Scribd
Upload
51 views6 pages

DIY Smart Dustbin With Arduino

This document describes how to make a smart dustbin using an Arduino, ultrasonic sensor, and servo motor. The dustbin opening is modified to accommodate the ultrasonic sensor. The sensor and Arduino are placed inside and programmed to detect when the dustbin is full. When full is detected, the attached servo motor will open the dustbin lid. Instructions include cutting plastic, placing components, wiring, and programming.

Uploaded by

amitkbharti6784
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
51 views6 pages

DIY Smart Dustbin With Arduino

This document describes how to make a smart dustbin using an Arduino, ultrasonic sensor, and servo motor. The dustbin opening is modified to accommodate the ultrasonic sensor. The sensor and Arduino are placed inside and programmed to detect when the dustbin is full. When full is detected, the attached servo motor will open the dustbin lid. Instructions include cutting plastic, placing components, wiring, and programming.

Uploaded by

amitkbharti6784
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

instructables

DIY Smart Dustbin With Arduino

by AhsanQureshi

Here we will make a Smart Dustbin by using arduino and ultrasonic sensor.
I hope you guys enjoy learning this project.

Supplies:
Arduino Uno
Ultrasonic Sensor
Servo Motor
Dustbin

Step 1: Preparing the Opening

Take a plastic sheet and cut fraw a circle with the help of dustbin and but it off from plastic sheet and then cut the
circle in half and join them again with the help of scotch tape or plastic tape.

DIY Smart Dustbin With Arduino: Page 1


Step 2: Place the Ultra Sonic Sensor

Place the ultra sonic sensor in the dustbin as shown in the picture and move on to the next step.

DIY Smart Dustbin With Arduino: Page 2


Step 3: Programming

Connect the arduino and upload the given program on your arduino uno and place the arduino in the dustbin with
the help of double tape and move on to the next step.

Download
https://www.instructables.com/ORIG/F2Y/4YM4/JXAO7CI4/F2Y4YM4JXAO7CI4.txt
…

DIY Smart Dustbin With Arduino: Page 3


Step 4: Wiring

Now Place the 9 Volt Battery and Wire the circuit as shown in the picture above and then move on to the next
step.

Step 5: Place the Plastic Circle

Now Place the Plastic circle that we had cut in the second step and and glue the half circle on the dustbin and take
the servo motor and place it on the circle with fix it with the help of some glue as shown in the pictures.

Take a string and a metal Washer and tie a not with the string as shown in the picture and make an hole and pass
it through the plastic circle and again tie a not with servo motor.

DIY Smart Dustbin With Arduino: Page 4


Step 6: Wiring the Servo Motor Final Task

Now Wire the Servo Motor according to the given Diagram and you have complete the project.

Hope you enjoy making it have some difficulties watch the video here : https://userstube.com/music/video/251/diy-
make-a-smart-dustbin-at-home

DIY Smart Dustbin With Arduino: Page 5


DIY Smart Dustbin With Arduino: Page 6

You might also like