Scribd
Upload
23 views2 pages

Experiment 7: Theory

The document describes an experiment on Quadrature Phase Shift Keying (QPSK) modulation and demodulation. QPSK modulation encodes digital data into phases of a carrier wave, transmitting two bits per change in phase. It uses a modulator that splits even and odd bits, multiplies them with a carrier that is in or out of phase by 90 degrees, and sums the signals. The QPSK demodulator uses two detectors to simultaneously recover the two BPSK signals and convert them back to the original digital data bits. The experiment aims to demonstrate QPSK modulation and demodulation using specific equipment.

Uploaded by

pankaj singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
23 views2 pages

Experiment 7: Theory

The document describes an experiment on Quadrature Phase Shift Keying (QPSK) modulation and demodulation. QPSK modulation encodes digital data into phases of a carrier wave, transmitting two bits per change in phase. It uses a modulator that splits even and odd bits, multiplies them with a carrier that is in or out of phase by 90 degrees, and sums the signals. The QPSK demodulator uses two detectors to simultaneously recover the two BPSK signals and convert them back to the original digital data bits. The experiment aims to demonstrate QPSK modulation and demodulation using specific equipment.

Uploaded by

pankaj singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Experiment 7

Aim: Quadrature Phase Shift Keying Modulation and Demodulation.

Equipments : Experiment Kit ADCL-02, 03, Power Supply, 20MHz Dual Trace Oscilloscope, Connecting Chords.

Theory:
The Quadrature Phase Shift Keying
(QPSK) is a variation of BPSK, and it is also
a
Double Side Band Suppressed Carrier
(DSBSC) modulation scheme, which sends
two bits of digital information at a time,
called as bigits. Instead of the conversion
of digital bits into a series of digital stream,
it converts them into bit pairs. This
decreases the data bit rate to half, which
allows space for the other users.
The QPSK Modulator uses a bit-splitter,
two multipliers with local oscillator, a 2-bit
serial to parallel converter, and a summer
circuit. Following is the block diagram for
the same.
At the modulator’s input, the message
signal’s even bits (i.e., 2nd bit, 4th bit, 6th bit, etc.) and odd bits (i.e., 1st bit, 3rd bit, 5th bit, etc.) are separated by the bits splitter
and are multiplied with the same carrier to generate odd BPSK (called as PSKI) and even BPSK (called as PSKQ). The PSKQ
signal is anyhow phase shifted by 90° before being modulated.
The QPSK waveform for two-bits input is as follows, which shows the modulated result for different instances of binary
inputs.

QPSK Demodulator
The QPSK Demodulator uses two product
demodulator circuits with local oscillator,
two band pass filters, two integrator
circuits, and a 2-bit parallel to serial
converter. Following is the diagram for the
same.
The two product detectors at the input
of demodulator simultaneously
demodulate the two BPSK signals. The
pair of bits are recovered here from the
original data. These signals after
processing, are passed to the parallel
to serial converter.

BlockDiagram:

Observations:

You might also like