voltage * Output Discharge Switch
Low Irrelevant Irrelevant Low On
High < 1/3 VCC High High Off
High > 1/3 VCC > 2/3 VCC Low On
High > 1/3 VCC < 2/3 VCC As previously established
* Voltage levels shown are nominal

Typical Applications Circuit

Figure 1 Circuit for astable operation Figure 2. Circuit for monostable operation

NOTE A: Bypassing the control voltage input to ground with a capacitor may improve operation. This should be evaluated for individual
applications.

Ordering Information

O RDERING NUM BER P ACK AG E M ARKIN G

NE555 DIP - 8 / SOP - 8 NE555

Address : 6A06--6A07
Rm 6A07,Changyin Office Building ,No.88,Yong Ding Road,Hai Dian District ,Beijing
Postalcode:100039
Tel: 86-010-58895780 / 81 / 82 / 83 / 84 Fax : 010-58895793
Http://www.estek.com.cn
Email:[email protected]

REV No:01-060823

BEIJING ESTEK ELECTRONICS CO.,LTD

3