Scribd
Upload
125 views1 page

Mastercam Topics

This document outlines a syllabus for learning Mastercam. It introduces CNC machines and basic CAM concepts before covering how to use Mastercam to create 2D drawings and toolpaths, and 3D models and toolpaths. Specific topics covered include techniques for lines, arcs, shapes and transformations in 2D drawings, and pocketing, contouring, drilling and more complex toolpaths in 2D and 3D environments.

Uploaded by

saravanan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
125 views1 page

Mastercam Topics

This document outlines a syllabus for learning Mastercam. It introduces CNC machines and basic CAM concepts before covering how to use Mastercam to create 2D drawings and toolpaths, and 3D models and toolpaths. Specific topics covered include techniques for lines, arcs, shapes and transformations in 2D drawings, and pocketing, contouring, drilling and more complex toolpaths in 2D and 3D environments.

Uploaded by

saravanan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

 

MASTER CAM SYLLABUS

Introduction to CNC Machines


Introduction to MASTERCAM
Product Introduction
Basic concepts of CAM (cutters, machines job setup, etc)

MASTER CAM

 Creating 2D drawings
 Creating 2D tool paths
 Creating 3D models(Solid & Surface)
 Creating 3D tool paths

Creating 2D Drawings

 Line,Arc,Rectangle,Fillet,Chamfer
 Point,Polygon,Rectangle shapes
 XForm, Trim, Break
 Drafting ,Analyzing

Creating 2D Tool paths

 Pocket, Contour,Facing,Drilling
 Transforming 2D tool paths(Translate,Rotate,Mirror)
 Hole milling, slot milling and helical milling tool paths
 Back plot, Verification, post processing

Creating 3D Models

 Extrude,Revolve,Fillet,Chamfer
 Sweep, Thicken, Ruled
 Boolean operations(Add,Subtract,Common)
 Converting Solid to Surface , Surface to Solid
 Surface modeling tools ( Ruled, Extrude,net,fence,trim,split, removing boundary, fill
holes, flat boundary)

Creating 3D Tool paths

 boundary box, Orientation, Analyzing


 Pocket,Contour,Shallow,Parallel,Rest milling,Corner finishing tool paths
 Back plot, Verification, Gouge checking, Post – processing, Editing of programs

You might also like