Sun PU Gard

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

SUNANDA

SPECIALITY COATINGS PVT.LTD


AN ISO 9001:2000 COMPANY

Sunpugard
Two Component Polyurethane Coating

DESCRIPTION DIRECTION FOR USE


SUNPUGARD is a two component aliphatic  Surface to be coated should be free
polyurethane based coating for exterior as from dust, oil, grease etc.
well as interior applications. It has excellent  Stir well the contents of Part A.
chemical and abrasion resistance. Its good  Mix 4 volumes of Part A with 1
adhesion to concrete and variety of other volume of Part B, Stir well.
surfaces makes it an ideal choice for  Apply by spray or brush (If required
coatings. use thinner SUN PU- 108, upto 2%
can be added.)
APPLICATIONS  Allow to cure for 2 hours before
1. Concrete (cured for atleast 28 days) recoating.
surfaces.  After second coat allow to cure for
2. As a topcoat for epoxy flooring. 24 hrs.
 Clean all the appliances immediately
PHYSICAL AND CHEMICAL PROPERTIES after use with SUN CL-9.
Sp. Gr. @ R T : 1.08 + 3%
Volume solids : 40 + 3% STORAGE AND HANDLING
Pot Life : 3 to 4 hours. 1. It contains inflammable solvents. Store in
Drying Characteristics : a cool ventilated area away from naked
Surface dry - 15 – 30 min. flame, heat, sparks and children.
Tack free dry - 60 - 90 min 2. Take necessary precautions like wearing
Hard Dry - 24 hrs. mask, gloves, goggles etc. when
handling the product.
MIXING RATIO
Mix 4 volumes of part A with 1 volume of Part PACKING
B. 20 ltrs. In HDPE / MS containers.

THEORETICAL COVERAGE CAPACITY STORAGE AND SHELF LIFE


DFT 100 microns - 4 sq.m. per litre It has a shelf life of 3 months when stored in
original packing in a cool, dry place.

www.sunandaglobal.com
SUNANDA
SPECIALITY COATINGS PVT.LTD
AN ISO 9001:2000 COMPANY

HAZARDS IDENTIFICATION ACCIDENTAL RELEASE MEASURES


Health hazards: No particular hazard known. Environment Care: Clean small spillages
If the product spills on to the skin and dries immediately with water. Contain large
up, some irritation may occur. spillages with suitable absorbent materials.
Dispose the waste water/absorbent material
FIRST AID MEASURES in accordance with local regulations.
Skin contact: Immediately wash thoroughly
with soap and water. QUALITY ASSURANCE
Inhalation: Remove to open air. Seek All products are manufactured under a
medical attention. Quality Management System for Design,
Contact with eyes: Immediately wash under Manufacturing and Selling of Construction
running water with eyelids open for at least Chemicals as per the standards of ISO 9001:
15 minutes. Seek medical attention. 2000.
Ingestion: Rinse mouth thoroughly and drink
plenty of water. Seek medical attention.

DISCLAIMER
This information is accurate and reliable to the best of the knowledge. It is meant as a guideline only. Sunanda Speciality Coatings Pvt. Ltd. (SSCPL) cannot give any guarantees under any
circumstances for the results, or assume any obligation or liability in connection with the use of this information. It is recommended that the product be tested to determine its suitability for specific
applications. Since, SSCPL has no control over how others may use its products; it is recommended that the Specifier, Architect, Engineer, Contractor and Owner assume all the responsibilities in
connection therewith.

www.sunandaglobal.com

You might also like